參數資料
型號： DS3148
廠商： Maxim Integrated Products
文件頁數： 62/89頁
文件大?。?/td> 0K
描述： IC 8CH DS3/3 FRAMER 349-BGA
產品培訓模塊： Lead (SnPb) Finish for COTS
Obsolescence Mitigation Program
標準包裝： 1
控制器類型： DS3/E3 調幀器
接口： LIU
電源電壓： 3.135 V ~ 3.465 V
電流 - 電源： 640mA
工作溫度： -40°C ~ 85°C
安裝類型： 表面貼裝
封裝/外殼： 349-BGA 裸露焊盤
供應商設備封裝： 349-HCBGA（27x27）
包裝： 托盤
DS3146/DS3146/DS31412 6-/8-/12-Channel DS3/E3 Framers
65 of 89
Register Name:
FSRL
Register Description:
FEAC Status Register Latched
Register Address:
62h
Bit #
7
6
5
4
3
2
1
0
Name
N/A
RFFOL
RFFNL
RFIL
RFCDL
TFIL
Default
—
Note: See Figure 7-8 for details on the interrupt logic for the status bits in the BSRL register.
Bit 0: Transmit FEAC Idle Latched (TFIL). This latched status bit is set to 1 when the TFI status bit in the FSR
register goes high. TFIL is cleared when the host processor writes a 1 to it and is not set again until TFI goes high
again. When TFIL is set, it can cause a hardware interrupt to occur if the TFIIE bit in the FSRIE register and the
FEACIE bit in the MSRIE register are both set. The interrupt is cleared when this bit is cleared or one or both of the
interrupt-enable bits are cleared. This bit can be used to determine when the FEAC codeword transmission has
finished, and thus a new codeword can be transmitted.
Bit 1: Receive FEAC Codeword Detected Latched (RFCDL). This latched status bit is set to 1 when the RFCD
status bit in the FSR register goes high. RFCDL is cleared when the host processor writes a one to it and is not set
again until RFCD goes high again. When RFCDL is set, it can cause a hardware interrupt to occur if the RFCDIE
bit in the FSRIE register and the FEACIE bit in the MSRIE register are both set. The interrupt is cleared when this
bit is cleared or one or both of the interrupt-enable bits are cleared.
Bit 2: Receive FEAC Idle Latched (RFIL). This latched status bit is set to 1 when the RFI status bit in the FSR
register goes high. RFIL is cleared when the host processor writes a 1 to it and is not set again until RFI goes high
again. When RFIL is set, it can cause a hardware interrupt to occur if the RFIIE bit in the FSRIE register and the
FEACIE bit in the MSRIE register are both set. The interrupt is cleared when this bit is cleared or one or both of the
interrupt-enable bits are cleared. This bit can be used to determine when the FEAC receiver has stopped receiving
codewords, which can mark the end of an alarm situation.
Bit 3: Receive FEAC FIFO Not-Empty Latched (RFFNL). This latched status bit is set to 1 when the RFFE bit in
the FSR register goes low. RFFNL is cleared when the host processor writes a 1 to it and is not set again until the
RFFE bit goes low again. When RFFNL is set, it can cause a hardware interrupt to occur if the RFFNIE bit in the
FSRIE register and the FEACIE bit in the MSRIE register are both set. The interrupt is cleared when this bit is
cleared or one or both of the interrupt-enable bits are cleared. This bit can be used to determine when to read
FEAC codeword(s) from the FIFO.
Bit 4: Receive FEAC FIFO Overflow Latched (RFFOL). This latched status bit is set to 1 when the receive FEAC
controller has attempted to write to an already full receive FEAC FIFO and the current incoming FEAC codeword is
lost. RFFOL is cleared when the host processor writes a 1 to it and is not set again until another FIFO overflow
occurs (i.e., the receive FEAC FIFO has been read and then fills beyond capacity). When RFFOL is set, it can
cause a hardware interrupt to occur if the RFFOIE bit in the FSRIE register and the FEACIE bit in the MSRIE
register are both set. The interrupt is cleared when this bit is cleared or one or both of the interrupt-enable bits are
cleared.
相關PDF資料
PDF描述
DS21FT42 IC FRAMER T1 4X3 12CH 300-BGA
V375C24M75BL3 CONVERTER MOD DC/DC 24V 75W
V375C24M75BL2 CONVERTER MOD DC/DC 24V 75W
DS21FF42N+ IC FRAMER T1 4X4 16CH 300-BGA
DS21FT42N IC FRAMER T1 4X3 12CH IND 300BGA
相關代理商/技術參數
參數描述
DS3148N 功能描述:網絡控制器與處理器 IC 8 Port DS3/E3 Framer RoHS:否 制造商:Micrel 產品:Controller Area Network (CAN) 收發器數量: 數據速率: 電源電流（最大值）:595 mA 最大工作溫度:+ 85 C 安裝風格:SMD/SMT 封裝 / 箱體:PBGA-400 封裝:Tray
DS315 制造商:Hubbell Wiring Device-Kellems 功能描述:SWITCH, DECO SER, 3W, 15A 120/277V, BR
DS3150 制造商:MAXIM 制造商全稱:Maxim Integrated Products 功能描述:3.3V, DS3/E3/STS-1 Line Interface Unit
DS3150DK 功能描述:網絡開發工具 DS3150 Dev Kit RoHS:否 制造商:Rabbit Semiconductor 產品:Development Kits 類型:Ethernet to Wi-Fi Bridges 工具用于評估:RCM6600W 數據速率:20 Mbps, 40 Mbps 接口類型:802.11 b/g, Ethernet 工作電源電壓:3.3 V
DS3150G 功能描述:IC LIU T3/E3/STS-1 49-BGA RoHS:否 類別:集成電路 (IC) >> 接口 - 驅動器，接收器，收發器 系列:- 產品培訓模塊:Lead (SnPb) Finish for COTS Obsolescence Mitigation Program 標準包裝:25 系列:- 類型:收發器 驅動器/接收器數:2/2 規程:RS232 電源電壓:4.5 V ~ 5.5 V 安裝類型:通孔 封裝/外殼:16-DIP（0.300"，7.62mm） 供應商設備封裝:16-PDIP 包裝:管件
發布緊急采購，3分鐘左右您將得到回復。

采購需求

(若只采購一條型號，填寫一行即可)

發布成功！您可以繼續發布采購。也可以進入我的后臺，查看報價

發布成功！您可以繼續發布采購。也可以進入我的后臺，查看報價

*型號 *數量 廠商 批號 封裝
添加更多采購

我的聯系方式

*
*
*