![](http://datasheet.mmic.net.cn/330000/MSM7662_datasheet_16442494/MSM7662_46.png)
Semiconductor
MSM7662
46/47
2) Application Circuit for FM-1 and FM-2 Modes
Select either 16-bit [YCbCr] or RGB output as the output interface.
Number of field memories utilized
16-bit [YCbCr]: Use 2 field memories.
RGB: Use 3 field memories.
Video input can be five composite inputs or two S-Video inputs.
Connect unused video input pins to AGND. If a composite signal is input, the C input side
(video amp, A/D converter, etc.) will be in the OFF operation state.
If the input is limited by the composite signal, connect VIN (5:6), VRT2, VRB2, AMPOUT2,
ADIN2, and CLPOUT2 pins to AGND. Externally attached components such as capacitors
may be removed.
Set the MODE[3:0] pins to the prescribed setting.
For the MF-1 mode setting, externally generate and supply control signals for the field
memory.
For the MF-2 mode setting, memory control signals from M[7:4] can be supplied to the field
memory.
For the MF-2 mode setting, the output timing for HSYNC_L, VSYNC_L, ODD, VVALID, and
HVALID becomes the memory read timing. Data output from memory is aligned with the
variout sync signal timings. (See page 24 and page 25)
Supply power and GND for analog, A/D, and digital circuits on the circuit board should be
separated at the power source wherever possible. Power and GND lines for analog and A/D
circuits must be wide and low impedance.
MSM7662
Video LSI
OSC
I
2
C
Controller
1
m
F
1
m
F
Video in
(C input)
SDA SCL RESET_L
VIN(1:4)
VRT1
AMPOUT
ADIN1
CLPOUT1
VRCL1
AV
DD
DAV
DD
DV
DD
Y(7:0)
C(7:0)
B(7:0)
HVALID
VVALID
ODD
HSYNC_L
VSYNC_L
CLKX2O
CLKX2
MODE[3:0]
DGND
DAGND
AGND
10
m
F
10
m
F
1
m
F
10
m
F
10
m
F
1
m
F
10 k
W
Video in
(Composite
Y input)
4.7 k
W
4.7 k
W
3.3 V or 5 V
1000 pF
47
m
F
1000 pF
47
m
F
1000 pF
47
m
F
VRB1
VIN(5:6)
VRT2
AMPOUT2
ADIN2
CLPOUT2
VRB2
Memory
control signal
M[7:4]
Field
mem-
ory
Field
mem-
ory
CLKXO
75
W
75
W