參數資料
型號： IBMN612804GT3B
廠商： IBM Microeletronics
英文描述： 128Mb Double Data Rate Synchronous DRAM(128M位高速CMOS同步動態RAM（采用雙數據速率結構）)
中文描述： 128Mb的雙數據速率同步DRAM（128兆位高速的CMOS同步動態隨機存儲器（采用雙數據速率結構））
文件頁數： 9/79頁
文件大?。?/td> 1324K
代理商： IBMN612804GT3B
IBMN612404GT3B
IBMN612804GT3B
Preliminary
128Mb Double Data Rate Synchronous DRAM
06K0566.F39350B
1/01
IBM Corporation. All rights reserved.
Use is further subject to the provisions at the end of this document.
Page 9 of 79
Register Definition
Mode Register
The Mode Register is used to define the specific mode of operation of the DDR SDRAM. This definition
includes the selection of a burst length, a burst type, a CAS latency, and an operating mode. The Mode Reg-
ister is programmed via the Mode Register Set command (with BA0 = 0 and BA1 = 0) and retains the stored
information until it is programmed again or the device loses power (except for bit A8, which is self-clearing).
Mode Register bits A0-A2 specify the burst length, A3 specifies the type of burst (sequential or interleaved),
A4-A6 specify the CAS latency, and A7-A11 specify the operating mode.
The Mode Register must be loaded when all banks are idle, and the controller must wait the specified time
before initiating the subsequent operation. Violating either of these requirements results in unspecified opera-
tion.
Burst Length
Read and write accesses to the DDR SDRAM are burst oriented, with the burst length being programmable.
The burst length determines the maximum number of column locations that can be accessed for a given
Read or Write command. Burst lengths of 2, 4, or 8 locations are available for both the sequential and the
interleaved burst types.
Reserved states should not be used, as unknown operation or incompatibility with future versions may result.
When a Read or Write command is issued, a block of columns equal to the burst length is effectively
selected. All accesses for that burst take place within this block, meaning that the burst wraps within the block
if a boundary is reached. The block is uniquely selected by A1-Ai when the burst length is set to two, by A
2
-Ai
when the burst length is set to four and by A
3
-Ai when the burst length is set to eight (where Ai is the most
significant column address bit for a given configuration). The remaining (least significant) address bit(s) is
(are) used to select the starting location within the block. The programmed burst length applies to both Read
and Write bursts.
相關PDF資料
PDF描述
IBMN625404GT3B 256Mb Double Data Rate Synchronous DRAM(256M位雙數據速率同步動態RAM)
IBMN625804GT3B 256Mb Double Data Rate Synchronous DRAM(256M位雙數據速率同步動態RAM)
ICM7321 SINGLE 12/10/8-BIT VOLTAGE-OUTPUT DACS
ICM7321M SINGLE 12/10/8-BIT VOLTAGE-OUTPUT DACS
ICM7321MG SINGLE 12/10/8-BIT VOLTAGE-OUTPUT DACS
相關代理商/技術參數
參數描述
IBMPPC403GAJC33C1 制造商:IBM 功能描述:
IBMPPC750CLGEQ4023 制造商:IBM 功能描述:MPU 750CL RISC 32BIT 90NM 400MHZ 1.15V/1.8V 278FCBGA - Trays
IBMPPC750CLGEQ5023 制造商:IBM Microelectronics 功能描述:MPU 750CL RISC 32BIT 90NM 500MHZ 1.15V/1.8V 278FCBGA - Trays
IBMPPC750CLGEQA033 制造商:IBM 功能描述:MPU 750CL RISC 32BIT 90NM 1GHZ 1.15V/1.8V 278FCBGA - Trays 制造商:IBM 功能描述:IBMIBMPPC750CLGEQA033 CPU PPC 750CL 1GHZ
IBN100 制造商:Hubbell Wiring Device-Kellems 功能描述:ICON, BLANK,BR,100PK
發布緊急采購，3分鐘左右您將得到回復。

采購需求

(若只采購一條型號，填寫一行即可)

發布成功！您可以繼續發布采購。也可以進入我的后臺，查看報價

發布成功！您可以繼續發布采購。也可以進入我的后臺，查看報價

*型號 *數量 廠商 批號 封裝
添加更多采購

我的聯系方式

*
*
*