- 您現在的位置：買賣IC網 > PDF目錄363664 > NS16C2752TVA (NATIONAL SEMICONDUCTOR CORP) Dual UART with 16-byte/64-byte FIFOs and up to 5 Mbit/s Data Rate PDF資料下載
參數資料
| 型號： | NS16C2752TVA |
| 廠商： | NATIONAL SEMICONDUCTOR CORP |
| 元件分類： | 微控制器/微處理器 |
| 英文描述： | Dual UART with 16-byte/64-byte FIFOs and up to 5 Mbit/s Data Rate |
| 中文描述： | 2 CHANNEL(S), 5M bps, SERIAL COMM CONTROLLER, PQCC44 |
| 封裝： | PLASTIC, LCC-44 |
| 文件頁數： | 21/43頁 |
| 文件大?。?/td> | 881K |
| 代理商： | NS16C2752TVA |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁當前第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁第30頁第31頁第32頁第33頁第34頁第35頁第36頁第37頁第38頁第39頁第40頁第41頁第42頁第43頁
6.0 Register Set
(Continued)
TABLE 12. LSR (0x5)
(Continued)
Bit
3
Bit Name
Rx Frame
Error
R/W
Def
R
0
Description
Framing Error Indicator
This bit is the Framing Error (FE) indicator.
1= Received character did not have a valid Stop bit when the serial channel detects a
logic 0 during the first Stop bit time.
0 = No frame error (default).
The bit is reset to 0 whenever the CPU reads the contents of the Line Status Register
or when the next valid character is loaded into the Receiver Buffer Register. In the
FIFO Mode this error is associated with the particular character in the FIFO it applies
to. This error is revealed to the CPU when its associated character is at the top of the
FIFO. The serial channel will try to resynchronize after a framing error. This assumes
that the framing error was due to the next start bit, so it samples this start bit twice
and then takes in the data.
Parity Error Indicator
This bit is the Parity Error (PE) indicator.
1 = Received data word does not have the correct even or odd parity, as selected by
the even-parity-select bit during the character Stop bit time when the character has a
parity error.
0 = No parity error (default).
This bit is reset to a logic 0 whenever the CPU reads the contents of the Line Status
Register or when the next valid character is loaded into the Receiver Buffer Register.
In the FIFO mode this error is associated with the particular character in the FIFO it
applies to. This error is revealed to the host when its associated character is at the
top of the FIFO.
Overrun Error Indicator
This bit is the Overrun Error (OE) indicator.
This bit indicates that the next character received was transferred into the Receiver
Buffer Register before the CPU could read the previously received character. This
transfer overwrites the previous character. It is reset whenever the CPU reads the
contents of the Line Status Register. If the FIFO mode data continues to fill the FIFO
beyond the trigger level, an overrun error will occur only after the FIFO is full and the
next character has been completely received in the shift register. OE is indicated to
the CPU as soon as it happens. The character in the shift register can be overwritten,
but it is not transferred to the FIFO.
1 = Set to a logic 1 during the character stop bit time when the overrun condition
exists.
0 = No overrun error (default).
Receiver Data Indicator
This bit is the receiver Data Ready (DR) indicator.
1 = Whenever a complete incoming character has been received and transferred into
the Receiver Buffer Register (RBR) or the FIFO. Bit 0 is reset by reading all of the
data in the RBR or the FIFO.
0 = No receive data available (default).
2
Rx Parity
Error
R
0
1
Rx Overrun
Error
R
0
0
Rx Data
Ready
R
0
N
www.national.com
21
相關PDF資料 |
PDF描述 |
|---|---|
| NS32203D | DIRECT MEMORY ACCESS CONTROLLER |
| NS32203N | DIRECT MEMORY ACCESS CONTROLLER |
| NS32382-10 | MEMORY MANAGEMENT UNITS |
| NS32382-15 | MEMORY MANAGEMENT UNITS |
| NS32490D | NIC Network Interface Controller(NIC網絡接口控制器) |
相關代理商/技術參數 |
參數描述 |
|---|---|
| NS16C2752TVA/NOPB | 功能描述:UART 接口集成電路 RoHS:否 制造商:Texas Instruments 通道數量:2 數據速率:3 Mbps 電源電壓-最大:3.6 V 電源電壓-最小:2.7 V 電源電流:20 mA 最大工作溫度:+ 85 C 最小工作溫度:- 40 C 封裝 / 箱體:LQFP-48 封裝:Reel |
| NS16C2752TVAX/NOPB | 功能描述:UART 接口集成電路 Dual UART w/ 64-byte FIFO RoHS:否 制造商:Texas Instruments 通道數量:2 數據速率:3 Mbps 電源電壓-最大:3.6 V 電源電壓-最小:2.7 V 電源電流:20 mA 最大工作溫度:+ 85 C 最小工作溫度:- 40 C 封裝 / 箱體:LQFP-48 封裝:Reel |
| NS16C2752TVS | 制造商:Texas Instruments 功能描述:UART 2-CH 64Byte FIFO 3.3V/5V 48-Pin TQFP |
| NS16C2752TVS/NOPB | 功能描述:UART 接口集成電路 RoHS:否 制造商:Texas Instruments 通道數量:2 數據速率:3 Mbps 電源電壓-最大:3.6 V 電源電壓-最小:2.7 V 電源電流:20 mA 最大工作溫度:+ 85 C 最小工作溫度:- 40 C 封裝 / 箱體:LQFP-48 封裝:Reel |
| NS16C2752TVSX/NOPB | 功能描述:UART 接口集成電路 Dual UART w/ 64-byte FIFO RoHS:否 制造商:Texas Instruments 通道數量:2 數據速率:3 Mbps 電源電壓-最大:3.6 V 電源電壓-最小:2.7 V 電源電流:20 mA 最大工作溫度:+ 85 C 最小工作溫度:- 40 C 封裝 / 箱體:LQFP-48 封裝:Reel |
發布緊急采購，3分鐘左右您將得到回復。