參數資料
型號: TMP96C141AF
廠商: Toshiba Corporation
英文描述: High Speed Advanced CMOS 16-bit Microcontroller For Controlling Medium to Large-Scale Equipment(用于中等到大型設備控制,高速、先進的 CMOS 16位微控制器)
中文描述: 采用先進的CMOS高速16位微控制器控制中的大型設備(用于中等到大型設備控制,高速,先進的的CMOS 16位微控制器)
文件頁數: 114/178頁
文件大?。?/td> 5667K
代理商: TMP96C141AF
114
TOSHIBA CORPORATION
TMP96C141AF
Setting example: To drive channel 0 (PG0) by 4-phase 1-2
step excitation (normal rotation) when
timer 0 is selected, set each register as follows:
Note:
x; don’t care –; no change
7
0
x
*
1
1
6
x
0
x
*
1
5
x
x
*
0
4
x
0
*
0
3
1
*
1
1
0
1
2
0
*
1
1
0
0
1
0
1
*
1
1
1
0
0
0
1
0
*
1
1
1
0
1
TRUN
TMOD
TFFCR
TREG0
P6CR
P6FC
PG01CR
PG0REG
TRUN
Stop timer 0, and clears it to zero.
Set 8-bit timer mode and selects
Clear TFF1 to zero and enables the inversion trigger by timer 0.
Set the cycle in timer register.
Set P60 ~ P63 bits to the output mode.
Set P60 ~ P63 bits to the PG output.
Select PG0 4-phase 1 - 2 step excitation mode and normal rotation.
Set an initial value.
Start timer 0.
φ
T1 as the input clock of timer 0.
Note:
To shift PG, TFFCR <TFF1IE> must be set to “1” to enable TFF1 inversion.
Table 3.10 (1) Select of Trigger Signal
TFF1 Inversion
PG Shift
8-bit timer mode
Selected by TFFCR <TFF1IS> when the up-counter value matches
TREG0 or TREG1 value.
When the up-counter value matches with both TREG0 and TREG1
values. (The value of up-counter = TREG1*2
When the up-counter value matches with both TREG0 and TREG1.
When the up-counter value matches TREG0 value and PWM cycle.
16-bit timer mode
8
+ TREG0)
PPG output mode
PWM output mode
When the up-counter value matches TREG1 value (PPG cycle).
Trigger signal for PG is not generated.
(3) Trigger Signal From Timer
The trigger signal from the timer which is used by PG is not
Channel 1 of PG can be synchronized with the 16-bit
timer Timer 4/Timer 5. In this case, the PG shift trigger signal
from the 16-bit timer is output only when the up-counter UC4/
UC5 value matches TREG5/TREG7.
When using a trigger signal from Timer 4, set either
T4FFCR <EQ5T4> or T4MOD <EQ5T5> to “1” and a trigger is
generated when the value in UC4 and the value in TREG5
match. When using a trigger signal from Timer 5, set T5FFCR
<EQ7T6> to 1. Generates a trigger when the value in UC5 and
the value in TREG7 match.
equal to the trigger signal of timer flip-flop (TFF1, TFF4, TFF5,
and TFF6) and differs as shown in Table 3.10 (1) depending on
the operation mode of the timer.
相關PDF資料
PDF描述
TMP96CM40F High Speed Advanced CMOS 16-bit Microcontroller With Bulit-in 32K Byte OTP ROM For Controlling Medium to Large-Scale Equipment(用于中等到大型設備控制,高速、先進的 CMOS 16位微控制器,芯片內置32K字節可一次編程ROM)
TMPA8700PSF CMOS 8-bit one-time PROM Microcontroller(CMOS OTP型EPROM 8位微控制器)
TMPA8700PSN CMOS 8-bit one-time PROM Microcontroller(CMOS OTP型EPROM 8位微控制器)
TMPR3904AF 32 Bit TX39 Family System RISC Microprocessor(32位TX39系列簡化指令系統計算機微處理器)
TMPR3907F 32 Bit TX39 Family System RISC Microprocessor(32位TX39系列簡化指令系統計算機微處理器)
相關代理商/技術參數
參數描述
TMP96C141BF 功能描述:16位微控制器 - MCU ROMLESS TLCS 900 w/ 1K RAM RoHS:否 制造商:Texas Instruments 核心:RISC 處理器系列:MSP430FR572x 數據總線寬度:16 bit 最大時鐘頻率:24 MHz 程序存儲器大小:8 KB 數據 RAM 大小:1 KB 片上 ADC:Yes 工作電源電壓:2 V to 3.6 V 工作溫度范圍:- 40 C to + 85 C 封裝 / 箱體:VQFN-40 安裝風格:SMD/SMT
TMP96C141BFG 功能描述:16位微控制器 - MCU 900 Romless MCU 1K RAM RoHS:否 制造商:Texas Instruments 核心:RISC 處理器系列:MSP430FR572x 數據總線寬度:16 bit 最大時鐘頻率:24 MHz 程序存儲器大小:8 KB 數據 RAM 大小:1 KB 片上 ADC:Yes 工作電源電壓:2 V to 3.6 V 工作溫度范圍:- 40 C to + 85 C 封裝 / 箱體:VQFN-40 安裝風格:SMD/SMT
TMP96CM40F 制造商:Toshiba America Electronic Components 功能描述:TLCS900 M/ROM, 32K ROM , 1K RAM - Tape and Reel
TMP96PM40F 制造商:TOSHIBA 制造商全稱:Toshiba Semiconductor 功能描述:Quality And Reliability Assurance / Handling Precautions
TMP96PM40F(Z) 功能描述:16位微控制器 - MCU 32K ROM OTP 1K RAM RoHS:否 制造商:Texas Instruments 核心:RISC 處理器系列:MSP430FR572x 數據總線寬度:16 bit 最大時鐘頻率:24 MHz 程序存儲器大小:8 KB 數據 RAM 大小:1 KB 片上 ADC:Yes 工作電源電壓:2 V to 3.6 V 工作溫度范圍:- 40 C to + 85 C 封裝 / 箱體:VQFN-40 安裝風格:SMD/SMT