- 您現在的位置：買賣IC網 > PDF目錄378056 > PM73488-PI (PMC-SIERRA INC) 5 Gbit/s ATM Switch Fabric Element PDF資料下載
參數資料
| 型號： | PM73488-PI |
| 廠商： | PMC-SIERRA INC |
| 元件分類： | 數字傳輸電路 |
| 英文描述： | 5 Gbit/s ATM Switch Fabric Element |
| 中文描述： | ATM SWITCHING CIRCUIT, PBGA596 |
| 封裝： | EPBGA-596 |
| 文件頁數： | 50/135頁 |
| 文件大?。?/td> | 1735K |
| 代理商： | PM73488-PI |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁第30頁第31頁第32頁第33頁第34頁第35頁第36頁第37頁第38頁第39頁第40頁第41頁第42頁第43頁第44頁第45頁第46頁第47頁第48頁第49頁當前第50頁第51頁第52頁第53頁第54頁第55頁第56頁第57頁第58頁第59頁第60頁第61頁第62頁第63頁第64頁第65頁第66頁第67頁第68頁第69頁第70頁第71頁第72頁第73頁第74頁第75頁第76頁第77頁第78頁第79頁第80頁第81頁第82頁第83頁第84頁第85頁第86頁第87頁第88頁第89頁第90頁第91頁第92頁第93頁第94頁第95頁第96頁第97頁第98頁第99頁第100頁第101頁第102頁第103頁第104頁第105頁第106頁第107頁第108頁第109頁第110頁第111頁第112頁第113頁第114頁第115頁第116頁第117頁第118頁第119頁第120頁第121頁第122頁第123頁第124頁第125頁第126頁第127頁第128頁第129頁第130頁第131頁第132頁第133頁第134頁第135頁
PMC-Sierra, Inc.
PM73488 QSE
L
PMC-980616
Issue 3
5 Gbit/s ATMSwitch Fabric Element
Released
Datasheet
52
All dribbling errors,
Any bridging fault between ports, and
Complex partial failures.
As much as possible, the following secondary goals will be taken into account in the algorithms implemented.
Quick and responsive in failure detection,
Localize the problem, and minimize the effect of the problem,
Avoid throughput collapse,
Identify and locate the problem,
Possibly do strong manufacturing test,
On line diagnostics, and
Automatically detect when a failure resolves itself.
5. 3. Fault Detection Mechanisms
Several mechanisms are built into the QSE and the QRT to facilitate online detection and location of faults within a
system. These involve:
Special coding and guaranteed transitions on the BP_ACK line. If this is not detected, the condition is
flagged, and no data is sent out on the port.
Special coding and guaranteed transitions on the SE_SOC line. If this is not detected, the port is flagged as
failed, and all data from the port is discarded.
Cell present being marked by two bits, Nibble 0 is 10xx for cell present or 01xx for cell absent (11xx and
00xx are considered errors, the port is flagged as failed, and all data from the port is discarded).
Idle cell is coded by five nibbles, (01xx, 0000,1000, 0100, 0010, 0001). This pattern verifies no line has a
stuck-at or bridging fault.
Closed loop port behavior ensures no data is sent to a bad port. If a port is flagged as failed, then no BP
signal is sent back on the BP_ACK line. This in turn will be detected by the transmitting QSE, and will be
flagged. In addition, no data will be sent to that port while the condition exists.
Nibbles 1 through 12 of the cell header are parity protected. For unicast data, in the QRT, a parity errored
cell is dropped, but an ACK is still issued. In the QSE, an ONACK is issued for parity errored cells. This
results in the unicast ONACKed cell being retransmitted if the parity error did not occur in the last stage. For
multicast data, parity errored cells are dropped by both the QRT and QSE.
Marked cell count. All input and output ports have a 4-bit cell counter. Any cell that goes by with a marked
cell count bit set increments this count. (Note that unicast traffic has to be ACKed to increment the count.)
Modulo 16 arithmetic can be performed on these counts to determine if there was any unexpected cell loss or
generation.
Whenever a port is tagged dead due to BP_ACK failure, there needs to be two consecutive good instances to
make the port alive again.
5. 4. Interface Behavior
In Figure 33 on page 51, the various interfaces of interest are labeled
a
,
b
,
c
,
d
,
e
,
f
,
g
, and
h
respectively.
相關PDF資料 |
PDF描述 |
|---|---|
| PM73488 | 5 Gbit/s ATM Switch Fabric Element |
| PM7349 | Ultraframer DS3/E3/DS2/E2/DS1/E1/DS0 |
| PM7350 | Dual Serial Link, PHY Multiplexer |
| PM7350-PI | DUAL SERIAL LINK PHY MULTIPLEXER |
| PM7351 | OCTAL SERIAL LINK MULTIPLEXER |
相關代理商/技術參數 |
參數描述 |
|---|---|
| PM7349 | 制造商:PMC 制造商全稱:PMC 功能描述:Quad J2, E3 and DS-3 Framer |
| PM7349-BI | 制造商:未知廠家 制造商全稱:未知廠家 功能描述:Telecommunication IC |
| PM7350 | 制造商:PMC 制造商全稱:PMC 功能描述:DUAL SERIAL LINK PHY MULTIPLEXER |
發布緊急采購，3分鐘左右您將得到回復。