- 您現在的位置：買賣IC網 > PDF目錄2067 > DS2450S+T&R (Maxim Integrated Products)IC CONVERTER A/D QUAD 1-W 8-SOIC PDF資料下載
參數資料
| 型號： | DS2450S+T&R |
| 廠商： | Maxim Integrated Products |
| 文件頁數： | 3/25頁 |
| 文件大?。?/td> | 0K |
| 描述： | IC CONVERTER A/D QUAD 1-W 8-SOIC |
| 產品培訓模塊： | Lead (SnPb) Finish for COTS Obsolescence Mitigation Program |
| 產品變化通告： | Product Discontinuation 27/Jul/12 |
| 標準包裝： | 2,000 |
| 位數： | 16 |
| 采樣率（每秒）： | 1k |
| 數據接口： | 串行 |
| 轉換器數目： | 1 |
| 功率耗散（最大）： | 2.5mW |
| 電壓電源： | 單電源 |
| 工作溫度： | -40°C ~ 85°C |
| 安裝類型： | 表面貼裝 |
| 封裝/外殼： | 8-SOIC（0.209"，5.30mm 寬） |
| 供應商設備封裝： | 8-SOIC |
| 包裝： | 帶卷 (TR) |
| 輸入數目和類型： | 4 個單端，單極 |
DS2450
11 of 24
With VCC power supply the bus master may either send a reset pulse to exit the Convert command or
continuously generate read data time slots. As long as the DS2450 is busy with conversions the bus
master will read 0’s. After the conversion is completed the bus master will receive 1’s instead. Since in a
open-drain environment a single 0 overwrites multiple 1’s the bus master can monitor multiple devices
converting simultaneously and immediately knows when the last one is ready. As in the parasitically
powered scenario the bus master finally has to exit the Convert command by issuing a rest pulse.
1-WIRE BUS SYSTEM
The 1-Wire bus is a system which has a single bus master and one or more slaves. In all instances the
DS2450 is a slave device. The discussion of this bus system is broken down into three topics: hardware
configuration, transaction sequence, and 1-Wire signaling (signal types and timing). A 1-Wire protocol
defines bus transactions in terms of the bus state during specific time slots that are initiated on the falling
edge of sync pulses from the bus master. For a more detailed protocol description, refer to Chapter 4 of
the Book of DS19xx iButton Standards.
HARDWARE CONFIGURATION
The 1-Wire bus has only a single line by definition; it is important that each device on the bus be able to
drive it at the appropriate time. To facilitate this, each device attached to the 1-Wire bus must have open
drain or 3-state outputs. The 1-Wire port of the DS2450 is open drain with an internal circuit equivalent
to that shown in Figure 8. A multidrop bus consists of a 1-Wire bus with multiple slaves attached. At
regular speed the 1-Wire bus has a maximum data rate of 16.3k bits per second. The speed can be
boosted to 142k bits per second by activating the Overdrive Mode. The 1-Wire bus requires a pullup
resistor of approximately 5kΩ at regular speed or maximum 2.2kΩ at Overdrive speed for
communication. During A/D conversions the bus master must provide a strong pullup to 5V to supply
sufficient energy if the DS2450 is powered entirely from the 1-Wire bus.
The idle state for the 1-Wire bus is high. If for any reason a transaction needs to be suspended, the bus
MUST be left in the idle state if the transaction is to resume. If this does not occur and the bus is left low
for more than 16 μs (Overdrive Speed) or more than 120 μs (regular speed), one or more devices on the
bus may be reset.
HARDWARE CONFIGURATION
Figure 8
SEE TEXT
相關PDF資料 |
PDF描述 |
|---|---|
| DS3508E+ | IC GAMMA BUFFER 8CH 20-TSSOP |
| DS3510T+ | IC I2C GAMMA/VCOM BUFF 48-TQFN |
| DS3514T+T&R | IC I2C GAMMA/VCOM BUFF 48-TQFN |
| EL1881CS-T13 | IC VIDEO SYNC SEPARATOR 8-SOIC |
| EL1883IS-T13 | IC VID SYNC SEPARATOR HORZ 8SOIC |
相關代理商/技術參數 |
參數描述 |
|---|---|
| DS245CEDX | 制造商:CUTLER HAMMER/EATON 功能描述: 制造商:Eaton Corporation 功能描述: 制造商:Eaton Corporation 功能描述:RWD |
| DS246 | 制造商:未知廠家 制造商全稱:未知廠家 功能描述:Analog IC |
| DS2460 | 制造商:DALLAS 制造商全稱:Dallas Semiconductor 功能描述:SHA-1 Coprocessor with EEPROM |
| DS2460+ | 制造商:Maxim Integrated Products 功能描述: |
| DS2460S | 制造商:DALLAS 制造商全稱:Dallas Semiconductor 功能描述:SHA-1 Coprocessor with EEPROM |
發(fā)布緊急采購，3分鐘左右您將得到回復。