- 您現在的位置：買賣IC網 > PDF目錄173638 > GS8662R09BGD-400I (GSI TECHNOLOGY) 8M X 9 STANDARD SRAM, 0.45 ns, PBGA165 PDF資料下載
參數資料
| 型號： | GS8662R09BGD-400I |
| 廠商： | GSI TECHNOLOGY |
| 元件分類： | SRAM |
| 英文描述： | 8M X 9 STANDARD SRAM, 0.45 ns, PBGA165 |
| 封裝： | 13 X 15 MM, 1 MM PITCH, ROHS COMPLIANT, FPBGA-165 |
| 文件頁數： | 35/37頁 |
| 文件大小： | 769K |
| 代理商： | GS8662R09BGD-400I |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁第30頁第31頁第32頁第33頁第34頁當前第35頁第36頁第37頁
GS8662R08/09/18/36BD-400/350/333/300/250
Specifications cited are subject to change without notice. For latest documentation see http://www.gsitechnology.com.
Rev: 1.02 3/2011
7/37
2011, GSI Technology
Background
Common I/O SRAMs, from a system architecture point of view, are attractive in read dominated or block transfer applications.
Therefore, the SigmaDDR-II SRAM interface and truth table are optimized for burst reads and writes. Common I/O SRAMs are
unpopular in applications where alternating reads and writes are needed because bus turnaround delays can cut high speed
Common I/O SRAM data bandwidth in half.
Burst Operations
Read and write operations are “burst” operations. In every case where a read or write command is accepted by the SRAM, it will
respond by issuing or accepting four beats of data, executing a data transfer on subsequent rising edges of K and K#, as illustrated
in the timing diagrams. It is not possible to stop a burst once it starts. Four beats of data are always transferred. This means that it is
possible to load new addresses every other K clock cycle. Addresses can be loaded less often, if intervening deselect cycles are
inserted.
Deselect Cycles
Chip Deselect commands are pipelined to the same degree as read commands. This means that if a deselect command is applied to
the SRAM on the next cycle after a read command captured by the SRAM, the device will complete the four beat read data transfer
and then execute the deselect command, returning the output drivers to high-Z.A high on the LD# pin prevents the RAM from
loading read or write command inputs and puts the RAM into deselect mode as soon as it completes all outstanding burst transfer
operations.
SigmaDDR-II B4 SRAM Read Cycles
The status of the Address, LD and R/W pins are evaluated on the rising edge of K. Because the device executes a four beat burst
transfer in response to a read command, if the previous command captured was a read or write command, the Address, LD and R/
W pins are ignored. If the previous command captured was a deselect, the control pin status is checked.The SRAM executes
pipelined reads. The read command is clocked into the SRAM by a rising edge of K. After the next rising edge of K, the SRAM
produces data out in response to the next rising edge of C (or the next rising edge of K, if C and C are tied high). The second beat
of data is transferred on the next rising edge of C, then on the next rising edge of C and finally on the next rising edge of C, for a
total of four transfers per address load.
SigmaDDR-II B4 SRAM Write Cycles
The status of the Address, LD and R/W pins are evaluated on the rising edge of K. Because the device executes a four beat burst
transfer in response to a write command, if the previous command captured was a read or write command, the Address, LD and R/
W pins are ignored at the next rising edge of K. If the previous command captured was a deselect, the control pin status is
checked.The SRAM executes “l(fā)ate write” data transfers. Data in is due at the device inputs on the rising edge of K following the
rising edge of K clock used to clock in the write command and the write address. To complete the remaining three beats of the burst
of four write transfer the SRAM captures data in on the next rising edge of K, the following rising edge of K and finally on the next
rising edge of K, for a total of four transfers per address load.
相關PDF資料 |
PDF描述 |
|---|---|
| GS88037BT-225I | 256K X 36 CACHE SRAM, 2.5 ns, PQFP100 |
| GS880F36BGT-7.5T | 256K X 36 CACHE SRAM, 7.5 ns, PQFP100 |
| GS880V18BT-250T | 512K X 18 CACHE SRAM, 5.5 ns, PQFP100 |
| GS880Z32CGT-250 | 256K X 32 ZBT SRAM, 5.5 ns, PQFP100 |
| GS88118AGT-150I | 512K X 18 CACHE SRAM, 7.5 ns, PQFP100 |
相關代理商/技術參數 |
參數描述 |
|---|---|
| GS8662R09E-167 | 制造商:GSI 制造商全稱:GSI Technology 功能描述:72Mb SigmaCIO DDR-II Burst of 4 SRAM |
| GS8662R09E-167I | 制造商:GSI 制造商全稱:GSI Technology 功能描述:72Mb SigmaCIO DDR-II Burst of 4 SRAM |
| GS8662R09E-200 | 制造商:GSI 制造商全稱:GSI Technology 功能描述:72Mb SigmaCIO DDR-II Burst of 4 SRAM |
| GS8662R09E-200I | 制造商:GSI 制造商全稱:GSI Technology 功能描述:72Mb SigmaCIO DDR-II Burst of 4 SRAM |
| GS8662R09E-250 | 制造商:GSI 制造商全稱:GSI Technology 功能描述:72Mb SigmaCIO DDR-II Burst of 4 SRAM |
發布緊急采購，3分鐘左右您將得到回復。