- 您現在的位置：買賣IC網 > Datasheet目錄57 > SI4711-B30-GM (Silicon Laboratories Inc)IC TX FM RADIO 76-108MHZ 20UQFN Datasheet資料下載
參數資料
| 型號： | SI4711-B30-GM |
| 廠商： | Silicon Laboratories Inc |
| 文件頁數： | 25/40頁 |
| 文件大小： | 380K |
| 描述： | IC TX FM RADIO 76-108MHZ 20UQFN |
| 標準包裝： | 490 |
| 頻率： | 76MHz ~ 108MHz |
| 應用： | 通用 |
| 調制或協議： | FM |
| 電流 - 傳輸： | 18.8mA |
| 數據接口： | PCB，表面貼裝 |
| 天線連接器： | PCB，表面貼裝 |
| 電源電壓： | 2.7 V ~ 5.5 V |
| 封裝/外殼： | 20-UFQFN 裸露焊盤 |
| 包裝： | 托盤 |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁當前第25頁第26頁第27頁第28頁第29頁第30頁第31頁第32頁第33頁第34頁第35頁第36頁第37頁第38頁第39頁第40頁
Si4710/11-B30
Rev. 1.1
25
5.7. Pre-Emphasis and De-Emphasis
Pre-emphasis and de-emphasis is a technique used by
FM broadcasters to improve the signal-to-noise ratio of
FM receivers by reducing the effects of high-frequency
interference and noise. When the FM signal is
transmitted, a pre-emphasis filter is applied to
accentuate the high audio frequencies. All FM receivers
incorporate a de-emphasis filter that attenuates high
frequencies to restore a flat frequency response. Two
time constants are used in various regions. The pre-
emphasis time constant is programmable to 50 or 75 祍
and is set by using the TX_PREEMPHASIS property.
5.8. RDS/RBDS Processor (Si4711 Only)
The Si4711 implements an RDS/RBDS* processor for
symbol encoding, block synchronization, and error
correction. Digital data can be transmitted with the
Si4711 RDS/RBDS encoding feature.
RDS transmission is supported with three different
modes. The first mode is the simplest mode and
requires no additional user support except for pre-
loading the desired RDS PI and PTY codes and up to
12 8-byte PS character strings. The Si4711 will transmit
the PI code and rotate through the transmission of the
PS character strings with no further control required
from outside the device. The second mode allows for
more complicated transmissions. The PI and PTY
codes are written to the device as in mode 1. The
remaining blocks (B, C, and D) are written to a 252 byte
buffer. This buffer can hold 42 sets of BCD blocks. The
Si4711 creates RDS groups by creating block A from
the PI code, concatenating blocks BCD from the buffer,
and rotating through the buffer. The BCD buffer is
circular; so, the pattern is repeated until the buffer is
changed. Finally, the third mode allows the outside
controller to burst data into the BCD buffer, which
emulates a FIFO. The data does not repeat, but, when
the buffer is nearly empty, the Si4711 signals the
outside device to initiate another data burst. This mode
permits the outside device to use any RDS functionality
(including open data applications) that it wants.
*Note: RDS/RBDS is referred to only as RDS throughout the
remainder of this document.
5.9. Tuning
The frequency synthesizer uses Silicon Laboratories
proven technology including a completely integrated
VCO. The frequency synthesizer generates the
quadrature local oscillator signal used to upconvert the
low intermediate frequency to RF. The VCO frequency
is locked to the reference clock and adjusted with an
automatic frequency control (AFC) servo loop during
transmission.
The tuning frequency can be directly programmed with
commands. For example, to tune to 98.1 MHz, the user
writes the TX_TUNE_FREQ command with an
argument = 9810.
The Si4710/11 supports channel spacing of 50, 100, or
200 kHz.
5.10. Reference Clock
The Si4710/11 reference clock is programmable,
supporting RCLK frequencies from 31.130 kHz to
40 MHz. The RCLK frequency divided by an integer
number (the prescaler value) must fall in the range of
31,130 to 34,406 Hz. Therefore, the range of RCLK
frequencies is not continuous below frequencies of
311.3 kHz. The default RCLK frequency is 32.768 kHz.
Please refer to AN332: Universal Programming Guide
for using other RCLK frequencies.
5.11. Control Interface
A serial port slave interface is provided; this allows an
external controller to send commands to the Si4710/11
and receive responses from the device. The serial port
can operate in three bus modes: 2-wire mode, SPI
mode, or 3-wire mode. The Si4710/11 selects the bus
mode by sampling the state of the GPO1 and
GPO2/INT
pins on the rising edge of RST
. The GPO1
pin includes an internal pull-up resistor that is
connected while RST
is low, and the GPO2/INT
pin
includes an internal pull-down resistor that is connected
while RST
is low. Therefore, it is only necessary for the
user to actively drive pins that differ from these states.
相關PDF資料 |
PDF描述 |
|---|---|
| SI4713-B30-GMR | IC TX FM RADIO RPS/RDS 20UQFN |
| SKY12146-321LF | IC VAR VOLT ATTEN 12QFN |
| SN171GG-NR | SNAP PROTOBOARD W/NO RADIO |
| SWLP.2450.12.4.B.02 | ANTENNA WI-FI WLAN 2.4GHZ |
| TD4A | SENSOR RTD LIQUID TEMP 2TERM |
相關代理商/技術參數 |
參數描述 |
|---|---|
| SI4711-B30-GMR | 功能描述:射頻發射器 Si4711 Broadcast FM Transmitter RDS/RBDS RoHS:否 制造商:Micrel 類型:ASK Transmitter 封裝 / 箱體:SOT-23-6 工作頻率:300 MHz to 450 MHz 封裝:Reel |
| Si4712-A20-GM | 功能描述:射頻發射器 Broadcast FM Radio Trns-Pwr Scan RoHS:否 制造商:Micrel 類型:ASK Transmitter 封裝 / 箱體:SOT-23-6 工作頻率:300 MHz to 450 MHz 封裝:Reel |
| Si4712-A-EVB | 功能描述:射頻開發工具 Si4712 Eval Board Use Si4713-A-EVB RoHS:否 制造商:Taiyo Yuden 產品:Wireless Modules 類型:Wireless Audio 工具用于評估:WYSAAVDX7 頻率: 工作電源電壓:3.4 V to 5.5 V |
| Si4712-B30-GM | 功能描述:射頻發射器 FMRadio Trnsmttr w/Rcv PwrScn 3x3x.55 RoHS:否 制造商:Micrel 類型:ASK Transmitter 封裝 / 箱體:SOT-23-6 工作頻率:300 MHz to 450 MHz 封裝:Reel |
| SI4712-B30-GMR | 功能描述:射頻發射器 Si4712 Broadcast FM Transmitt Recvr Scan RoHS:否 制造商:Micrel 類型:ASK Transmitter 封裝 / 箱體:SOT-23-6 工作頻率:300 MHz to 450 MHz 封裝:Reel |
發布緊急采購，3分鐘左右您將得到回復。