- 您現在的位置：買賣IC網 > PDF目錄379183 > DS28E04S-100 4096-Bit Addressable 1-Wire EEPROM with PIO PDF資料下載
參數資料
| 型號： | DS28E04S-100 |
| 元件分類： | DRAM |
| 英文描述： | 4096-Bit Addressable 1-Wire EEPROM with PIO |
| 中文描述： | 4096位尋址1 - Wire EEPROM，帶有先鋒 |
| 文件頁數： | 30/36頁 |
| 文件大小： | 347K |
| 代理商： | DS28E04S-100 |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁當前第30頁第31頁第32頁第33頁第34頁第35頁第36頁
DS28E04-100: 4096-Bit 1-Wire Addressable EEPROM with PIO
30 of 36
Figure 17. Noise Suppression Scheme
V
PUP
V
TH
V
HY
0V
t
REH
t
GL
t
REH
t
GL
Case A
Case C
Case B
CRC GENERATION
With the DS28E04-100 there are two different types of CRCs. One CRC is an 8-bit type and is stored in the most
significant byte of the 64-bit ROM. The bus master can compute a CRC value from the first 56 bits of the ROM and,
if none of the address inputs is connected to GND, compare it to the value stored within the DS28E04-100 to
determine whether the ROM data has been received error-free. If any of the address pins are connected to GND,
the bus master can calculate the CRC based on an all 1s external address field to determine whether the non-
external address ROM data has been received error-free. The equivalent polynomial function of this CRC is X
+ X
5
+ X
+ 1. This 8-bit CRC is received in the true (noninverted) form. It is computed at the factory and hardcoded into
the ROM.
The other CRC is a 16-bit type, generated according to the standardized CRC16-polynomial function x
16
+ x
15
+ x
2
+ 1. This CRC is used for fast verification of a data transfer when writing to or reading from the scratchpad or when
reading from the PIOs. In contrast to the 8-bit CRC, the 16-bit CRC is always communicated in the inverted form. A
CRC generator inside the DS28E04-100 chip (Figure 18) calculates a new 16-bit CRC, as shown in the command
flow chart (Figure 9). The bus master compares the CRC value read from the device to the one it calculates from
the data, and decides whether to continue with an operation or to reread the portion of the data with the CRC error.
With the Write Scratchpad command, the CRC is generated by first clearing the CRC generator and then shifting in
the command code, the target addresses TA1 and TA2, and all the data bytes as they were sent by the bus
master. The DS28E04-100 transmits this CRC only if E4:E0 = 11111b, i.e., the end of the scratchpad is hit.
With the Read Scratchpad command, the CRC is generated by first clearing the CRC generator and then shifting in
the Command code, the target addresses TA1 and TA2, the E/S byte, and the scratchpad data as they were sent
by the DS28E04-100. The DS28E04-100 transmits this CRC only if the reading continues through the end of the
data written in the previous write scratchpad sequence. Example: if one writes a single byte to the scratchpad and
then reads the scratchpad, one will receive a CRC of the command, TA1, TA2, and the data byte.
With the initial pass through the PIO Access Read command flow, the CRC is generated by first clearing the CRC
generator and then shifting in the command code followed by 32 bytes of PIO pin data. Subsequent passes
through the command flow generate a 16-bit CRC that is the result of clearing the CRC generator and then shifting
in 32 bytes read from the PIO pins. For more information on generating CRC values, refer to
Application Note 27
.
相關PDF資料 |
PDF描述 |
|---|---|
| DS3151 | Single/Dual/Triple/Quad DS3/E3/STS-1 LIUs |
| DS3151N | Single/Dual/Triple/Quad DS3/E3/STS-1 LIUs |
| DS3152 | Single/Dual/Triple/Quad DS3/E3/STS-1 LIUs |
| DS3152N | Single/Dual/Triple/Quad DS3/E3/STS-1 LIUs |
| DS3153 | Single/Dual/Triple/Quad DS3/E3/STS-1 LIUs |
相關代理商/技術參數 |
參數描述 |
|---|---|
| DS28E04S-100/T | 功能描述:電可擦除可編程只讀存儲器 RoHS:否 制造商:Atmel 存儲容量:2 Kbit 組織:256 B x 8 數據保留:100 yr 最大時鐘頻率:1000 KHz 最大工作電流:6 uA 工作電源電壓:1.7 V to 5.5 V 最大工作溫度:+ 85 C 安裝風格:SMD/SMT 封裝 / 箱體:SOIC-8 |
| DS28E04S-100+ | 功能描述:電可擦除可編程只讀存儲器 4096-Bit Addressable 1-Wire 電可擦除可編程只讀存儲器 w/PIO RoHS:否 制造商:Atmel 存儲容量:2 Kbit 組織:256 B x 8 數據保留:100 yr 最大時鐘頻率:1000 KHz 最大工作電流:6 uA 工作電源電壓:1.7 V to 5.5 V 最大工作溫度:+ 85 C 安裝風格:SMD/SMT 封裝 / 箱體:SOIC-8 |
| DS28E04S-100+T | 功能描述:電可擦除可編程只讀存儲器 4096-Bit Addressable 1-Wire 電可擦除可編程只讀存儲器 w/PIO RoHS:否 制造商:Atmel 存儲容量:2 Kbit 組織:256 B x 8 數據保留:100 yr 最大時鐘頻率:1000 KHz 最大工作電流:6 uA 工作電源電壓:1.7 V to 5.5 V 最大工作溫度:+ 85 C 安裝風格:SMD/SMT 封裝 / 箱體:SOIC-8 |
| DS28E04S-224-BB+T | 制造商:Maxim Integrated Products 功能描述:- Tape and Reel |
| DS28E05P+ | 功能描述:電可擦除可編程只讀存儲器 1W 1KB FTP MEMORY TSOC RoHS:否 制造商:Atmel 存儲容量:2 Kbit 組織:256 B x 8 數據保留:100 yr 最大時鐘頻率:1000 KHz 最大工作電流:6 uA 工作電源電壓:1.7 V to 5.5 V 最大工作溫度:+ 85 C 安裝風格:SMD/SMT 封裝 / 箱體:SOIC-8 |
發布緊急采購，3分鐘左右您將得到回復。