- 您現在的位置：買賣IC網 > PDF目錄379183 > DS28E04S-100 4096-Bit Addressable 1-Wire EEPROM with PIO PDF資料下載
參數資料
| 型號： | DS28E04S-100 |
| 元件分類： | DRAM |
| 英文描述： | 4096-Bit Addressable 1-Wire EEPROM with PIO |
| 中文描述： | 4096位尋址1 - Wire EEPROM，帶有先鋒 |
| 文件頁數： | 22/36頁 |
| 文件大?。?/td> | 347K |
| 代理商： | DS28E04S-100 |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁當前第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁第30頁第31頁第32頁第33頁第34頁第35頁第36頁
DS28E04-100: 4096-Bit 1-Wire Addressable EEPROM with PIO
22 of 36
Figure 12. PIO Access Pulse Timing Diagram
t
PULSE
IO
PIO
MS 2 bits of inverted
Selection Mask
LS 2 bits of confir-
mation byte (AAh)
V
TH
t
REH
+x
POL=1
POL=0
RESET ACTIVITY LATCHES [C3h]
Each PIO channel includes an activity latch that is set whenever there is a state transition at a PIO pin of duration
greater than t
PWMIN
. This change can be caused by an external event/signal or by writing to the PIO or by
generating a pulse. Depending on the application there may be a need to reset the activity latch after having
captured and serviced an external event. Since there is only read access to the PIO Activity Latch State Register,
the DS28E04-100 supports a special command to reset these latches. After having received the command code,
the device resets all activity latches simultaneously. There are two ways for the master to verify the execution of
the Reset Activity Latches command. One way is to start reading from the 1-Wire line right after the command code
is transmitted. In this case, the master reads AAh bytes until it sends a 1-Wire reset. The other way is reading
register address 0222h.
1-Wire BUS SYSTEM
The 1-Wire bus is a system that has a single bus master and one or more slaves. In all instances the DS28E04-
100 is a slave device. The bus master is typically a microcontroller. The discussion of this bus system is broken
down into three topics: hardware configuration, transaction sequence, and 1-Wire signaling (signal types and
timing). The 1-Wire protocol defines bus transactions in terms of the bus state during specific time slots, which are
initiated on the falling edge of sync pulses from the bus master.
HARDWARE CONFIGURATION
The 1-Wire bus has only a single line by definition; it is important that each device on the bus be able to drive it at
the appropriate time. To facilitate this, each device attached to the 1-Wire bus must have open-drain or tri-state
outputs. The 1-Wire port of the DS28E04-100 is open drain with an internal circuit equivalent to that shown in
Figure 13.
A multidrop bus consists of a 1-Wire bus with multiple slaves attached. The DS28E04-100 supports both a
standard and Overdrive communication speed of 15.4kbps (max) and 111kbps (max), respectively. Note that
legacy 1-Wire products support a standard communication speed of 16.3kbps and Overdrive of 142kbps. The
slightly reduced rates for the DS28E04-100 are a result of additional recovery times, which in turn were driven by a
1-Wire physical interface enhancement to improve noise immunity. The value of the pullup resistor primarily
depends on the network size and load conditions. The DS28E04-100 requires a pullup resistor of 2.2k (max) at
any speed.
The idle state for the 1-Wire bus is high. If, for any reason, a transaction needs to be suspended, the bus MUST be
left in the idle state if the transaction is to resume. If this does not occur and the bus is left low for more than 16μs
(Overdrive speed) or more than 120μs (standard speed), one or more devices on the bus can be reset.
相關PDF資料 |
PDF描述 |
|---|---|
| DS3151 | Single/Dual/Triple/Quad DS3/E3/STS-1 LIUs |
| DS3151N | Single/Dual/Triple/Quad DS3/E3/STS-1 LIUs |
| DS3152 | Single/Dual/Triple/Quad DS3/E3/STS-1 LIUs |
| DS3152N | Single/Dual/Triple/Quad DS3/E3/STS-1 LIUs |
| DS3153 | Single/Dual/Triple/Quad DS3/E3/STS-1 LIUs |
相關代理商/技術參數 |
參數描述 |
|---|---|
| DS28E04S-100/T | 功能描述:電可擦除可編程只讀存儲器 RoHS:否 制造商:Atmel 存儲容量:2 Kbit 組織:256 B x 8 數據保留:100 yr 最大時鐘頻率:1000 KHz 最大工作電流:6 uA 工作電源電壓:1.7 V to 5.5 V 最大工作溫度:+ 85 C 安裝風格:SMD/SMT 封裝 / 箱體:SOIC-8 |
| DS28E04S-100+ | 功能描述:電可擦除可編程只讀存儲器 4096-Bit Addressable 1-Wire 電可擦除可編程只讀存儲器 w/PIO RoHS:否 制造商:Atmel 存儲容量:2 Kbit 組織:256 B x 8 數據保留:100 yr 最大時鐘頻率:1000 KHz 最大工作電流:6 uA 工作電源電壓:1.7 V to 5.5 V 最大工作溫度:+ 85 C 安裝風格:SMD/SMT 封裝 / 箱體:SOIC-8 |
| DS28E04S-100+T | 功能描述:電可擦除可編程只讀存儲器 4096-Bit Addressable 1-Wire 電可擦除可編程只讀存儲器 w/PIO RoHS:否 制造商:Atmel 存儲容量:2 Kbit 組織:256 B x 8 數據保留:100 yr 最大時鐘頻率:1000 KHz 最大工作電流:6 uA 工作電源電壓:1.7 V to 5.5 V 最大工作溫度:+ 85 C 安裝風格:SMD/SMT 封裝 / 箱體:SOIC-8 |
| DS28E04S-224-BB+T | 制造商:Maxim Integrated Products 功能描述:- Tape and Reel |
| DS28E05P+ | 功能描述:電可擦除可編程只讀存儲器 1W 1KB FTP MEMORY TSOC RoHS:否 制造商:Atmel 存儲容量:2 Kbit 組織:256 B x 8 數據保留:100 yr 最大時鐘頻率:1000 KHz 最大工作電流:6 uA 工作電源電壓:1.7 V to 5.5 V 最大工作溫度:+ 85 C 安裝風格:SMD/SMT 封裝 / 箱體:SOIC-8 |
發布緊急采購，3分鐘左右您將得到回復。