- 您現在的位置：買賣IC網 > PDF目錄98050 > P95020ZNQGI (INTEGRATED DEVICE TECHNOLOGY INC) 2-CHANNEL POWER SUPPLY MANAGEMENT CKT, QCC132 PDF資料下載
參數資料
| 型號： | P95020ZNQGI |
| 廠商： | INTEGRATED DEVICE TECHNOLOGY INC |
| 元件分類： | 電源管理 |
| 英文描述： | 2-CHANNEL POWER SUPPLY MANAGEMENT CKT, QCC132 |
| 封裝： | QFN-132 |
| 文件頁數： | 98/137頁 |
| 文件大?。?/td> | 3533K |
| 代理商： | P95020ZNQGI |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁第30頁第31頁第32頁第33頁第34頁第35頁第36頁第37頁第38頁第39頁第40頁第41頁第42頁第43頁第44頁第45頁第46頁第47頁第48頁第49頁第50頁第51頁第52頁第53頁第54頁第55頁第56頁第57頁第58頁第59頁第60頁第61頁第62頁第63頁第64頁第65頁第66頁第67頁第68頁第69頁第70頁第71頁第72頁第73頁第74頁第75頁第76頁第77頁第78頁第79頁第80頁第81頁第82頁第83頁第84頁第85頁第86頁第87頁第88頁第89頁第90頁第91頁第92頁第93頁第94頁第95頁第96頁第97頁當前第98頁第99頁第100頁第101頁第102頁第103頁第104頁第105頁第106頁第107頁第108頁第109頁第110頁第111頁第112頁第113頁第114頁第115頁第116頁第117頁第118頁第119頁第120頁第121頁第122頁第123頁第124頁第125頁第126頁第127頁第128頁第129頁第130頁第131頁第132頁第133頁第134頁第135頁第136頁第137頁
P95020 / Preliminary Datasheet
Revision 0.7.10
63
2010 Integrated Device Technology, Inc.
STJITTER
Short Term Jitter (peak-to-peak)
24, 48 MHz Output
200
ps
32 kHz Output
300
ns
tPU
Power-up Time
From minimum VDD_CKGEN18 and
VDD_CKGEN33 to outputs stable to
±1% Note 2
3
ms
From stable crystal 32kHz input to
stable output
300
ms
Notes:
1.
Measured with a 5pF load.
2.
Power-up time for TCXO derived output frequencies only after TCXO has stabilized.
4.3
CKGEN - PLL CONTROL
The PLL in the CKGEN module is powered on/off by setting bits [2:0] in the CKGEN_PLL_CFG register as shown below.
S2
S1
S0
PLL behavior
0
PLL OFF
0
1
PLL power up with 26MHz TCXO_IN as
reference clock
0
1
0
PLL power up with 32kHz XTAL_IN as
reference clock
0
1
PLL power up with 26MHz TCXO_IN
as reference clock
1
0
PLL OFF
1
0
1
PLL power up with 12MHz TCXO_IN as
reference clock
1
0
PLL power up with 13MHz TCXO_IN as
reference clock
1
PLL power up with 19.2MHz TCXO_IN
as reference clock
The 12 MHz and 48 MHz outputs are enabled/disabled by setting bits [7:6] in the CKGEN_PLL_CFG register. One or
both of the clock outputs will be enabled when a “1” is written into the corresponding register location for the output in
question.
4.4
CKGEN
– OSCILLATOR CIRCUIT
The CKGEN module may use an external 32.768 kHz crystal connected to the XTALIN pin. The oscillator circuit does not
require any external resistors or capacitors to operate. Table 15 specifies several crystal parameters for the external
crystal. The typical startup time is less than one second when using a crystal with the specified characteristics.
Table 15 - Crystal Specifications
SYMBOL
PARAMETER
MIN
TYP
MAX
UNITS
COMMENTS
fo
Nominal Frequency
32.768
kHz
ESR
Series Resistance
80
k
CL
Load Capacitance
12
pF
4.5
CKGEN - CKGEN POWER SOURCE
The CKGEN module receives its power from an on-chip LDO. The CKGEN power is controlled
via the “PSTATE_ON” bit
in the Power State and Switch Control Register (see section 13.3.10). Setting that register is automatic whenever there is
an interrupt targeting the embedded processor pending. The
“PSTATE_ON” bit can be cleared by writing a logic “1” if
software wants to power down the CKGEN. Please be aware that powering down the CKGEN should be the last
operation by the software, since once CKGEN is powered down, there will be no clock for the internal register access bus
and IC. The P95020 has a minor delay when the PSTATE_ON bit is cleared to allow the
“cleaning” access to be
finished.
When CKGEN is powered, the 8M clock will be available so the IC/processor will be active. The chip
s registers can be
accessed. However, the PLLs will still not be on. To turn on the PLLs, S2:S0 registers need to be set.
4.6
CKGEN
– CLOCK ACCURACY
The accuracy of the clock is dependent upon the accuracy of the crystal and the accuracy of the match between the
capacitive load of the oscillator circuit and the capacitive load for which the crystal was trimmed. Additional error is added
相關PDF資料 |
PDF描述 |
|---|---|
| P95020ZNQG | 2-CHANNEL POWER SUPPLY MANAGEMENT CKT, QCC132 |
| P95020ZLLG8 | 2-CHANNEL POWER SUPPLY MANAGEMENT CKT, PBGA124 |
| P95020ZLLGI8 | 2-CHANNEL POWER SUPPLY MANAGEMENT CKT, PBGA124 |
| PBL3717A | STEPPER MOTOR CONTROLLER, 1.2 A, PDIP16 |
| PC13892AJVL | 1-CHANNEL POWER SUPPLY MANAGEMENT CKT, PBGA186 |
相關代理商/技術參數 |
參數描述 |
|---|---|
| P95021NQG | 功能描述:PMIC 解決方案 Integrates Audio, LED B/Light Pwr Mgt RoHS:否 制造商:Texas Instruments 安裝風格:SMD/SMT 封裝 / 箱體:QFN-24 封裝:Reel |
| P95021NQG8 | 制造商:Integrated Device Technology Inc 功能描述:POWER MANAGEMENT, AUDIO & CONT 制造商:Integrated Device Technology Inc 功能描述:132-VFQFPN - Tape and Reel 制造商:Integrated Device Technology Inc 功能描述:Integrates Audio, LED B/Light Pwr Mgt |
| P950-36I | 制造商:Tripp Lite 功能描述:SERIAL ATA II SIGNAL CABLE, 2X7-PIN STRAIGHT CONNECTOR - 39" - Bulk |
| P9508- | 制造商:ROEBUCK 功能描述:ROEBUCK DISH WASHING BRUSH |
| P9-511121 | 功能描述:按鈕開關 Flush Dome Solder 5A SPST-DB, SPDT-DB RoHS:否 制造商:OTTO 觸點形式: 開關功能: 電流額定值: 電壓額定值 AC: 電壓額定值 DC: 功率額定值: 安裝風格: 照明: 照明顏色: IP 等級: 端接類型: 觸點電鍍: 執行器: 蓋顏色: 封裝: 可燃性等級: |
發布緊急采購，3分鐘左右您將得到回復。