參數資料
型號: M37643F8FP
元件分類: 微控制器/微處理器
英文描述: 8-BIT, FLASH, 12 MHz, MICROCONTROLLER, PQFP80
封裝: 14 X 20 MM, 0.80 MM PITCH, PLASTIC, QFP-80
文件頁數: 42/120頁
文件大?。?/td> 1253K
代理商: M37643F8FP
28
7643 Group
SINGLE-CHIP 8-BIT CMOS MICROCOMPUTER
MITSUBISHI MICROCOMPUTERS
PRELIMINAR
Y
Notice:
This
is not
a final
specification.
Some
parametric
limits
are
subject
to
change.
Serial I/O Normal Operation
The serial I/O counter is set to “7” by writing operation to the serial
I/O shift register (address 002A16). When the SRDY Output Select
bit is “1”, the SRDY pin goes “L” after that writing. On the negative
edge of the transfer clock the SRDY pin returns “H” and the data
of the first bit is transmitted from the STXD pin. The remaining
data are done from the STXD pin bit by bit on each falling edge of
the transfer clock.
Additionally, the data is latched from the SRXD pin on each rising
edge of the transfer clock and then the contents of the serial I/O
shift register are shifted by one bit.
When the internal system clock is selected as the transfer clock,
the followings occur at counting eight transfer clocks:
The serial I/O counter reaches “0”
The transfer clock halts at “H”
The serial I/O interrupt request bit is set to “1”
The STXD pin goes a high-impedance state after an 8-bit transfer
is completed.
When the external clock is selected as the transfer clock, the fol-
lowings occur at counting eight transfer clocks:
The serial I/O counter reaches “0”
The serial I/O interrupt request bit is set to “1”
In this case, the transfer clock needs to be controlled by the exter-
nal source because the transfer clock does not halt. Additionally,
the STXD pin does not go a high-impedance state after an 8-bit
transfer is completed.
Figure 23 shows serial I/O timing.
Fig. 23 Serial I/O timing
D1
D0
D2
D3
D4
D5
D6
D7
First
Last
STXD/SRXD
Synchronizing clock
SCLK (CPoL = 1, CPha =1 )
SCLK (CPoL = 0, CPha = 1)
SCLK (CPoL = 1, CPha = 0)
SCLK (CPoL = 0, CPha = 0)
qNormal mode timing (LSB first)
Transfer clock
Synchronizing clock
Serial I/O shift
register write signal
SRDY signal
Serial I/O output STXD
Serial I/O input SRXD
(Note)
Interrupt request bit is set to “1”.
Note: When the internal clock is selected as the transfer clock, the STXD pin goes to a high-impedance state after transfer completion.
qSPI compatible mode timing
SRDY signal
相關PDF資料
PDF描述
M37643F8HP 8-BIT, FLASH, 12 MHz, MICROCONTROLLER, PQFP80
M37643M8-XXXHP 8-BIT, MROM, 12 MHz, MICROCONTROLLER, PQFP80
M37702S1LGP 16-BIT, 8 MHz, MICROCONTROLLER, PQFP80
M37702M2LXXXGP 16-BIT, MROM, 8 MHz, MICROCONTROLLER, PQFP80
M37702M2LXXXHP 16-BIT, MROM, 8 MHz, MICROCONTROLLER, PQFP80
相關代理商/技術參數
參數描述
M37643F8M8-XXXFP 制造商:RENESAS 制造商全稱:Renesas Technology Corp 功能描述:SINGLE-CHIP 8-BIT CMOS MICROCOMPUTER
M37643M8E8-XXXFP 制造商:RENESAS 制造商全稱:Renesas Technology Corp 功能描述:SINGLE-CHIP 8-BIT CMOS MICROCOMPUTER
M37643M8M8-XXXFP 制造商:RENESAS 制造商全稱:Renesas Technology Corp 功能描述:SINGLE-CHIP 8-BIT CMOS MICROCOMPUTER
M3764A-12 制造商:OK International 功能描述:
M3765 制造商:未知廠家 制造商全稱:未知廠家 功能描述:HORN/SIREN WITH SOFT CHIRP 6 ALARM SOUNDS