- 您現在的位置：買賣IC網 > PDF目錄4035 > MC8640DHX1067NE (Freescale Semiconductor)IC DUAL CORE PROCESSOR 1023-CBGA PDF資料下載
參數資料
| 型號： | MC8640DHX1067NE |
| 廠商： | Freescale Semiconductor |
| 文件頁數： | 39/130頁 |
| 文件大?。?/td> | 0K |
| 描述： | IC DUAL CORE PROCESSOR 1023-CBGA |
| 標準包裝： | 1 |
| 系列： | MPC86xx |
| 處理器類型： | 32-位 MPC86xx PowerPC |
| 速度： | 1.067GHz |
| 電壓： | 0.95V |
| 安裝類型： | 表面貼裝 |
| 封裝/外殼： | 1023-BCBGA，F(xiàn)CCBGA |
| 供應商設備封裝： | 1023-FCCBGA（33x33） |
| 包裝： | 托盤 |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁第30頁第31頁第32頁第33頁第34頁第35頁第36頁第37頁第38頁當前第39頁第40頁第41頁第42頁第43頁第44頁第45頁第46頁第47頁第48頁第49頁第50頁第51頁第52頁第53頁第54頁第55頁第56頁第57頁第58頁第59頁第60頁第61頁第62頁第63頁第64頁第65頁第66頁第67頁第68頁第69頁第70頁第71頁第72頁第73頁第74頁第75頁第76頁第77頁第78頁第79頁第80頁第81頁第82頁第83頁第84頁第85頁第86頁第87頁第88頁第89頁第90頁第91頁第92頁第93頁第94頁第95頁第96頁第97頁第98頁第99頁第100頁第101頁第102頁第103頁第104頁第105頁第106頁第107頁第108頁第109頁第110頁第111頁第112頁第113頁第114頁第115頁第116頁第117頁第118頁第119頁第120頁第121頁第122頁第123頁第124頁第125頁第126頁第127頁第128頁第129頁第130頁
MPC8640 and MPC8640D Integrated Host Processor Hardware Specifications, Rev. 3
16
Freescale Semiconductor
Input Clocks
4.1.1
SYSCLK and Spread Spectrum Sources
Spread spectrum clock sources are an increasingly popular way to control electromagnetic interference
emissions (EMI) by spreading the emitted noise to a wider spectrum and reducing the peak noise
magnitude in order to meet industry and government requirements. These clock sources intentionally add
long-term jitter to diffuse the EMI spectral content. The jitter specification given in Table 8 considers
short-term (cycle-to-cycle) jitter only and the clock generator’s cycle-to-cycle output jitter should meet the
MPC8640 input cycle-to-cycle jitter requirement. Frequency modulation and spread are separate concerns,
and the MPC8640 is compatible with spread spectrum sources if the recommendations listed in Table 9 are
observed.
It is imperative to note that the processor’s minimum and maximum SYSCLK, core, and VCO frequencies
must not be exceeded regardless of the type of clock source. Therefore, systems in which the processor is
operated at its maximum rated e600 core frequency should avoid violating the stated limits by using
down-spreading only.
SDn_REF_CLK and SDn_REF_CLK were designed to work with a spread spectrum clock (+0 to 0.5%
spreading at 30-33 kHz rate is allowed), assuming both ends have same reference clock. For better results,
use a source without significant unintended modulation.
SYSCLK duty cycle
tKHK/tSYSCLK
40
—
60
%
3
SYSCLK jitter
—
150
ps
4, 5
Notes:
1. Caution: The MPX clock to SYSCLK ratio and e600 core to MPX clock ratio settings must be chosen such that the resulting
SYSCLK frequency, e600 (core) frequency, and MPX clock frequency do not exceed their respective maximum or minimum
operating frequencies. Refer to Section 18.2, “MPX to SYSCLK PLL Ratio,” and Section 18.3, “e600 to MPX clock PLL
Ratio,” for ratio settings.
2. Rise and fall times for SYSCLK are measured at 0.4 V and 2.7 V.
3. Timing is guaranteed by design and characterization.
4. This represents the short term jitter only and is guaranteed by design.
5. The SYSCLK driver’s closed loop jitter bandwidth should be <500 kHz at –20 dB. The bandwidth must be set low to allow
cascade-connected PLL-based devices to track SYSCLK drivers with the specified jitter. Note that the frequency modulation
for SYSCLK reduces significantly for the spread spectrum source case. This is to guarantee what is supported based on
design.
Table 9. Spread Spectrum Clock Source Recommendations
At recommended operating conditions. See Table 2.
Parameter
Min
Max
Unit
Notes
Frequency modulation
—
50
kHz
1
Frequency spread
—
1.0
%
1, 2
Notes:
1. Guaranteed by design.
2. SYSCLK frequencies resulting from frequency spreading, and the resulting core and VCO frequencies, must meet the
minimum and maximum specifications given in Table 8.
Table 8. SYSCLK AC Timing Specifications (continued)
At recommended operating conditions (see Table 2) with OVDD = 3.3 V ± 165 mV.
Parameter
Symbol
Min
Typical
Max
Unit
Notes
相關PDF資料 |
PDF描述 |
|---|---|
| FMC35DRAS-S734 | CONN EDGECARD 70POS .100 R/A SLD |
| ABB108DHBN | CONN EDGECARD 216PS R/A .050 SLD |
| XC4028XL-2BG352I | IC FPGA I-TEMP 3.3V 2SPD 352MBGA |
| MC68040RC40V | IC MICROPROCESSOR 32BIT 182-PGA |
| ABB108DHBD | CONN EDGECARD 216PS R/A .050 SLD |
相關代理商/技術參數 |
參數描述 |
|---|---|
| MC8640DHX1250H | 制造商:FREESCALE 制造商全稱:Freescale Semiconductor, Inc 功能描述:Integrated Host Processor Hardware Specifications Addendum for the MC8640xTxxyyyyaC Series |
| MC8640DHX1250HC | 功能描述:微處理器 - MPU G8,REV2.1,1.05V,105C RoHS:否 制造商:Atmel 處理器系列:SAMA5D31 核心:ARM Cortex A5 數據總線寬度:32 bit 最大時鐘頻率:536 MHz 程序存儲器大小:32 KB 數據 RAM 大小:128 KB 接口類型:CAN, Ethernet, LIN, SPI,TWI, UART, USB 工作電源電壓:1.8 V to 3.3 V 最大工作溫度:+ 85 C 安裝風格:SMD/SMT 封裝 / 箱體:FBGA-324 |
| MC8640DHX1250HE | 功能描述:微處理器 - MPU G8 REV 3.0 1.05V 105C RoHS:否 制造商:Atmel 處理器系列:SAMA5D31 核心:ARM Cortex A5 數據總線寬度:32 bit 最大時鐘頻率:536 MHz 程序存儲器大小:32 KB 數據 RAM 大小:128 KB 接口類型:CAN, Ethernet, LIN, SPI,TWI, UART, USB 工作電源電壓:1.8 V to 3.3 V 最大工作溫度:+ 85 C 安裝風格:SMD/SMT 封裝 / 箱體:FBGA-324 |
| MC8640DHX1250N | 制造商:FREESCALE 制造商全稱:Freescale Semiconductor, Inc 功能描述:Integrated Host Processor Hardware Specifications Addendum for the MC8640xTxxyyyyaC Series |
| MC8640DTHX1000H | 制造商:FREESCALE 制造商全稱:Freescale Semiconductor, Inc 功能描述:Integrated Host Processor Hardware Specifications |
發布緊急采購，3分鐘左右您將得到回復。