參數資料
型號： CDB4382A
廠商： Cirrus Logic, Inc.
英文描述： 114 dB, 192 kHz 8-channel D/A Converter
中文描述： 114分貝192千赫8通道D / A轉換
文件頁數： 25/47頁
文件大?。?/td> 685K
代理商： CDB4382A
DS618PP1
25
CS4382A
3.8
Direct Stream Digital (DSD) Mode
In stand-alone mode, DSD operation is selected by holding DSD_EN(LRCK) high and applying the DSD
data and clocks to the appropriate pins. The M[2:0] pins set the expected DSD rate and MCLK ratio.
In control-port mode the FM bits set the device into DSD mode (DSD_EN pin is not required to be held high).
The DIF register then controls the expected DSD rate and MCLK ratio.
During DSD operation, the PCM related pins should either be tied low or remain active with clocks (except
LRCK in Stand-alone mode). When the DSD related pins are not being used they should either be tied static
low, or remain active with clocks (except M3 in Stand-alone mode).
3.9
Grounding and Power Supply Arrangements
As with any high resolution converter, the CS4382A requires careful attention to power supply and ground-
ing arrangements if its potential performance is to be realized. The Typical Connection Diagram shows the
recommended power arrangements, with VA, VD, VLC, and VLS connected to clean supplies. If the ground
planes are split between digital ground and analog ground, the GND pins of the CS4382A should be con-
nected to the analog ground plane.
All signals, especially clocks, should be kept away from the FILT+ and VQ pins in order to avoid unwanted
coupling into the DAC.
3.9.1
Capacitor Placement
Decoupling capacitors should be placed as close to the DAC as possible, with the low value ceramic ca-
pacitor being the closest. To further minimize impedance, these capacitors should be located on the same
layer as the DAC. If desired, all supply pins with similar voltage ratings may be connected to the same sup-
ply, but a decoupling capacitor should still be placed on each supply pin.
Notes:
All decoupling capacitors should be referenced to analog ground.
The CDB4382A evaluation board demonstrates the optimum layout and power supply arrangements.
3.10
Analog Output and Filtering
The application note “Design Notes for a 2-Pole Filter with Differential Input” discusses the second-order
Butterworth filter and differential to single-ended converter which was implemented on the CS4382A eval-
uation board, CDB4382A, as seen in Figure 16. The CS4382A does not include phase or amplitude com-
pensation for an external filter. Therefore, the DAC system phase and amplitude response will be dependent
on the external analog circuitry. The off-chip filter has been designed to attenuate the typical full-scale out-
put level to below 2 Vrms.
Figure 15 shows how the full-scale differential analog output level specification is derived.
相關PDF資料
PDF描述
CDB4382 114 dB, 192 kHz 8-Channel D/A Converter
CDB4383 RES 1K-OHM 1% 0.10W 50PPM MET-FILM AXIAL BULK MIL-R-10509
CDB4384 103 dB, 192 kHz 8-Channel D/A Converter
CDB4385 114 dB, 192kHz 8-CHANNEL D/A CONVERTER
CDB4390 RESISTOR-1K, 1/10W, 1% MFILM, RN55C
相關代理商/技術參數
參數描述
CDB4383 制造商:CIRRUS 制造商全稱:Cirrus Logic 功能描述:114 dB, 192 kHz 8-Channel D/A Converter
CDB4384 功能描述:音頻 IC 開發工具 Eval Bd 8-Ch DAC w/DSD RoHS:否 制造商:Texas Instruments 產品:Evaluation Kits 類型:Audio Amplifiers 工具用于評估:TAS5614L 工作電源電壓:12 V to 38 V
CDB4385 功能描述:音頻 IC 開發工具 Eval Bd 8-Ch DAC w/DSD RoHS:否 制造商:Texas Instruments 產品:Evaluation Kits 類型:Audio Amplifiers 工具用于評估:TAS5614L 工作電源電壓:12 V to 38 V
CDB4390 制造商:CIRRUS 制造商全稱:Cirrus Logic 功能描述:24-Bit, Stereo D/A Converter for Digital Audio
CDB4391 制造商:CIRRUS 制造商全稱:Cirrus Logic 功能描述:24-Bit, 192 kHz Stereo DAC with Volume Control
發布緊急采購，3分鐘左右您將得到回復。

采購需求

(若只采購一條型號，填寫一行即可)

發布成功！您可以繼續發布采購。也可以進入我的后臺，查看報價

發布成功！您可以繼續發布采購。也可以進入我的后臺，查看報價

*型號 *數量 廠商 批號 封裝
添加更多采購

我的聯系方式

*
*
*