- 您現在的位置：買賣IC網 > PDF目錄371754 > FX579 Half Duplex GMSK Modem PDF資料下載
參數資料
| 型號： | FX579 |
| 英文描述： | Half Duplex GMSK Modem |
| 中文描述： | 半雙工GMSK調制解調器 |
| 文件頁數： | 14/23頁 |
| 文件大?。?/td> | 582K |
| 代理商： | FX579 |
Half Duplex GMSK Modem
FX579
1996 Consumer Microcircuits Limited
14
D/579/4
ACQUIRE Pin
"0" to "1"
"1"
"0"
Rx Level Measurement Mode
Clamp
Lossy Peak Detect
Peak Averaging
PLL Mode
Narrow
→
Wide Bandwidth
Wide Bandwidth
Narrow Bandwidth
Rx Level Measurement Clamp:
Operates for a minimum of two bit times, maximum three bit
times, after a "0" to "1" transition of the ACQUIRE input. The external DOC capacitors are
rapidly charged towards the input signal level, with the charge time constant being of the order
of 0.5 bit time.
Rx Level Measurement Lossy Peak Detect:
The detectors rapidly capture the +ve and -ve
going signal peaks of the Rx filter output signal, these peaks being stored on the external DOC
capacitors. The detectors operate in this mode whenever ACQUIRE is at a logic "1", except for
the initial Clamp period.
Rx Level Measurement Peak Averaging:
Provides a slower but more accurate measurement
of the signal peak amplitudes. This operating mode depends on the PLL circuitry being in lock.
PLL Wide Bandwidth:
Sets the PLL bandwidth wide enough to allow a lock to the received
signal in 8 zero crossings. This mode will operate as long as ACQUIRE is at logic "1".
PLL Narrow Bandwidth:
The correction applied to the extracted clock is limited to a maximum
of ± 1/16th bit period for every 4 zero crossings received. The PLL operates in this mode
whenever the ACQUIRE input is set to logic "0".
Table 3 Receive Operating Modes
Rx Data Formats
The receive section of the FX579 works best with data which has a reasonably 'random' structure, i.e.
the data should contain approximately the same number of 'ones' as 'zeroes' with no long sequences
(> 100 bits) of consecutive 'ones' or 'zeroes'. Also, long sequences (>100 bits) of patterns without "11"
and "00" should be avoided.
For this reason, it is recommended that data is scrambled in some manner before transmission, for
example by 'exclusive-ORing' with the output of a binary pseudorandom pattern generator.
Where data is transmitted in bursts, each burst should be preceded by a preamble designed to allow
the receive modem to establish timing and level lock as quickly as possible. This preamble should be
at least 16 bits long, and should preferably consist of alternating pairs of "1"s and "0"s i.e.
"110011001100...." A "10101010...." preamble sequence will yield poor peak levels for the receive
circuits, although performance is better with BT = 0.5 than with BT = 0.3.
相關PDF資料 |
PDF描述 |
|---|---|
| FX601A | Monostable Multivibrator |
| FX601R | Analog IC |
| FX601 | Ultrahigh-Speed Switching Applications |
| FX6A-20S-0.8SV | 0.8mm Pitch Stacking Height 5 to 9mm Connector |
| FX6-100S-0.8SV | 0.8mm Pitch Stacking Height 5 to 9mm Connector |
相關代理商/技術參數 |
參數描述 |
|---|---|
| FX579D4 | 制造商:CMLMICRO 制造商全稱:CML Microcircuits 功能描述:HALF DUPLEX GMSK MODEM |
| FX5800-TD | 制造商:Micro-Star International 功能描述:GF FX 5800 128MB 8X AGP - Bulk |
| FX5-80P-SH | 功能描述:CONN HEADER 80POS 1MM R/A GOLD RoHS:否 類別:連接器，互連式 >> 板對板 - 陣列，邊緣類型，包廂 系列:FX5 標準包裝:3,000 系列:SlimStack™ 502396 連接器類型:插頭，外罩觸點 位置數:100 間距:0.016"（0.40mm） 行數:2 安裝類型:表面貼裝 特點:固定焊尾 觸點表面涂層:金 觸點涂層厚度:8µin（0.20µm） 包裝:帶卷 (TR) 配接層疊高度:2.5mm 板上方高度:0.084"（2.13mm） 其它名稱:502396-1010 |
| FX5-80P-SH(71) | 功能描述:板對板與夾層連接器 HDR 80P 1MM R/A GOLD RoHS:否 制造商:JAE Electronics 系列:WP3 產品類型:Receptacles 節距:0.4 mm 疊放高度:1 mm 安裝角: 位置/觸點數量:50 排數:2 外殼材料:Plastic 觸點材料:Copper Alloy 觸點電鍍:Gold 電壓額定值:50 V 電流額定值:0.4 A |
| FX5-80P-SH(72) | 功能描述:板對板與夾層連接器 80P R/A SMT HEADER LOC BOSS GLD PLT RoHS:否 制造商:JAE Electronics 系列:WP3 產品類型:Receptacles 節距:0.4 mm 疊放高度:1 mm 安裝角: 位置/觸點數量:50 排數:2 外殼材料:Plastic 觸點材料:Copper Alloy 觸點電鍍:Gold 電壓額定值:50 V 電流額定值:0.4 A |
發布緊急采購，3分鐘左右您將得到回復。