參數資料
型號： LTC4253ACGN#TRPBF
廠商： Linear Technology
文件頁數： 9/34頁
文件大?。?/td> 383K
描述： IC HOT SWAP CONTRLR -48V 16-SSOP
標準包裝： 2,500
類型： 熱交換控制器
應用： 通用
內部開關： 無
電源電壓： 8.2 V ~ 14.5 V
工作溫度： 0°C ~ 70°C
安裝類型： 表面貼裝
封裝/外殼： 16-SSOP（0.154"，3.90mm 寬）
供應商設備封裝： 16-SSOP
包裝： 帶卷 (TR)
LTC4253/LTC4253A
9
425353aff
For more information www.linear.com/4253
the start-up cycle, the SS capacitor (C
SS
) is ramped by a
22礎 (28礎 for the LTC4253A) current source. The GATE
pin is held low until SS exceeds 20 " V
OS
= 0.2V . SS is
internally shunted by a 100k R
SS
which limits the SS pin
voltage to 2.2V (50k resistor and 1.4V for the LTC4253A).
This corresponds to an analog current limit SENSE voltage
of 100mV (60mV for the LTC4253A). If the SS capacitor
is omitted, the SS pin ramps up in about 250祍 (140祍
for the LTC4253A). The SS pin is pulled low under any of
the following conditions: UVLO at V
IN
, UV , OV , during the
initial timing cycle, a circuit breaker fault time-out or the
RESET pin going high.
SENSE (Pin 7): Circuit Breaker/Current Limit Sense Pin. 
Load current is monitored by a sense resistor R
S
 connected
between
 
SENSE and V
EE
, and controlled in three steps. If
SENSE exceeds V
CB
 (50mV), the circuit breaker compara-
tor activates a (200礎???營
DRN
) TIMER pull-up current.
If SENSE exceeds V
ACL
, the analog current-limit amplifier
pulls GATE down to regulate the MOSFET current at V
ACL
/
R
S
. In the event of a catastrophic short-circuit, SENSE may
overshoot V
ACL
. If SENSE reaches V
FCL
 (200mV), the fast
current-limit comparator pulls GATE low with a strong
pull-down. To disable the circuit breaker and current limit
functions, connect SENSE
 
to V
EE
.
V
EE
 (Pin 8): Negative Supply Voltage Input. Connect this 
pin to the negative side of the power supply.
GATE (Pin 9): N-channel MOSFET Gate Drive Output. This 
pin is pulled high by a 50礎 current source. GATE is pulled
low by invalid conditions at V
IN
 (UVLO), UV , OV , during the
initial timing cycle, a circuit breaker fault time-out or the
RESET pin going high. GATE is actively servoed to control
the fault current as measured at SENSE. Compensation
capacitor, C
C
, at GATE stabilizes this loop. A comparator
monitors GATE to ensure that it is low before allowing an
initial timing cycle, then the GATE ramps up after an over-
voltage event or restart after a current limit fault. During
GATE start-up, a second comparator detects GATE within
2.8V of V
IN
 before PWRGD1 can be set and power good
sequencing starts.
DRAIN (Pin 10): Drain Sense Input. Connecting an external 
resistor, R
D
 between this pin and the MOSFETs drain (V
OUT
)
allows voltage sensing below 6.15V (5V for LTC4253A)
and current feedback to TIMER. A comparator detects if
DRAIN is below 2.39V and together with the GATE high
comparator, sets the PWRGD1 flag. If V
OUT
 is above V
DRNCL
,
the DRAIN pin is clamped at approximately V
DRNCL
. R
D
 
