- 您現在的位置：買賣IC網 > PDF目錄377765 > LTC1873EG (LINEAR TECHNOLOGY CORP) Quadruple 2-Input Positive-AND Gate 14-TSSOP -40 to 85 PDF資料下載
參數資料
| 型號： | LTC1873EG |
| 廠商： | LINEAR TECHNOLOGY CORP |
| 元件分類： | 穩壓器 |
| 英文描述： | Quadruple 2-Input Positive-AND Gate 14-TSSOP -40 to 85 |
| 中文描述： | 5 A SWITCHING CONTROLLER, 750 kHz SWITCHING FREQ-MAX, PDSO28 |
| 封裝： | 0.209 INCH, PLASTIC, SSOP-28 |
| 文件頁數： | 10/32頁 |
| 文件大?。?/td> | 308K |
| 代理商： | LTC1873EG |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁當前第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁第30頁第31頁第32頁
10
LTC1873
Switching Architecture
Each half of the LTC1873 is designed to operate as a
synchronous buck converter (Figure 1). Each channel
includes two high power MOSFET gate drivers to control
external N-channel MOSFETs QT and QB. These drivers
have 0.5
output impedances and can carry well over an
amp of continuous current with peak currents up to 5A to
slew large MOSFET gates quickly. The external MOSFETs
are connected with the drain of QT attached to the input
supply and the source of QT at the switching node SW. QB
is the synchronous rectifier with its drain at SW and its
source at PGND. SW is connected to one end of the
inductor, with the other end connected to V
OUT
. The output
capacitor is connected from V
OUT
to PGND.
When a switching cycle begins, QB is turned off and QT is
turned on. SW rises almost immediately to V
IN
and the
inductor current begins to increase. When the PWM pulse
finishes, QT turns off and one nonoverlap interval later, QB
turns on. Now SW drops to PGND and the inductor current
decreases. The cycle repeats with the next tick of the
master clock. The percentage of time spent in each mode
is controlled by the duty cycle of the PWM signal, which in
turn is controlled by the feedback amplifier. The master
clock runs at a 550kHz rate and turns QT once every 1.8
μ
s.
In a typical application with a 5V input and a 1.5V output,
the duty cycle will be set at 1.5/5
×
100% or 30% by the
feedback loop. This will give roughly a 540ns on-time for
QT and a 1.26
μ
s on-time for QB.
This constant frequency operation brings with it a couple
of benefits. Inductor and capacitor values can be chosen
with a precise operating frequency in mind and the feed-
back loop components can be similarly tightly specified.
Noise generated by the circuit will always be in a known
frequency band with the 550kHz frequency designed to
leave the 455kHz IF band free of interference. Subharmonic
oscillation and slope compensation, common headaches
with constant frequency current mode switchers, are
absent in voltage mode designs like the LTC1873.
During the time that QT is on, its source (the SW pin) is at
V
IN
. V
IN
is also the power supply for the LTC1873. How-
ever, QT requires V
IN
+ V
GS(ON)
at its gate to achieve
minimum R
ON
. This presents a problem for the LTC1873—
it needs to generate a gate drive signal at TG higher than
its highest supply voltage. To accomplish this, the TG
driver runs from floating supplies, with its negative supply
attached to SW and its power supply at BOOST. This
allows
it to slew up and down with the source of QT. In combination
with a simple external charge pump (Figure 2),
this allows
the LTC1873 to completely enhance the gate of QT without
requiring an additional, higher supply voltage.
The two channels of the LTC1873 run from a common
clock, with the phasing chosen to be 180
°
from side 1 to
side 2. This has the effect of doubling the frequency of the
switching pulses seen by the input bypass capacitor,
significantly lowering the RMS current seen by the capaci-
tor and reducing the value required (see the 2-Phase
section).
Feedback Amplifier
Each side of the LTC1873 senses the output voltage at
V
OUT
with an internal feedback op amp (see Block Dia-
gram). This is a real op amp with a low impedance output,
85dB open-loop gain and 25MHz gain-bandwidth product.
