參數資料
型號: LXT360PE
英文描述: PCM TRANSCEIVER|SINGLE|CEPT PCM-30/E-1|CMOS|LDCC|28PIN|PLASTIC
中文描述: 的PCM收發器|單|優稅PCM-30/E-1 |的CMOS | LDCC | 28腳|塑料
文件頁數: 11/52頁
文件大?。?/td> 1187K
代理商: LXT360PE
Integrated T1/E1 LH/SH Transceiver for DS1/DSX-1 or PRI Applications
LXT361
Datasheet
11
9
7
RD/DS
DI
Read.
On an Intel bus, driving RD Low commands a LXT361 register read
operation.
Data Strobe.
On a Motorola bus, DS goes Low when data is being driven
on the address/data bus. Data is valid on the rising edge of DS.
10
11
9
10
AD6
AD7
DI/O
Address/Data Bus 6 and 7.
Used with AD0 - AD5 to form the address/
data bus. Conforms to Intel and Motorola multiplexed address/data bus
specifications.
12
13
WR / R/W
DI
Write.
On an Intel bus, driving WR Low commands a LXT361 register write
operation.
Read/Write.
On a Motorola bus, driving R/W High commands a LXT361
register read operation; driving it Low commands a write operation.
13
16
15
19
TTIP
TRING
AO
Transmit Tip and Ring
. Differential driver output pair designed to drive a
50 - 200
load. The transformer and line matching resistors should be
selected to give the desired pulse height and return loss performance. See
Application Information
on page 32
.
14
16
TGND
-
Ground
return for the transmit driver power supply TVCC.
15
18
TVCC
-
+5 VDC Power Supply
for the transmit drivers. TVCC must not vary from
VCC by more than ± 0.3 V.
17
20
CS
DI
Chip Select.
During a read or write operation, CS must remain Low. See
Figure 16
and
Figure 17
for timing requirements.
In the case of a single processor controlling several chips, this line is used
to select a specific transceiver.
18
21
INT
DO
Interrupt.
INT goes Low to flag the host when LOS, AIS, NLOOP, QRSS,
DFMS or DFMO bits changes state, or when an elastic store overflow or
underflow occurs. To identify the specific interrupt, read the Performance
Status Register (PSR). To clear or mask an interrupt, write a one to the
appropriate bit in the Interrupt Clear Register (ICR). To re-enable the
interrupt, write a zero. INT is an
open drain output
that must be
connected to VCC through a pull-up resistor.
19
20
24
25
RTIP
RRING
AI
Receive Tip and Ring
. The Alternate Mark Inversion (AMI) signal received
from the line is applied at these pins. A 1:1 transformer is required. Data
and clock recovered from RTIP/RRING are output on the RPOS/RNEG (or
RDATA in
Unipolar mode
), and RCLK pins.
21
27
VCC
-
+5 VDC Power Supply
for all circuits except the transmit drivers. Transmit
drivers are supplied by TVCC.
Table 3. LXT361 Signal Descriptions (Continued)
Pin #
Symbol
I/O
1
Description
PLCC
QFP
1. DI = Digital Input; DO = Digital Output; DI/O = Digital Input/Output; AI = Analog Input; AO = Analog Output.
相關PDF資料
PDF描述
LXT384BE Telecomm/Datacomm
LXT384LE Telecomm/Datacomm
LXT386BE PCM TRANSCEIVER|QUAD|CEPT PCM-30/E-1|CMOS|BGA|160PIN|PLASTIC
LXT386LE PCM TRANSCEIVER|QUAD|CEPT PCM-30/E-1|CMOS|QFP|100PIN|PLASTIC
LXT388LE PCM TRANSCEIVER|DUAL|CEPT PCM-30/E-1|CMOS|QFP|100PIN|PLASTIC
相關代理商/技術參數
參數描述
LXT360QE 制造商:Intel 功能描述: 制造商:LEVEL ONE 功能描述:
LXT361 制造商:LVL1 制造商全稱:LVL1 功能描述:Integrated T1/E1 LH/SH Transceivers for DS1/DSX-1/CSU or NTU/ISDN PRI Applications
LXT361LE 制造商:LEVEL ONE 功能描述:361LE
LXT361PE 制造商:LEVEL 1 功能描述: 制造商:LEVEL ONE 功能描述: 制造商:Intel 功能描述:PCM TRANSCEIVER, Single, CEPT PCM-30/E-1, 28 Pin, Plastic, PLCC
LXT361QE 制造商:LEVEL ONE 功能描述: 制造商:LEVEL ONE 功能描述:DATACOM, PCM TRANSCEIVER, PQFP44