current is internally multiplied by 8 and added to TIMERs
200礎 during a circuit breaker fault cycle. This reduces
the fault time and MOSFET heating.
OV (Pin 11): Overvoltage Input. For the LTC4253, the 
threshold at the OV pin is set at 6.15V with 0.3V hys-
teresis. If OV > 6.15V , GATE pulls low. When OV returns
below 5.85V , GATE start-up begins without an initial timing
cycle. The LTC4253A OV threshold is set at 5.09V with
102mV hysteresis. If OV > 5.09V , GATE pulls low. When
OV returns below 4.988V , GATE start-up begins without an
initial timing cycle. If OV occurs in the middle of an initial
timing cycle, the initial timing cycle is restarted after OV
goes away. OV does not reset the latched fault or PWRGD1
flag. The internal UVLO at V
IN
 always overrides OV . A 1nF
to 10nF capacitor at OV prevents transients and switch-
ing noise from affecting the OV thresholds and prevents
glitches at the GATE.
UV (Pin 12): Undervoltage Input. For the LTC4253, the 
threshold at the UV pin is set at 3.225V with 0.3V hysteresis.
If UV < 2.925V , PWRGD1 pulls high, both GATE and TIMER
pull low. If UV rises above 3.225V , this initiates an initial
timing cycle followed by GATE start-up. The LTC4253A UV
threshold is set at 3.08V with 324mV hysteresis. If UV <
2.756V , PWRGD1 pulls high, both GATE and TIMER pull
low. If UV rises above 3.08V , this initiates an initial timing
cycle followed by GATE start-up. The internal UVLO at V
IN
 
always overrides UV . A low at UV resets an internal fault
latch. A 1nF to 10nF capacitor at UV prevents transients
and switching noise from affecting the UV thresholds and
prevents glitches at the GATE pin.
PIN FUNCTIONS
相關PDF資料
PDF描述
LTC4257CS8 IC CTRLR INTFACE PWR/ETHER 8SOIC
LTC4260IUH#PBF IC HOT SWAP CNTRL I2C 32-QFN
LTC4261IGN-2#PBF IC CTRLR HOTSWAP W/ADC 28-SSOP
LTC4263IS#TRPBF IC IEEE 803.2AF CNTRLR 14-SOIC
LTC4268IDKD-1#PBF IC PD HIGH POWER W/CNTRL 32-DFN
相關代理商/技術參數
參數描述
LTC4253ACUF-ADJ#PBF 制造商:Linear Technology 功能描述:Hot Swap Controller 1-CH 20-Pin QFN EP
LTC4253ACUF-ADJ#TRPBF 制造商:Linear Technology 功能描述:Hot Swap Controller 1-CH 20-Pin QFN EP T/R
LTC4253AIGN#PBF 功能描述:IC HOT SWAP CONTRLR -48V 16-SSOP RoHS:是 類別:集成電路 (IC) >> PMIC - 熱交換 系列:- 產品培訓模塊:Obsolescence Mitigation Program 標準包裝:100 系列:- 類型:熱插拔開關 應用:通用 內部開關:是 電流限制:可調 電源電壓:9 V ~ 13.2 V 工作溫度:-40°C ~ 150°C 安裝類型:表面貼裝 封裝/外殼:10-WFDFN 裸露焊盤 供應商設備封裝:10-TDFN-EP（3x3） 包裝:管件
LTC4253AIGN#TRPBF 功能描述:IC HOT SWAP CONTRLR -48V 16-SSOP RoHS:是 類別:集成電路 (IC) >> PMIC - 熱交換 系列:- 產品培訓模塊:Obsolescence Mitigation Program 標準包裝:100 系列:- 類型:熱插拔開關 應用:通用 內部開關:是 電流限制:可調 電源電壓:9 V ~ 13.2 V 工作溫度:-40°C ~ 150°C 安裝類型:表面貼裝 封裝/外殼:10-WFDFN 裸露焊盤 供應商設備封裝:10-TDFN-EP（3x3） 包裝:管件
LTC4253AIGN-ADJ 制造商:LINER 制造商全稱:Linear Technology 功能描述:-48V Hot Swap Controller with Sequencer
發布緊急采購，3分鐘左右您將得到回復。

采購需求

(若只采購一條型號，填寫一行即可)

發布成功！您可以繼續發布采購。也可以進入我的后臺，查看報價

發布成功！您可以繼續發布采購。也可以進入我的后臺，查看報價

*型號 *數量 廠商 批號 封裝
添加更多采購

我的聯系方式

*
*
*