參數資料
型號： PI7C7300ANA
廠商： Pericom Semiconductor Corp.
英文描述： 3-PORT PCI-to-PCI BRIDGE
中文描述： 3端口PCI至PCI橋
文件頁數： 42/109頁
文件大小： 779K
代理商： PI7C7300ANA
PI7C7300A
3-PORT PCI-TO-PCI BRIDGE
ADVANCE INFORMATION
Page 42 OF 109
09/25/03 Revision 1.09
and master enable bits, and change them subsequently only when the primary and
secondary PCI buses are idle.
5.2.1
I/O BASE AND LIMIT ADDRESS REGISTER
PI7C7300A implements one set of I/O base and limit address registers in configuration
space that define an I/O address range per port downstream forwarding. PI7C7300A
supports 32-bit I/O addressing, which allows I/O addresses downstream of PI7C7300A
to be mapped anywhere in a 4GB I/O address space.
I/O transactions with addresses that fall inside the range defined by the I/O base and limit
registers are forwarded downstream from the primary PCI bus to the secondary PCI bus.
I/O transactions with addresses that fall outside this range are forwarded upstream from
the secondary PCI bus to the primary PCI bus.
The I/O range can be turned off by setting the I/O base address to a value greater than
that of the I/O limit address. When the I/O range is turned off, all I/O trans-actions are
forwarded upstream, and no I/O transactions are forwarded downstream. The I/O range
has a minimum granularity of 4KB and is aligned on a 4KB boundary. The maximum I/O
range is 4GB in size. The I/O base register consists of an 8-bit field at configuration
address 1Ch, and a 16-bit field at address 30h. The top 4 bits of the 8-bit field define bits
[15:12] of the I/O base address.
The bottom 4 bits read only as 1h to indicate that PI7C7300A supports 32-bit I/O
addressing. Bits [11:0] of the base address are assumed to be 0, which naturally aligns
the base address to a 4KB boundary. The 16 bits contained in the I/O base upper 16 bits
register at configuration offset 30h define AD[31:16] of the I/O base address. All 16 bits
are read/write. After primary bus reset or chip reset, the value of the I/O base address is
initialized to 0000 0000h.
The I/O limit register consists of an 8-bit field at configuration offset 1Dh and a 16-bit
field at offset 32h. The top 4 bits of the 8-bit field define bits [15:12] of the I/O limit
address. The bottom 4 bits read only as 1h to indicate that 32-bit I/O addressing is
supported. Bits [11:0] of the limit address are assumed to be FFFh, which naturally aligns
the limit address to the top of a 4KB I/O address block. The 16 bits contained in the I/O
limit upper 16 bits register at configuration offset 32h define AD[31:16] of the I/O limit
address. All 16 bits are read/write. After primary bus reset or chip reset, the value of the
I/O limit address is reset to 0000 0FFFh.
Note:
The initial states of the I/O base and I/O limit address registers define an I/O range
of 0000 0000h to 0000 0FFFh, which is the bottom 4KB of I/O space. Write these
registers with their appropriate values before setting either the I/O enable bit or the
master enable bit in the command register in configuration space.
5.2.2
ISA MODE
PI7C7300A supports ISA mode by providing an ISA enable bit in the bridge control
register in configuration space. ISA mode modifies the response of PI7C7300A inside
the I/O address range in order to support mapping of I/O space in the presence of an ISA
bus in the system. This bit only affects the response of PI7C7300A when the transaction
falls inside the address range defined by the I/O base and limit address registers, and only
相關PDF資料
PDF描述
PI7C8140A 2 PORT PCI TO PCI BRIDGE PLX PCI 6140 COMPARISON
PI7C8148B 2-PORT PCI-to-PCI BRIDGE PLX PC16152 COMPARISON
PI7C8150B-33 PCI Bridge | Asynchronous 2-Port PCI Bridge
PI7C8152B PCI Bridge | Asynchronous 2-Port PCI Bridge
PI7C8154 PCI Bridge | 2-Port PCI-to-PCI Bridge
相關代理商/技術參數
參數描述
PI7C7300ANAE 功能描述:外圍驅動器與原件 - PCI 3 Port PCI Bridge RoHS:否 制造商:PLX Technology 工作電源電壓: 最大工作溫度: 安裝風格:SMD/SMT 封裝 / 箱體:FCBGA-1156 封裝:Tray
PI7C7300ANA-E 制造商:Pericom Semiconductor Corporation 功能描述:PCI-to-PCI Bridge 272-Pin BGA 制造商:Pericom Semiconductor Corporation 功能描述:PCI to PCI Bridge 272-Pin BGA
PI7C7300DNAE 功能描述:外圍驅動器與原件 - PCI PCI -to -PCI Bridge 3 Port RoHS:否 制造商:PLX Technology 工作電源電壓: 最大工作溫度: 安裝風格:SMD/SMT 封裝 / 箱體:FCBGA-1156 封裝:Tray
PI7C7300EVB 功能描述:界面開發工具 3 Port PCI Bridge Eval Brd RoHS:否 制造商:Bourns 產品:Evaluation Boards 類型:RS-485 工具用于評估:ADM3485E 接口類型:RS-485 工作電源電壓:3.3 V
PI7C8140A 制造商:PERICOM 制造商全稱:Pericom Semiconductor Corporation 功能描述:2 PORT PCI TO PCI BRIDGE PLX PCI 6140 COMPARISON
發布緊急采購，3分鐘左右您將得到回復。

采購需求

(若只采購一條型號，填寫一行即可)

發布成功！您可以繼續發布采購。也可以進入我的后臺，查看報價

發布成功！您可以繼續發布采購。也可以進入我的后臺，查看報價

*型號 *數量 廠商 批號 封裝
添加更多采購

我的聯系方式

*
*
*