參數資料
型號: NS16C2752TVA
廠商: NATIONAL SEMICONDUCTOR CORP
元件分類: 微控制器/微處理器
英文描述: Dual UART with 16-byte/64-byte FIFOs and up to 5 Mbit/s Data Rate
中文描述: 2 CHANNEL(S), 5M bps, SERIAL COMM CONTROLLER, PQCC44
封裝: PLASTIC, LCC-44
文件頁數: 36/43頁
文件大?。?/td> 881K
代理商: NS16C2752TVA
8.0 Design Notes
(Continued)
FCR 0x02.3 = 1
LCR 0x03.7:0 = temp
8.5 DIFFERENCES BETWEEN THE PC16552D AND
NS16C2552/2752
The following are differences between the versions of UART
that helps user to identify the feature differences.
TABLE 31. Differences among the UART products
Features
PC16552D
16-byte
4.5V to 5.5V
1.5Mbps
24MHz
0 - 70C
No
No
No
No
3-bit
1 level
No
No
NS16C2552
16-byte
2.97V to 5.5V
5.0Mbps
80MHz
-40 to 85C
Yes
Yes
Yes
Yes
5-bit
1 level
Yes
Yes
NS16C2752
64-byte
2.97V to 5.5V
5.0Mbps
80MHz
-40 to 85C
Yes
Yes
Yes
Yes
5-bit
4 levels
Yes
Yes
Tx and Rx FIFO sizes
Supply voltage
Highest baud rate
Highest clock input frequency
Operating temperature
Enhanced Register Set
Sleep mode IER[4]
Xon, Xoff, and Xon-Any software auto flow control
CTS and RTS hardware auto flow control
Interrupt source ID in IIR
Tx FIFO trigger level select FCR[5:4]
IrDA v1.0 mode MCR[6]
Clock divisor 1 or 4 select MCR[7]
8.6 NOTES ON TX FIFO OF NS16C2752
Notes on interrupt assertion and deassertion.
1.
To avoid frequent interrupt request generation, there is a
hysteresis of two characters. When the transmit FIFO
threshold is enabled and the number of empty spaces
reaches the threshold, a THR empty interrupt is gener-
ated requesting the CPU to fill the transmit FIFO. The
host has to fill at least two characters in the Tx FIFO
before another THR empty interrupt can be generated.
The DMA request TXRDY works differently. When the
number of empty spaces exceeds the threshold, TXRDY
asserts initiating the DMA transfer. The TXRDY deas-
serts when the transmit FIFO is full.
2.
When the number of empty spaces reaches the thresh-
old level, an interrupt is generated. If the host does not
fill the FIFO, the interrupt will remain asserted until the
host writes to the THR or reads from IIR.
When the number of empty spaces reaches the thresh-
old level, an interrupt is generated. If the host reads the
IIR but does not fill the Tx FIFO, the INTR is deasserted.
However, if the host still does not fill the Tx FIFO, the
FIFO becomes empty. The THR empty interrupt is not
generated because the host has not written to the Tx
FIFO and the interrupt service is not complete.
When the number of empty spaces reaches the thresh-
old level, a THR empty interrupt is generated. If the host
writes at least one character into the Tx FIFO, the inter-
rupt is serviced and the THR empty flag is deasserted.
Subsequently, if the host fails to fill the FIFO before it
reaches empty, a THR empty interrupt will be asserted.
Reset Tx FIFO causes a THR empty interrupt.
3.
4.
5.
N
www.national.com
36
相關PDF資料
PDF描述
NS32203D DIRECT MEMORY ACCESS CONTROLLER
NS32203N DIRECT MEMORY ACCESS CONTROLLER
NS32382-10 MEMORY MANAGEMENT UNITS
NS32382-15 MEMORY MANAGEMENT UNITS
NS32490D NIC Network Interface Controller(NIC網絡接口控制器)
相關代理商/技術參數
參數描述
NS16C2752TVA/NOPB 功能描述:UART 接口集成電路 RoHS:否 制造商:Texas Instruments 通道數量:2 數據速率:3 Mbps 電源電壓-最大:3.6 V 電源電壓-最小:2.7 V 電源電流:20 mA 最大工作溫度:+ 85 C 最小工作溫度:- 40 C 封裝 / 箱體:LQFP-48 封裝:Reel
NS16C2752TVAX/NOPB 功能描述:UART 接口集成電路 Dual UART w/ 64-byte FIFO RoHS:否 制造商:Texas Instruments 通道數量:2 數據速率:3 Mbps 電源電壓-最大:3.6 V 電源電壓-最小:2.7 V 電源電流:20 mA 最大工作溫度:+ 85 C 最小工作溫度:- 40 C 封裝 / 箱體:LQFP-48 封裝:Reel
NS16C2752TVS 制造商:Texas Instruments 功能描述:UART 2-CH 64Byte FIFO 3.3V/5V 48-Pin TQFP
NS16C2752TVS/NOPB 功能描述:UART 接口集成電路 RoHS:否 制造商:Texas Instruments 通道數量:2 數據速率:3 Mbps 電源電壓-最大:3.6 V 電源電壓-最小:2.7 V 電源電流:20 mA 最大工作溫度:+ 85 C 最小工作溫度:- 40 C 封裝 / 箱體:LQFP-48 封裝:Reel
NS16C2752TVSX/NOPB 功能描述:UART 接口集成電路 Dual UART w/ 64-byte FIFO RoHS:否 制造商:Texas Instruments 通道數量:2 數據速率:3 Mbps 電源電壓-最大:3.6 V 電源電壓-最小:2.7 V 電源電流:20 mA 最大工作溫度:+ 85 C 最小工作溫度:- 40 C 封裝 / 箱體:LQFP-48 封裝:Reel