deveopmen
Clock Generating Circuit
Preliminary Specifications REV.D
Specifications in this manual are tentative and subject to change.
Mitsubishi microcomputers
M16C/80 (100-pin version) group
SINGLE-CHIP 16-BIT CMOS MICROCOMPUTER
40
Figure 1.8.2. Examples of sub clock
Table 1.8.1. Main clock and sub clock generating circuits
Clock Generating Circuit
The clock generating circuit contains two oscillator circuits that supply the operating clock sources to the
CPU and internal peripheral units.
Example of oscillator circuit
Figure 1.8.1 shows some examples of the main clock circuit, one using an oscillator connected to the
circuit, and the other one using an externally derived clock for input. Figure 1.8.2 shows some examples
of sub clock circuits, one using an oscillator connected to the circuit, and the other one using an externally
derived clock for input. Circuit constants in Figures 1.8.1 and 1.8.2 vary with each oscillator used. Use
the values recommended by the manufacturer of your oscillator.
Figure 1.8.1. Examples of main clock
Main clock generating circuit
CPU’s operating clock source
Internal peripheral units’
operating clock source
Ceramic or crystal oscillator
X
IN
, X
OUT
Available
Oscillating
Externally derived clock can be input
Sub clock generating circuit
CPU’s operating clock source
Timer A/B’s count clock
source
Crystal oscillator
X
C
IN
, X
COUT
Available
Stopped
Use of clock
Usable oscillator
Pins to connect oscillator
Oscillation stop/restart function
Oscillator status immediately after reset
Other
Microcomputer
(Built-in feedback resistance)
X
IN
X
OUT
Open
Externally derived clock
Vcc
Vss
Microcomputer
(Built-in feedback resistance)
X
IN
X
OUT
R
d
C
IN
C
OUT
(Note)
Note: Insert a damping resistance if required. The resistance will vary depending on the oscillator and the oscillation
drive capacity setting. Use the value recommended by the maker of the oscillator.
When the oscillation drive capacity is set to low, check that oscillation is stable.
Insert a feedback resistance between X
IN
and X
OUT
when an oscillation manufacture required.
Microcomputer
(Built-in feedback resistance)
X
CIN
X
COUT
Open
Externally derived clock
Vcc
Vss
Note: Insert a damping resistance if required. The resistance will vary depending on the oscillator and the oscillation
drive capacity setting. Use the value recommended by the maker of the oscillator.
When the oscillation drive capacity is set to low, check that oscillation is stable.
Insert a feedback resistance between X
CIN
and X
COUT
when an oscillation manufacture required.
Microcomputer
(Built-in feedback resistance)
X
CIN
X
COUT
(Note)
R
Cd
C
CIN
C
COUT