參數資料
型號: CP2201EK
廠商: Silicon Laboratories Inc
文件頁數: 67/108頁
文件大?。?/td> 0K
描述: KIT EVAL FOR CP2201 ETH CTRLR
標準包裝: 1
主要目的: 接口,以太網傳感器
嵌入式: 是,MCU,8 位
已用 IC / 零件: CP2200,CP2201
主要屬性: 溫度和光傳感器
次要屬性: 圖形用戶界面
已供物品: 板,電源,線纜,CD
產品目錄頁面: 627 (CN2011-ZH PDF)
相關產品: 336-1313-ND - IC ETH CTRLR SNGL-CHIP 28QFN
336-1312-ND - IC ETH CTRLR SNGL-CHIP 48TQFP
其它名稱: 336-1316
CP2200/1
Rev. 1.0
61
Register 34. RXCN: Receive Interface Control
Register 35. RXSTA: Receive Interface Status
Bits 7–4: UNUSED. Read = 0000b, Write = don’t care.
Bit 3:
RXINH: Receive Inhibit
Setting this bit to ‘1’ temporarily inhibits new packet reception. If a packet is currently being
received, reception will continue until the packet is received. Once set, this bit must be cleared to ‘0’
by software to resume packet reception.
Bit 2:
RXCLRV: Valid Bit Clear
Writing a ‘1’ to this bit clears the valid bit of the current packet, freeing up the buffer for new packets.
This action should only be started after all bytes of the current packet have been read (CPEND = 1).
If the packet is not completely read, RXSKIP should be used to discard the remaining bytes.
Bit 1:
RXSKIP: Skip Current Packet
Writing a ‘1’ to this bit updates discards the current packet by clearing its valid bit and advances the
AutoRead buffer pointer to the beginning of the next packet.
Bit 0:
RXCLEAR: Receive Buffer Clear
Writing a ‘1’ to this bit discards all packets in the receive buffer and resets all buffer pointers and
valid bits to zero. Note: Any packets currently in the buffer will remain in memory, however, all infor-
mation such as the starting address and length of each packet will be lost. Any new packets that
arrive will overwrite the existing data.
R/W
W
Reset Value
RXINH
RXCLRV
RXSKIP RXCLEAR 00000000
Bit7
Bit6
Bit5
Bit4
Bit3
Bit2
Bit1
Bit0
Address:
0x11
Bits 7–2: UNUSED. Read = 000000b, Write = don’t care.
Bit 1:
CPEND: Current Packet End Reached
This bit is automatically cleared by hardware when the valid bit for the current packet is cleared (see
RXCLRV description) or the current packet is discarded (see RXSKIP description).
0: The last byte of the current packet has not been read using the AutoRead interface.
1: The last byte of the current packet has been read using the AutoRead interface.
Bit 0:
RXBUSY: Receiving Packet
0: Receive interface is idle.
1: Receive interface is currently receiving a packet.
R/WR/WR/WR/WR/WR/W
R
Reset Value
CPEND
RXBUSY 00000000
Bit7
Bit6
Bit5
Bit4
Bit3
Bit2
Bit1
Bit0
Address:
0x12
相關PDF資料
PDF描述
PM1210-820J-RC INDUCTOR 82UH 5% 1210 SMD
H3WWH-6036G IDC CABLE - HPL60H/AE60G/HPL60H
UPS2C471MRD CAP ALUM 470UF 160V 20% RADIAL
A3CKB-4006M IDC CABLE - AKC40B/AE40M/APK40B
MODEMDK KIT DEV EMBEDDED MODEM
相關代理商/技術參數
參數描述
CP2201-GM 功能描述:以太網 IC Ethernet Controller RoHS:否 制造商:Micrel 產品:Ethernet Switches 收發器數量:2 數據速率:10 Mb/s, 100 Mb/s 電源電壓-最大:1.25 V, 3.45 V 電源電壓-最小:1.15 V, 3.15 V 最大工作溫度:+ 85 C 封裝 / 箱體:QFN-64 封裝:Tray
CP2201-GMR 功能描述:以太網 IC Ethernet Controller RoHS:否 制造商:Micrel 產品:Ethernet Switches 收發器數量:2 數據速率:10 Mb/s, 100 Mb/s 電源電壓-最大:1.25 V, 3.45 V 電源電壓-最小:1.15 V, 3.15 V 最大工作溫度:+ 85 C 封裝 / 箱體:QFN-64 封裝:Tray
CP-220-K 制造商:PREMO 制造商全稱:PREMO CORPORATION S.L 功能描述:Coils and Chokes for general use
CP221 制造商:CENTRAL 制造商全稱:Central Semiconductor Corp 功能描述:Small Signal Transistor
CP-221 1 1/2"BL 100' 功能描述:HEATSHRNK CP221 1-1/2" X 100'BLK 制造商:3m 系列:CP-221 零件狀態:過期 類型:套管,彈性 收縮率:2 至 1 長度:100'(30.48m) 內徑(出廠):1.500"(38.1mm) 內徑 - 恢復后:0.752"(19.1mm) 恢復后的壁厚:0.040"(1.02mm) 材料:聚烯烴(PO) 特性:自熄滅 顏色:黑 工作溫度:-55°C ~ 135°C 收縮溫度:121°C 標準包裝:1