參數資料
型號： TPS56100PWPR
元件分類： 基準電壓源/電流源
英文描述： Voltage-Mode SMPS Controller
中文描述： 電壓模式開關電源控制器
文件頁數： 25/34頁
文件大?。?/td> 811K
代理商： TPS56100PWPR
TPS56302
DUAL-OUTPUT LOW-INPUT-VOLTAGE
DSP POWER SUPPLY CONTROLLER WITH SEQUENCING
SLVS289A
–
MARCH 2000
–
REVISED OCTOBER 2000
25
POST OFFICE BOX 655303
DALLAS, TEXAS 75265
APPLICATION INFORMATION
droop compensation
Droop compensation with the offset resistor divider from V
OUT
to the VSENSE is used to keep the output voltage
in range during load transients by increasing the output voltage setpoint toward the upper tolerance limit during
light loads and decreasing the voltage setpoint toward the lower tolerance limit during heavy loads. This allows
the output voltage to swing a greater amount and still remain within the tolerance window. The maximum droop
voltage is set with R6 and R7:
VDROOPmax
VIOUTmax
R6
R6
R7
Where V
DROOP(max)
is the maximum droop voltage; V
IOUT(max)
is the maximum V
IOUT
that reflects the
maximum output current (full load); R6 is the bottom resistor of the divider connected to the DROOP
pin, R7
is the top resistor.
The offset voltage is set to be half of the maximum droop voltage higher than the nominal output voltage, so
the whole droop voltage range is symmetrical to the nominal output voltage. The formula for setting the offset
voltage is:
VOFFSET
1
2
VDROOPmax
VO
R12
R10
R12
Where V
OFFSET
is the desired offset voltage; V
DROOP(max)
is the droop voltage at full load; V
O
is the nominal
output voltage; R10 is the top resistor of the offset resistor divider, and R12 is the bottom one.
Therefore, with the setup above, at light load, the output voltage is:
VO NO LOAD
VOnom
VOFFSET
VOnom
1
2
VDROOP
And, at full load, the output voltage is:
VO FULL LOAD
VOnom
VOFFSET
VOnom
1
2
VDROOP
output inductor ripple current
The output inductor current ripple can affect not only the efficiency, but also the output voltage ripple. The
equation for calculating the inductor current ripple is exhibited in the following:
Iripple
VIN
VOUT
IOUT
LOUT
rDS(on)
RL
D
Ts
Where I
ripple
is the peak-to-peak ripple current (A) through the inductor; V
IN
is the input voltage (V); V
OUT
is the
output voltage (V); I
OUT
is the output current; r
DS(on)
is the on-time resistance of MOSFET (
); R
L
is the output
inductor equivalent series resistance; D is the duty cycle; and Ts is the switch cycle (S). From the equation, it
can be seen that the current ripple can be adjusted by changing the output inductor value.
Example:
V
IN
= 5 V; V
OUT
= 1.8 V; I
OUT
= 5 A; r
DS(on)
= 10 m
; R
L
= 5 m
; D = 0.36; Ts = 5
μ
s; L
OUT
= 6
μ
H
Then, the ripple I
ripple
= 1 A.
相關PDF資料
PDF描述
TPS5615CPWPR Voltage-Mode SMPS Controller
TPS5618CPWPR Voltage-Mode SMPS Controller
TPS5625CPWPR Voltage-Mode SMPS Controller
TPS60100PWPR Analog IC
TPS60101PWPR Analog IC
相關代理商/技術參數
參數描述
TPS56100PWPRG4 功能描述:DC/DC 開關控制器 5B Programmable Synch Buck Cntrlr RoHS:否 制造商:Texas Instruments 輸入電壓:6 V to 100 V 開關頻率: 輸出電壓:1.215 V to 80 V 輸出電流:3.5 A 輸出端數量:1 最大工作溫度:+ 125 C 安裝風格: 封裝 / 箱體:CPAK
TPS561201DDCR 功能描述:AUGUSTA NEXT 1A 制造商:texas instruments 系列:* 零件狀態:在售 標準包裝:1
TPS561201DDCT 功能描述:4.5V TO 17V INPUT, 1A SYNCHRONOU 制造商:texas instruments 系列:SWIFT?? 包裝:剪切帶（CT） 零件狀態:在售 功能:降壓 輸出配置:正 拓?fù)?降壓 輸出類型:可調式 輸出數:1 電壓 - 輸入（最小值）:4.5V 電壓 - 輸入（最大值）:17V 電壓 - 輸出（最小值/固定）:0.76V 電壓 - 輸出（最大值）:7V 電流 - 輸出:1A 頻率 - 開關:580kHz 同步整流器:是 工作溫度:-40°C ~ 85°C（TA） 安裝類型:表面貼裝 封裝/外殼:SOT-23-6 細型，TSOT-23-6 供應商器件封裝:SOT-23-6 標準包裝:1
TPS561201EVM-896 功能描述:EVAIL MOD 制造商:texas instruments 系列:* 零件狀態:在售 標準包裝:1
TPS561208DDCR 功能描述:AUGUSTANEXT 1A 制造商:texas instruments 系列:* 零件狀態:在售 標準包裝:1
發布緊急采購，3分鐘左右您將得到回復。

采購需求

(若只采購一條型號，填寫一行即可)

發布成功！您可以繼續發布采購。也可以進入我的后臺，查看報價

發布成功！您可以繼續發布采購。也可以進入我的后臺，查看報價

*型號 *數量 廠商 批號 封裝
添加更多采購

我的聯系方式

*
*
*