參數資料
型號: L6470PD
廠商: STMICROELECTRONICS
元件分類: 運動控制電子
英文描述: STEPPER MOTOR CONTROLLER, 7 A, PDSO36
封裝: ROHS COMPLIANT, SSOP-36
文件頁數: 11/61頁
文件大?。?/td> 703K
代理商: L6470PD
L6470
Functional description
Doc ID 16737 Rev 1
19/61
6
Functional description
6.1
Device power-up
At power-up end, the device state is the following:
Registers are set to default,
Internal logic is driven by internal oscillator and a 2MHz clock is provided by OSCOUT
pin,
Bridges are disabled (High Z),
UVLO bit in STATUS register is forced low (fail condition),
FLAG output is forced low
During power-up the device is under reset (all logic IO disabled and power bridges in high
impedance state) until the following conditions are satisfied:
VS is greater than VSthOn,
VREG is greater than VREGth,
Internal oscillator is operative.
Any motion command makes the device exiting from High Z state (HardStop and SoftStop
included).
6.2
Logic I/O
Pins CS, CK, SDI, STCK, SW and STBY are TTL/CMOS 3.3V-5V compatible logic inputs.
Pin SDO is a TTL/CMOS compatible logic output. VDD pin voltage sets the logic output pins
voltage range.
A 10F capacitor should be connected to VDD pin in order to obtain a correct operation.
Pins FLAG and BUSY are open drain outputs.
6.3
Charge pump
To ensure the correct driving of the high side integrated mosfets a voltage higher than the
motor power supply voltage needs to be applied to the VBOOT pin. The high side gate
driver supply voltage Vboot is obtained through an oscillator and a few external components
realizing a charge pump (see Figure 4).
相關PDF資料
PDF描述
L6566BTR 0.8 A POWER FACTOR CONTROLLER, 900 kHz SWITCHING FREQ-MAX, PDSO16
L6706 SWITCHING REGULATOR, QCC40
L6717 DUAL SWITCHING CONTROLLER, 575 kHz SWITCHING FREQ-MAX, QCC48
L6728HTR SWITCHING CONTROLLER, 330 kHz SWITCHING FREQ-MAX, PDSO10
L6728H SWITCHING CONTROLLER, 330 kHz SWITCHING FREQ-MAX, PDSO10
相關代理商/技術參數
參數描述
L6470PDTR 功能描述:馬達/運動/點火控制器和驅動器 dSPIN 7.0A 8 - 45 V DMOS Motor Driver RoHS:否 制造商:STMicroelectronics 產品:Stepper Motor Controllers / Drivers 類型:2 Phase Stepper Motor Driver 工作電源電壓:8 V to 45 V 電源電流:0.5 mA 工作溫度:- 25 C to + 125 C 安裝風格:SMD/SMT 封裝 / 箱體:HTSSOP-28 封裝:Tube
L64710GC-30 制造商:未知廠家 制造商全稱:未知廠家 功能描述:Encoder/Decoder
L64710GC-40 制造商:未知廠家 制造商全稱:未知廠家 功能描述:Encoder/Decoder
L64710GM-25 制造商:未知廠家 制造商全稱:未知廠家 功能描述:Encoder/Decoder
L64710GM-30 制造商:未知廠家 制造商全稱:未知廠家 功能描述:Encoder/Decoder