- 您現在的位置：買賣IC網 > PDF目錄69010 > M34509G4HFP 4-BIT, OTPROM, 6 MHz, MICROCONTROLLER, PDSO24 PDF資料下載
參數資料
| 型號： | M34509G4HFP |
| 元件分類： | 微控制器/微處理器 |
| 英文描述： | 4-BIT, OTPROM, 6 MHz, MICROCONTROLLER, PDSO24 |
| 封裝： | 5.30 X 10.10 MM, 0.80 MM PITCH, PLASTIC, SSOP-24 |
| 文件頁數： | 112/145頁 |
| 文件大小： | 1060K |
| 代理商： | M34509G4HFP |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁第30頁第31頁第32頁第33頁第34頁第35頁第36頁第37頁第38頁第39頁第40頁第41頁第42頁第43頁第44頁第45頁第46頁第47頁第48頁第49頁第50頁第51頁第52頁第53頁第54頁第55頁第56頁第57頁第58頁第59頁第60頁第61頁第62頁第63頁第64頁第65頁第66頁第67頁第68頁第69頁第70頁第71頁第72頁第73頁第74頁第75頁第76頁第77頁第78頁第79頁第80頁第81頁第82頁第83頁第84頁第85頁第86頁第87頁第88頁第89頁第90頁第91頁第92頁第93頁第94頁第95頁第96頁第97頁第98頁第99頁第100頁第101頁第102頁第103頁第104頁第105頁第106頁第107頁第108頁第109頁第110頁第111頁當前第112頁第113頁第114頁第115頁第116頁第117頁第118頁第119頁第120頁第121頁第122頁第123頁第124頁第125頁第126頁第127頁第128頁第129頁第130頁第131頁第132頁第133頁第134頁第135頁第136頁第137頁第138頁第139頁第140頁第141頁第142頁第143頁第144頁第145頁
4509 Group
Rev.1.03
2009.07.27
page 67 of 140
REJ03B0147-0103
NOTES ON NOISE
Countermeasures against noise are described below.
The following countermeasures are effective against noise in theory,
however, it is necessary not only to take measures as follows but to
evaluate before actual use.
1. Shortest wiring length
(1) Wiring for RESET pin
Make the length of wiring which is connected to the RESET pin as
short as possible. Especially, connect a capacitor across the
RESET pin and the VSS pin with the shortest possible wiring.
<Reason>
In order to reset a microcomputer correctly, 1 machine cycle or more
of the width of a pulse input into the RESET pin is required.
If noise having a shorter pulse width than this is input to the RESET
input pin, the reset is released before the internal state of the micro-
computer is completely initialized.
This may cause a program runaway.
Fig. 64 Wiring for the RESET pin
(2) Wiring for clock input/output pins
Make the length of wiring which is connected to clock I/O pins as
short as possible.
Make the length of wiring across the grounding lead of a capacitor
which is connected to an oscillator and the VSS pin of a microcom-
puter as short as possible.
Separate the VSS pattern only for oscillation from other VSS pat-
terns.
<Reason>
If noise enters clock I/O pins, clock waveforms may be deformed.
This may cause a program failure or program runaway. Also, if a po-
tential difference is caused by the noise between the VSS level of a
microcomputer and the VSS level of an oscillator, the correct clock
will not be input in the microcomputer.
RESET
Reset
circuit
Noise
VSS
Reset
circuit
VSS
RESET
VSS
N.G.
O.K.
Noise
XIN
XOUT
VSS
XIN
XOUT
VSS
N.G.
O.K.
(3) Wiring to CNVSS pin
Connect CNVSS pin to a GND pattern at the shortest distance.
The GND pattern is required to be as close as possible to the GND
supplied to VSS.
In order to improve the noise reduction, to connect a 5 k resistor
serially to the CNVSS pin - GND line may be valid.
As well as the above-mentioned, in this case, connect to a GND pat-
tern at the shortest distance. The GND pattern is required to be as
close as possible to the GND supplied to VSS.
<Reason>
The CNVSS pin of the QzROM is the power source input pin for the
built-in QzROM. When programming in the built-in QzROM, the im-
pedance of the CNVSS pin is low to allow the electric current for
writing flow into the QzROM. Because of this, noise can enter easily.
If noise enters the CNVSS pin, abnormal instruction codes or data
are read from the built-in QzROM, which may cause a program run-
away.
Fig. 66 Wiring for the CNVSS pin of the QzPROM
About 5k
VSS
The shortest
CNVSS
(Note)
Note: This indicates pin.
Fig. 65 Wiring for clock I/O pins
相關PDF資料 |
PDF描述 |
|---|---|
| M34509G4-XXXFP | 4-BIT, OTPROM, 6 MHz, MICROCONTROLLER, PDSO24 |
| M34509G4H-XXXFP | 4-BIT, OTPROM, 6 MHz, MICROCONTROLLER, PDSO24 |
| M34510M4A-XXXSP | 4-BIT, MROM, 6 MHz, MICROCONTROLLER, PDIP32 |
| M34510M2A-XXXFP | 4-BIT, MROM, 6 MHz, MICROCONTROLLER, PDSO36 |
| M34510E8-XXXFP | 4-BIT, OTPROM, 6 MHz, MICROCONTROLLER, PDSO36 |
相關代理商/技術參數 |
參數描述 |
|---|---|
| M34509G4H-XXXFP | 制造商:RENESAS 制造商全稱:Renesas Technology Corp 功能描述:SINGLE-CHIP 4-BIT CMOS MICROCOMPUTER |
| M34509G4-XXXFP | 制造商:RENESAS 制造商全稱:Renesas Technology Corp 功能描述:SINGLE-CHIP 4-BIT CMOS MICROCOMPUTER |
| M34509T2-CPE | 功能描述:DEV TOOL COMPACT EMULATOR: 4508/ RoHS:否 類別:編程器，開發系統 >> 內電路編程器、仿真器以及調試器 系列:- 產品變化通告:Development Systems Discontinuation 19/Jul/2010 標準包裝:1 系列:* 類型:* 適用于相關產品:* 所含物品:* |
| M34512M2 | 制造商:MITSUBISHI 制造商全稱:Mitsubishi Electric Semiconductor 功能描述:SINGLE-CHIP 4-BIT CMOS MICROCOMPUTER |
| M34512M2-XXXFP | 制造商:MITSUBISHI 制造商全稱:Mitsubishi Electric Semiconductor 功能描述:SINGLE-CHIP 4-BIT CMOS MICROCOMPUTER |
發布緊急采購，3分鐘左右您將得到回復。