- 您現在的位置：買賣IC網 > PDF目錄69312 > R5F2L387CDFP 8-BIT, FLASH, 20 MHz, MICROCONTROLLER, PQFP80 PDF資料下載
參數資料
| 型號： | R5F2L387CDFP |
| 元件分類： | 微控制器/微處理器 |
| 英文描述： | 8-BIT, FLASH, 20 MHz, MICROCONTROLLER, PQFP80 |
| 封裝： | 12 X 12 MM, 0.50 MM PITCH, PLASTIC, LQFP-80 |
| 文件頁數： | 19/74頁 |
| 文件大?。?/td> | 959K |
| 代理商： | R5F2L387CDFP |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁當前第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁第30頁第31頁第32頁第33頁第34頁第35頁第36頁第37頁第38頁第39頁第40頁第41頁第42頁第43頁第44頁第45頁第46頁第47頁第48頁第49頁第50頁第51頁第52頁第53頁第54頁第55頁第56頁第57頁第58頁第59頁第60頁第61頁第62頁第63頁第64頁第65頁第66頁第67頁第68頁第69頁第70頁第71頁第72頁第73頁第74頁
27
2588F–AVR–06/2013
ATtiny261/461/861
The fast peripheral clock, clk
PCK, can be selected as the clock source for Timer/Counter1 and a
prescaled version of the PLL output, clk
PLL, can be selected as system clock. See Figure 6-3 for
a detailed illustration on the PLL clock system.
Figure 6-3.
PCK Clocking System
The internal PLL is enabled when CKSEL fuse bits are programmed to ‘0001’and the PLLE bit of
PLLCSR is set. The internal oscillator and the PLL are switched off in power down and stand-by
sleep modes.
When the LSM bit of PLLCSR is set, the PLL switches from using the output of the internal 8
MHz oscillator to using the output divided by two. The frequency of the fast peripheral clock is
effectively divided by two, resulting in a clock frequency of 32 MHz. The LSM bit can not be set if
PLL
CLK is used as a system clock.
Since the PLL is locked to the output of the internal 8 MHz oscillator, adjusting the oscillator fre-
quency via the OSCCAL register also changes the frequency of the fast peripheral clock. It is
possible to adjust the frequency of the internal oscillator to well above 8 MHz but the fast periph-
eral clock will saturate and remain oscillating at about 85 MHz. In this case the PLL is no longer
locked to the internal oscillator clock signal. Therefore, in order to keep the PLL in the correct
operating range, it is recommended to program the OSCCAL registers such that the oscillator
frequency does not exceed 8 MHz.
The PLOCK bit in PLLCSR is set when PLL is locked.
Programming CKSEL fuse bits to ‘0001’, the PLL output divided by four will be used as a system
clock, as shown in Table 6-4.
Table 6-4.
PLLCK Operating Modes
CKSEL3:0
Nominal Frequency
0001
16 MHz
1/2
8 MHz
LSM
8 MHz
OSCILLATOR
PLL
8x
CKSEL3:0
PLLE
OSCCAL
4 MHz
1/4
LOCK
DETECTOR
PRESCALER
CLKPS3:0
clkPLL
PLOCK
clkPCK
OSCILLATORS
XTAL1
XTAL2
64 / 32 MHz
8 MHz
16 MHz
相關PDF資料 |
PDF描述 |
|---|---|
| R5F2L387CNFP | 8-BIT, FLASH, 20 MHz, MICROCONTROLLER, PQFP80 |
| R5F2L368CDFP | 8-BIT, FLASH, 20 MHz, MICROCONTROLLER, PQFP64 |
| R5F2L3AACDFA | 8-BIT, FLASH, 20 MHz, MICROCONTROLLER, PQFP100 |
| R5F2L3ACCDFA | 8-BIT, FLASH, 20 MHz, MICROCONTROLLER, PQFP100 |
| R5F2L38CCNFA | 8-BIT, FLASH, 20 MHz, MICROCONTROLLER, PQFP80 |
相關代理商/技術參數 |
參數描述 |
|---|---|
| R5F2L387CNFA#V0 | 制造商:Renesas Electronics Corporation 功能描述:IC MCU 16BIT 48KB FLASH |
| R5F2L387CNFP#30 | 制造商:Renesas Electronics Corporation 功能描述:R8C/L38C FL-48K, PLQP0080KB-A - Trays 制造商:Renesas Electronics Corporation 功能描述:IC MCU 16BIT 48KB FLASH 80LQFP |
| R5F2L387MDFA#V0 | 制造商:Renesas Electronics Corporation 功能描述:IC MCU 16BIT 48KB FLASH |
| R5F2L387MNFA#V0 | 制造商:Renesas Electronics Corporation 功能描述:R8C/L38M 48+4/6 80LQFP 14X14 -20 TO +85 - Trays 制造商:Renesas Electronics Corporation 功能描述:IC MCU 16BIT 48KB FLASH 80LQFP |
| R5F2L387MNFP#30 | 制造商:Renesas Electronics Corporation 功能描述:IC MCU 16BIT 48KB FLASH 80LQFP |
發布緊急采購，3分鐘左右您將得到回復。