參數資料
          型號: PF48F3P0ZT00
          廠商: Intel Corp.
          英文描述: Intel StrataFlash Embedded Memory
          中文描述: 英特爾StrataFlash嵌入式存儲器
          文件頁數: 69/102頁
          文件大?。?/td> 1609K
          代理商: PF48F3P0ZT00
          1-Gbit P30 Family
          Datasheet
          Intel StrataFlash
          Embedded Memory (P30)
          Order Number: 306666, Revision: 001
          April 2005
          69
          13.0
          Security Modes
          The device features security modes used to protect the information stored in the flash memory
          array. The following sections describe each security mode in detail.
          13.1
          Block Locking
          Individual instant block locking is used to protect user code and/or data within the flash memory
          array. All blocks power up in a locked state to protect array data from being altered during power
          transitions. Any block can be locked or unlocked with no latency. Locked blocks cannot be
          programmed or erased; they can only be read.
          Software-controlled security is implemented using the Block Lock and Block Unlock commands.
          Hardware-controlled security can be implemented using the Block Lock-Down command along
          with asserting WP#. Also, V
          PP
          data security can be used to inhibit program and erase operations
          (see
          Section 11.6, “Program Protection” on page 66
          and
          Section 12.4, “Erase Protection” on
          page 68
          ).
          The P30 device also offers four pre-defined areas in the main array that can be configured as One-
          Time Programmable (OTP) for the highest level of security. These include the four 32 KB
          parameter blocks together as one and the three adjacent 128 KB main blocks. This is available for
          top or bottom parameter devices.
          13.1.1
          Lock Block
          To lock a block, issue the Lock Block Setup command. The next command must be the Lock Block
          command issued to the desired block’s address (see
          Section 9.2, “Device Commands” on page 50
          and
          Figure 46, “Block Lock Operations Flowchart” on page 91
          ). If the Set Read Configuration
          Register command is issued after the Block Lock Setup command, the device configures the RCR
          instead.
          Block lock and unlock operations are not affected by the voltage level on V
          PP
          . The block lock bits
          may be modified and/or read even if V
          PP
          is at or below V
          PPLK
          .
          13.1.2
          Unlock Block
          The Unlock Block command is used to unlock blocks (see
          Section 9.2, “Device Commands” on
          page 50
          ). Unlocked blocks can be read, programmed, and erased. Unlocked blocks return to a
          locked state when the device is reset or powered down. If a block is in a lock-down state, WP#
          must be deasserted before it can be unlocked (see
          Figure 32, “Block Locking State Diagram” on
          page 70
          ).
          13.1.3
          Lock-Down Block
          A locked or unlocked block can be locked-down by writing the Lock-Down Block command
          sequence (see
          Section 9.2, “Device Commands” on page 50
          ). Blocks in a lock-down state cannot
          be programmed or erased; they can only be read. However, unlike locked blocks, their locked state
          cannot be changed by software commands alone. A locked-down block can only be unlocked by
          issuing the Unlock Block command with WP# deasserted. To return an unlocked block to locked-
          相關PDF資料
          PDF描述
          PF48F4P0ZT00 Circular Connector; No. of Contacts:21; Series:; Body Material:Aluminum; Connecting Termination:Crimp; Connector Shell Size:22; Circular Contact Gender:Pin; Circular Shell Style:Wall Mount Receptacle; Insert Arrangement:22-21
          PF48F2000P0ZBQ0 Intel StrataFlash Embedded Memory
          PF48F3000P0ZBQ0 CAP 0.01UF 63V 10% MET-POLY-BOX RAD5MM 7.5X6.5X2.5MM BULK
          PF48F4000P0ZBQ0 Intel StrataFlash Embedded Memory
          PF48F0P0ZBQ0 Intel StrataFlash Embedded Memory
          相關代理商/技術參數
          參數描述
          PF48F3P0ZTQ0 制造商:INTEL 制造商全稱:Intel Corporation 功能描述:Intel StrataFlash Embedded Memory
          PF48F4000M0Y0CEA 制造商:Micron Technology Inc 功能描述:256BA/0BA SCSP 1.8 X16C HF - Trays
          PF48F4000P0ZB 制造商:MICRON 制造商全稱:Micron Technology 功能描述:Micron Parallel NOR Flash Embedded Memory (P30-65nm)
          PF48F4000P0ZBQ0 制造商:NUMONYX 制造商全稱:Numonyx B.V 功能描述:Numonyx StrataFlash Embedded Memory
          PF48F4000P0ZBQ0A 功能描述:IC FLASH 256MBIT 100NS 88-SCSP RoHS:是 類別:集成電路 (IC) >> 存儲器 系列:StrataFlash™ 產品變化通告:Product Discontinuation 26/Apr/2010 標準包裝:136 系列:- 格式 - 存儲器:RAM 存儲器類型:SRAM - 同步,DDR II 存儲容量:18M(1M x 18) 速度:200MHz 接口:并聯 電源電壓:1.7 V ~ 1.9 V 工作溫度:0°C ~ 70°C 封裝/外殼:165-TBGA 供應商設備封裝:165-CABGA(13x15) 包裝:托盤 其它名稱:71P71804S200BQ