The positive input is connected internally to an 800mV
reference, while the negative input is connected to the FB
Figure 1. Synchronous Buck Architecture
+
TG
1/2
LTC1873
BG
SW
PGND
C
OUT
1873 F01
+
C
IN
QT
QB
V
OUT
V
IN
L
EXT
Figure 2. Floating TG Driver Supply
+
TG
BOOST
SW
BG
PGND
PV
CC
D
CP
C
IN
+
C
OUT
1873 F02
V
OUT
L
EXT
V
IN
QT
QB
C
CP
1
μ
F
LTC1873
APPLICATIOU
W
U
U
相關PDF資料 |
PDF描述 |
|---|---|
| LTC1873 | Dual 550kHz Synchronous 2-Phase Switching Regulator Controller with 5-Bit VID(550kHz,雙 路,同步2相開關穩壓器(帶5位VID)) |
| LTC1874 | Dual Constant Frequency Current Mode Step-Down DC/DC Controller(雙路(3.3V,1.8V輸出）恒定頻率，電流模式，步降DC/DC控制器) |
| LTC1874EGN | Quadruple 2-Input Positive-AND Gate 14-VQFN -40 to 85 |
| LTC1875 | 15mA Quiescent Current 1.5A Monolithic Synchronous Step-Down Regulator |
| LTC1875EGN | 15mA Quiescent Current 1.5A Monolithic Synchronous Step-Down Regulator |
相關代理商/技術參數 |
參數描述 |
|---|---|
| LTC1873EG#PBF | 功能描述:IC REG CTRLR BUCK PWM VM 28-SSOP RoHS:是 類別:集成電路 (IC) >> PMIC - 穩壓器 - DC DC 切換控制器 系列:- 標準包裝:4,500 系列:PowerWise® PWM 型:控制器 輸出數:1 頻率 - 最大:1MHz 占空比:95% 電源電壓:2.8 V ~ 5.5 V 降壓:是 升壓:無 回掃:無 反相:無 倍增器:無 除法器:無 Cuk:無 隔離:無 工作溫度:-40°C ~ 125°C 封裝/外殼:6-WDFN 裸露焊盤 包裝:帶卷 (TR) 配用:LM1771EVAL-ND - BOARD EVALUATION LM1771 其它名稱:LM1771SSDX |
| LTC1873EG#TR | 功能描述:IC REG CTRLR BUCK PWM VM 28-SSOP RoHS:否 類別:集成電路 (IC) >> PMIC - 穩壓器 - DC DC 切換控制器 系列:- 標準包裝:4,500 系列:PowerWise® PWM 型:控制器 輸出數:1 頻率 - 最大:1MHz 占空比:95% 電源電壓:2.8 V ~ 5.5 V 降壓:是 升壓:無 回掃:無 反相:無 倍增器:無 除法器:無 Cuk:無 隔離:無 工作溫度:-40°C ~ 125°C 封裝/外殼:6-WDFN 裸露焊盤 包裝:帶卷 (TR) 配用:LM1771EVAL-ND - BOARD EVALUATION LM1771 其它名稱:LM1771SSDX |
| LTC1873EG#TRPBF | 功能描述:IC REG CTRLR BUCK PWM VM 28-SSOP RoHS:是 類別:集成電路 (IC) >> PMIC - 穩壓器 - DC DC 切換控制器 系列:- 標準包裝:4,500 系列:PowerWise® PWM 型:控制器 輸出數:1 頻率 - 最大:1MHz 占空比:95% 電源電壓:2.8 V ~ 5.5 V 降壓:是 升壓:無 回掃:無 反相:無 倍增器:無 除法器:無 Cuk:無 隔離:無 工作溫度:-40°C ~ 125°C 封裝/外殼:6-WDFN 裸露焊盤 包裝:帶卷 (TR) 配用:LM1771EVAL-ND - BOARD EVALUATION LM1771 其它名稱:LM1771SSDX |
| LTC1874EGN | 功能描述:IC REG CTRLR BUCK PWM CM 16-SSOP RoHS:否 類別:集成電路 (IC) >> PMIC - 穩壓器 - DC DC 切換控制器 系列:- 標準包裝:2,500 系列:- PWM 型:電流模式 輸出數:1 頻率 - 最大:500kHz 占空比:96% 電源電壓:4 V ~ 36 V 降壓:無 升壓:是 回掃:無 反相:無 倍增器:無 除法器:無 Cuk:無 隔離:無 工作溫度:-40°C ~ 125°C 封裝/外殼:24-WQFN 裸露焊盤 包裝:帶卷 (TR) |
| LTC1874EGN#PBF | 功能描述:IC REG CTRLR BUCK PWM CM 16-SSOP RoHS:是 類別:集成電路 (IC) >> PMIC - 穩壓器 - DC DC 切換控制器 系列:- 標準包裝:2,500 系列:- PWM 型:電流模式 輸出數:1 頻率 - 最大:500kHz 占空比:96% 電源電壓:4 V ~ 36 V 降壓:無 升壓:是 回掃:無 反相:無 倍增器:無 除法器:無 Cuk:無 隔離:無 工作溫度:-40°C ~ 125°C 封裝/外殼:24-WQFN 裸露焊盤 包裝:帶卷 (TR) |
發布緊急采購，3分鐘左右您將得到回復。