- 您現在的位置：買賣IC網 > PDF目錄373785 > ZL50022 (Zarlink Semiconductor Inc.) Enhanced 4 K Digital Switch with Stratum 4E DPLL PDF資料下載
參數資料
| 型號： | ZL50022 |
| 廠商： | Zarlink Semiconductor Inc. |
| 英文描述： | Enhanced 4 K Digital Switch with Stratum 4E DPLL |
| 中文描述： | 增強為4 K數字交換與地層4E條數字鎖相環 |
| 文件頁數： | 45/121頁 |
| 文件大小： | 939K |
| 代理商： | ZL50022 |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁第30頁第31頁第32頁第33頁第34頁第35頁第36頁第37頁第38頁第39頁第40頁第41頁第42頁第43頁第44頁當前第45頁第46頁第47頁第48頁第49頁第50頁第51頁第52頁第53頁第54頁第55頁第56頁第57頁第58頁第59頁第60頁第61頁第62頁第63頁第64頁第65頁第66頁第67頁第68頁第69頁第70頁第71頁第72頁第73頁第74頁第75頁第76頁第77頁第78頁第79頁第80頁第81頁第82頁第83頁第84頁第85頁第86頁第87頁第88頁第89頁第90頁第91頁第92頁第93頁第94頁第95頁第96頁第97頁第98頁第99頁第100頁第101頁第102頁第103頁第104頁第105頁第106頁第107頁第108頁第109頁第110頁第111頁第112頁第113頁第114頁第115頁第116頁第117頁第118頁第119頁第120頁第121頁
ZL50022
Data Sheet
45
Zarlink Semiconductor Inc.
(LDTR) should be programmed with respect to the maximum expected jitter frequency and amplitude on the
selected input references.
The lock status can be monitored through the Reference Change Status Register (RCSR). See Table 37 on
page 70 for the bit description of the Reference Change Status Register (RCSR).
15.2 Maximum Time Interval Error (MTIE)
Several standards require that the output clock of the DPLL may not move in phase more than a certain amount. In
order to meet those standards, a special circuit maintains the phase of the DPLL output clock during reference and
mode rearrangements. The total output phase change or Maximum Timing Interval Error (MTIE) during
rearrangements is less than 31 ns per rearrangement, exceeding Stratum 4E requirements. After a large number of
reference switches, the accumulated phase error can become significant, so it is recommended to use MTIE reset
in such situations, to realign outputs to the nearest edge of the selected reference. The MTIE reset can be
programmed by setting MTR (bit 7) in the Reference Change Control Register (RCCR), as described in Table 36 on
page 69.
15.3 Phase Alignment Speed (Phase Slope)
Besides total phase change, standards also require a certain rate of the phase change of the output clock. The
phase alignment speed is programmable by the user through a value in the Slew Rate Limit Register (SRLR) as
described in Table 35 on page 68. Stratum 4E requires that the phase alignment speed not exceed 81 ns per
1.326 ms (61ppm). The width of the register and the limiter circuitry provide a maximum phase change alignment
speed of 186 ppm. The phase alignment speed default value is 56 ppm.
15.4 Reference Monitoring
The quality of the four input reference clocks is continuously monitored by the reference monitors. There are
separate reference monitor circuits for the four DPLL references. References are checked for short phase (single
period) deviations as well as for frequency (multi-period) deviations with hysteresis.
The Reference Status Register (RSR) reports the status of the reference monitors. The register bits are described
in Table 41 on page 74. The Reference Mask Register (RMR) allows users to ignore the monitoring features of the
reference monitors. See Table 42 on page 75 for details.
15.5 Single Period Reference Monitoring
Values for short phase deviations (upper and lower limit) are programmable through registers. The unit of the binary
values of these numbers is 100 MHz clock period (10 ns). Single period deviation limits are more relaxed than multi
period limits, and are used for early detection of the reference loss, or huge phase jumps.
The values for the upper and lower limits are shown in the following table:
Reference
Frequency
8 kHz
1.544 MHz
2.048 MHz
4.096 MHz
8.192 MHz
16.384 MHz
19.44 MHz
Comment
10UIp-p
0.3UIp-p
0.2UIp-p
0.2UIp-p
0.2UIp-p
0.2UIp-p
0.2UIp-p
Table 11 - Values for Single Period Limits
相關PDF資料 |
PDF描述 |
|---|---|
| ZL50022GAC | Enhanced 4 K Digital Switch with Stratum 4E DPLL |
| ZL50022QCC | Enhanced 4 K Digital Switch with Stratum 4E DPLL |
| ZL50023 | Enhanced 4 K Digital Switch |
| ZL50023GAC | Enhanced 4 K Digital Switch |
| ZL50023QCC | Enhanced 4 K Digital Switch |
相關代理商/技術參數 |
參數描述 |
|---|---|
| ZL50022_06 | 制造商:ZARLINK 制造商全稱:Zarlink Semiconductor Inc 功能描述:Enhanced 4 K Digital Switch with Stratum 4E DPLL |
| ZL50022GAC | 制造商:Microsemi Corporation 功能描述:4K WITH RATE CONVERSION AND S4 - Trays 制造商:MICROSEMI CONSUMER MEDICAL PRODUCT GROUP 功能描述:IC TDM SWITCH 4K-CH ENH 256PBGA 制造商:Microsemi Corporation 功能描述:IC TDM SWITCH 4K-CH ENH 256PBGA |
| ZL50022GAG2 | 制造商:Microsemi Corporation 功能描述:SWIT FABRIC 4K X 4K 1.8V/3.3V 256BGA - Trays 制造商:MICROSEMI CONSUMER MEDICAL PRODUCT GROUP 功能描述:IC TDM SWITCH 4K-CH ENH 256PBGA 制造商:Microsemi Corporation 功能描述:IC TDM SWITCH 4K-CH ENH 256PBGA |
| ZL50022QCC | 制造商:Microsemi Corporation 功能描述: 制造商:Microsemi Corporation 功能描述:4K WITH RATE CONVERSION AND S4E DPLL - Trays |
| ZL50022QCG1 | 制造商:Microsemi Corporation 功能描述:PB FREE 4K +RATE CONVERSION & 256L LQFP - Trays 制造商:MICROSEMI CONSUMER MEDICAL PRODUCT GROUP 功能描述:IC TDM SWITCH 4K-CH ENH 256LQFP 制造商:Microsemi Corporation 功能描述:IC TDM SWITCH 4K-CH ENH 256LQFP |
發布緊急采購，3分鐘左右您將得到回復。