參數資料
型號: ZL50022
廠商: Zarlink Semiconductor Inc.
英文描述: Enhanced 4 K Digital Switch with Stratum 4E DPLL
中文描述: 增強為4 K數字交換與地層4E條數字鎖相環
文件頁數: 43/121頁
文件大小: 939K
代理商: ZL50022
ZL50022
Data Sheet
43
Zarlink Semiconductor Inc.
With a preferred reference, if more than two references are required, or the two references are not in consecutive
order, or the roles of the two references need to be interchanged, then external software is required to manually
control the reference switching of the DPLL (by monitoring the reference failure status and reprogramming the
device accordingly).
12.1.4 Freerun Mode
In freerun mode, the DPLL generates a fixed output frequency based on the crystal oscillator frequency. To meet
Stratum 4E, the accuracy of the circuitry for the freerunning output clock must be
±
32 ppm or better.
12.1.5 DPLL Internal Reset Mode
DPLL_IRM (bit 0) in the DPLL Control Register (DPLLCR) enables the internal reset mode. In the internal reset
mode, the DPLL module is disabled to save power. The circuit will be reset continuously and no output clocks will
be generated. When the internal DPLL module is in the internal reset mode, all registers remain accessible. Note
that applying the DPLL reset does not reset the DPLL registers: they preserve the values that they had prior to
entering reset.
13.0 DPLL Frequency Behaviour
13.1 Input Frequencies
The DPLL is able to synchronize to one of the following input frequencies:
13.2 Input Frequencies Selection
The input frequencies of REF 0 - 3 can be automatically detected or programmed independently by the Reference
Frequency Register (RFR) if RFRE (bit 1) in the DPLL Control Register (DPLLCR) is set. The detected frequency of
the selected reference is indicated in the Reference Change Status Register (RCSR). In addition, the detected
frequencies of all four references are indicated in the Reference Frequency Status Register (RFSR). See Table 28
on page 63, Table 29 on page 64, Table 37 on page 70 and Table 43 on page 77 for the detailed bit description of
the DPLL Control Register (DPLLCR), Reference Frequency Register (RFR), Reference Change Status Register
(RCSR) and Reference Frequency Status Register (RFSR), respectively.
13.3 Output Frequencies
The DPLL generates a limited number of output signals. All signals are synchronous to each other and in the
normal operating mode, are locked to the selected input reference. The DPLL provides outputs with the following
frequencies:
8 kHz
1.544 MHz (DS1)
2.048 MHz (E1)
4.096 MHz
8.192 MHz
16.384 MHz
19.44 MHz
Table 9 - DPLL Input Reference Frequencies
相關PDF資料
PDF描述
ZL50022GAC Enhanced 4 K Digital Switch with Stratum 4E DPLL
ZL50022QCC Enhanced 4 K Digital Switch with Stratum 4E DPLL
ZL50023 Enhanced 4 K Digital Switch
ZL50023GAC Enhanced 4 K Digital Switch
ZL50023QCC Enhanced 4 K Digital Switch
相關代理商/技術參數
參數描述
ZL50022_06 制造商:ZARLINK 制造商全稱:Zarlink Semiconductor Inc 功能描述:Enhanced 4 K Digital Switch with Stratum 4E DPLL
ZL50022GAC 制造商:Microsemi Corporation 功能描述:4K WITH RATE CONVERSION AND S4 - Trays 制造商:MICROSEMI CONSUMER MEDICAL PRODUCT GROUP 功能描述:IC TDM SWITCH 4K-CH ENH 256PBGA 制造商:Microsemi Corporation 功能描述:IC TDM SWITCH 4K-CH ENH 256PBGA
ZL50022GAG2 制造商:Microsemi Corporation 功能描述:SWIT FABRIC 4K X 4K 1.8V/3.3V 256BGA - Trays 制造商:MICROSEMI CONSUMER MEDICAL PRODUCT GROUP 功能描述:IC TDM SWITCH 4K-CH ENH 256PBGA 制造商:Microsemi Corporation 功能描述:IC TDM SWITCH 4K-CH ENH 256PBGA
ZL50022QCC 制造商:Microsemi Corporation 功能描述: 制造商:Microsemi Corporation 功能描述:4K WITH RATE CONVERSION AND S4E DPLL - Trays
ZL50022QCG1 制造商:Microsemi Corporation 功能描述:PB FREE 4K +RATE CONVERSION & 256L LQFP - Trays 制造商:MICROSEMI CONSUMER MEDICAL PRODUCT GROUP 功能描述:IC TDM SWITCH 4K-CH ENH 256LQFP 制造商:Microsemi Corporation 功能描述:IC TDM SWITCH 4K-CH ENH 256LQFP