參數資料
型號: MAX9877AERP+T
廠商: Maxim Integrated Products
文件頁數: 11/31頁
文件大小: 0K
描述: IC SUBSYSTEM MONO AUD 20MAXFILM
產品培訓模塊: Lead (SnPb) Finish for COTS
Obsolescence Mitigation Program
標準包裝: 2,500
系列: DirectDrive®
類型: D 類
輸出類型: 1-通道(單聲道),帶立體聲耳機
在某負載時最大輸出功率 x 通道數量: 825mW x 1 @ 4 歐姆; 53mW x 2 @ 16 歐姆
電源電壓: 2.7 V ~ 5.25 V
特點: 消除爆音,I²C,輸入多路復用器,短路和熱保護,關機,音量控制
安裝類型: 表面貼裝
供應商設備封裝: 20-UCSP
封裝/外殼: 20-WFBGA,CSPBGA
包裝: 帶卷 (TR)
MAX9877AERP
Low RF Susceptibility, Mono Audio
Subsystem with DirectDrive Headphone Amplifier
______________________________________________________________________________________
19
DirectDrive Headphone Amplifier
Traditional single-supply headphone amplifiers have
outputs biased at a nominal DC voltage (typically half
the supply). Large coupling capacitors are needed to
block this DC bias from the headphone. Without these
capacitors, a significant amount of DC current flows to
the headphone, resulting in unnecessary power dissi-
pation and possible damage to both the headphone
and headphone amplifier.
Maxim’s DirectDrive architecture uses a charge pump to
create an internal negative supply voltage. This allows
the headphone outputs of the MAX9877A to be biased
at GND while operating from a single supply (Figure 5).
Without a DC component, there is no need for the large
DC-blocking capacitors. Instead of two large (220F,
typ) capacitors, the MAX9877A charge pump requires
two small ceramic capacitors, conserving board space,
reducing cost, and improving the frequency response of
the headphone amplifier. See the Output Power vs.
Load Resistance graph in the
Typical Operating
Characteristics for details of the possible capacitor
sizes. There is a low DC voltage on the amplifier outputs
due to amplifier offset. However, the offset of the
MAX9877A is typically ±0.15mV, which, when combined
with a 32Ω load, results in less than 10A of DC current
flow to the headphones.
In addition to the cost and size disadvantages of the
DC-blocking capacitors required by conventional head-
phone amplifiers, these capacitors limit the amplifier’s
low-frequency response and can distort the audio sig-
nal. Previous attempts at eliminating the output-cou-
pling capacitors involved biasing the headphone return
(sleeve) to the DC bias voltage of the headphone
amplifiers. This method raises some issues:
FREQUENCY (MHz)
AMPLITUDE
(dB
μ
V/m)
160
140
120
100
80
60
10
15
20
25
30
35
40
TEST LIMIT
MAX9877A OUTPUT
TEST LIMIT
5
30
180
200
240
260
280
300
220
FREQUENCY (MHz)
AMPLITUDE
(dB
μ
V/m)
600
550
500
450
400
350
15
20
25
35
40
10
300
650
700
800
850
900
1000
950
750
Figure 4. EMI with 152mm of Speaker Cable
相關PDF資料
PDF描述
MAX9877EWP+TG45 IC AUDIO SUBSYSTEM 20-WLP
MAX9879ERV+T IC AUDIO SUBSYSTEM 30-UCSP
MAX987EUK-T IC COMP MICRPWR R-R I/O SOT23-5
MAX9888EWY+T IC CODEC AUDIO FLEXSOUND 63WLP
MAX9890AEBL+T IC SUPP CLICK-POP 9-UCSP
相關代理商/技術參數
參數描述
MAX9877AEWP+G45 制造商:Rochester Electronics LLC 功能描述: 制造商:Maxim Integrated Products 功能描述:
MAX9877AEWP+TG45 制造商:Rochester Electronics LLC 功能描述: 制造商:Maxim Integrated Products 功能描述:
MAX9877EBP+G45 制造商:Rochester Electronics LLC 功能描述: 制造商:Maxim Integrated Products 功能描述:
MAX9877EBP+TG45 制造商:Maxim Integrated Products 功能描述:
MAX9877ERP+ 制造商:Rochester Electronics LLC 功能描述: 制造商:Maxim Integrated Products 功能描述: