![](http://datasheet.mmic.net.cn/330000/PM7340_datasheet_16444385/PM7340_185.png)
PRELIMINARY
INVERSE MULTIPLEXING OVER ATM
PM7340 S/UNI-IMA-8
DATA SHEET
PMC-2001723
ISSUE 3
INVERSE MULTIPLEXING OVER ATM
PROPRIETARY AND CONFIDENTIAL TO PMC-SIERRA, INC., AND FOR ITS CUSTOMERS’ INTERNAL USE
168
expires.
FE entered CONFIG-ABORTED state
during group start-up.
4
FE_ABORT_INT
3
NE_ABORT_INT
Entered NE Config aborted state. FE
group parameters unacceptable during
group start-up. Possible causes are
IMA OAM label proposed by FE not
acceptable.
Group symmetry proposed by FE not
acceptable.
RX M proposed by FE not acceptable
GTSM state change.
2
GTSM_INT
1
FE_GSM_INT
FE GSM state change.
0
NE_GSM_INT
NE GSM state change.
2
31:24
TX_SCCI
Current TX SCCI value for the group.
Each time the Tx ICP cell class B&C
info changes, the SCCI field
increments by one.
This field will remain at its current value
during a group-restart.
23:16
TX_RX_TEST_PT
N
Tx test pattern field to be sent in the
transmit ICP cell. If the test link
command active bit in the incoming
ICP cell from RDAT is set, this field is
updated using the TX test pattern field
in the same ICP cell; otherwise this
field is set to “FF” internally.
This field will remain at its current value
during a group-restart.
15:3
RESERVED
2:0
TX_TRL_PHY_ID
Physical link ID for TX TRL. This field
need to be programmed by PM prior to
group startup to ensure TX IDCC ticks
are generated and TIMA start sending
ICP cells once the group is added.