- 您現在的位置：買賣IC網 > PDF目錄98005 > M34571G6FP 4-BIT, MROM, 6 MHz, MICROCONTROLLER, PDSO24 PDF資料下載
參數資料
| 型號： | M34571G6FP |
| 元件分類： | 微控制器/微處理器 |
| 英文描述： | 4-BIT, MROM, 6 MHz, MICROCONTROLLER, PDSO24 |
| 封裝： | 5.30 X 10.10 MM, 0.80 MM PITCH, PLASTIC, SSOP-24 |
| 文件頁數： | 82/126頁 |
| 文件大小： | 1776K |
| 代理商： | M34571G6FP |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁第30頁第31頁第32頁第33頁第34頁第35頁第36頁第37頁第38頁第39頁第40頁第41頁第42頁第43頁第44頁第45頁第46頁第47頁第48頁第49頁第50頁第51頁第52頁第53頁第54頁第55頁第56頁第57頁第58頁第59頁第60頁第61頁第62頁第63頁第64頁第65頁第66頁第67頁第68頁第69頁第70頁第71頁第72頁第73頁第74頁第75頁第76頁第77頁第78頁第79頁第80頁第81頁當前第82頁第83頁第84頁第85頁第86頁第87頁第88頁第89頁第90頁第91頁第92頁第93頁第94頁第95頁第96頁第97頁第98頁第99頁第100頁第101頁第102頁第103頁第104頁第105頁第106頁第107頁第108頁第109頁第110頁第111頁第112頁第113頁第114頁第115頁第116頁第117頁第118頁第119頁第120頁第121頁第122頁第123頁第124頁第125頁第126頁
Rev.1.02
May 25, 2007
Page 59 of 124
REJ03B0179-0102
4571 Group
NOTES ON NOISE
Countermeasures against noise are described below.
The following countermeasures are effective against noise in
theory, however, it is necessary not only to take measures as
follows but to evaluate before actual use.
1. Shortest wiring length
(1) Wiring for RESET pin
Make the length of wiring which is connected to the RESET pin
as short as possible. Especially, connect a capacitor across the
RESET pin and the VSS pin with the shortest possible wiring.
<Reason>
In order to reset a microcomputer correctly, 1 machine cycle or
more of the width of a pulse input into the RESET pin is
required.
If noise having a shorter pulse width than this is input to the
RESET input pin, the reset is released before the internal state of
the microcomputer is completely initialized.
This may cause a program runaway.
Fig 62. Wiring for the RESET pin
(2) Wiring for clock input/output pins
Make the length of wiring which is connected to clock I/O pins
as short as possible.
Make the length of wiring across the grounding lead of a
capacitor which is connected to an oscillator and the VSS pin
of a microcomputer as short as possible.
Separate the VSS pattern only for oscillation from other VSS
patterns.
<Reason>
If noise enters clock I/O pins, clock waveforms may be deformed.
This may cause a program failure or program runaway. Also, if a
potential difference is caused by the noise between the VSS level
of a microcomputer and the VSS level of an oscillator, the correct
clock will not be input in the microcomputer.
Fig 63. Wiring for clock I/O pins
(3) Port K Wiring
Do not leave port K open. Always connect it to the VDD pin or
VSS pin using the thickest wire at the shortest distance.
When port K is used for key matrix, connect it to the VDD pin
through a pull-up resistor.
In that case too, place a pull-up resistor close to port K and
connect it to port K or the VDD pin using the thickest wire at the
shortest distance as above.
<Reason>
Port K is also used as the power source input pin (VPP pin) for
the built-in QzROM.
When programming to the QzROM, the impedance of port K is
low so that the electric writing current will flow into the
QzROM. This allows noise to enter easily. If noise enters from
port K, abnormal instruction codes or data are read from the
QzROM, which may cause a program runaway.
Fig 64.
Wiring for port K
RESET
Reset
circuit
Noise
VSS
N.G.
Reset
circuit
VSS
RESET
VSS
O.K.
Noise
XIN
XOUT
VSS
N.G.
XIN
XOUT
VSS
O.K.
VDD
VSS
K
Shortest
distance
(Note)
Note: This indicates pin.
VDD
VSS
K
Shortest
distance
(Note)
VDD
VSS
K
Shortest
distance
Shortest
distance
A pull-up resistor
(Note)
相關PDF資料 |
PDF描述 |
|---|---|
| M34584EDFP | 4-BIT, OTPROM, 6 MHz, MICROCONTROLLER, PDSO42 |
| M35047-XXXSP | 24 X 12 CHARACTERS CRT CHAR DSPL CTLR, PDIP20 |
| M35047-XXXFP | 24 X 12 CHARACTERS CRT CHAR DSPL CTLR, PDSO20 |
| M35048-001FP | 24 X 12 CHARACTERS CRT CHAR DSPL CTLR, PDSO20 |
| M35049-XXXFP | 24 X 12 CHARACTERS CRT CHAR DSPL CTLR, PDSO20 |
相關代理商/技術參數 |
參數描述 |
|---|---|
| M34571G6-XXXFP | 制造商:RENESAS 制造商全稱:Renesas Technology Corp 功能描述:SINGLE-CHIP 4-BIT CMOS MICROCOMPUTER |
| M34571GD | 制造商:RENESAS 制造商全稱:Renesas Technology Corp 功能描述:SINGLE-CHIP 4-BIT CMOS MICROCOMPUTER |
| M34571GDFP | 制造商:RENESAS 制造商全稱:Renesas Technology Corp 功能描述:SINGLE-CHIP 4-BIT CMOS MICROCOMPUTER |
| M34571GD-XXXFP | 制造商:RENESAS 制造商全稱:Renesas Technology Corp 功能描述:SINGLE-CHIP 4-BIT CMOS MICROCOMPUTER |
| M3458 | 功能描述:電纜固定件和配件 RLTCG 3/8 NPT BLACK NO NUT RoHS:否 制造商:Heyco 類型:Cable Grips, Liquid Tight 材料:Nylon 顏色:Black 安裝方法:Cable 最大光束直徑:11.4 mm 抗拉強度: |
發布緊急采購，3分鐘左右您將得到回復。