參數資料
型號: EP7212
廠商: Cirrus Logic, Inc.
英文描述: HIGH-PERFORMANCE, LOW-POWER SYSTEM-ON-CHIP WITH LCD CONTROLLER AND DIGITAL AUDIO INTERFACE(DAI)
中文描述: 高性能,低功耗系統與LCD控制器和數字音頻接口(DAI芯片)
文件頁數: 25/136頁
文件大小: 2289K
代理商: EP7212
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁當前第25頁第26頁第27頁第28頁第29頁第30頁第31頁第32頁第33頁第34頁第35頁第36頁第37頁第38頁第39頁第40頁第41頁第42頁第43頁第44頁第45頁第46頁第47頁第48頁第49頁第50頁第51頁第52頁第53頁第54頁第55頁第56頁第57頁第58頁第59頁第60頁第61頁第62頁第63頁第64頁第65頁第66頁第67頁第68頁第69頁第70頁第71頁第72頁第73頁第74頁第75頁第76頁第77頁第78頁第79頁第80頁第81頁第82頁第83頁第84頁第85頁第86頁第87頁第88頁第89頁第90頁第91頁第92頁第93頁第94頁第95頁第96頁第97頁第98頁第99頁第100頁第101頁第102頁第103頁第104頁第105頁第106頁第107頁第108頁第109頁第110頁第111頁第112頁第113頁第114頁第115頁第116頁第117頁第118頁第119頁第120頁第121頁第122頁第123頁第124頁第125頁第126頁第127頁第128頁第129頁第130頁第131頁第132頁第133頁第134頁第135頁第136頁
EP7212
DS474PP1
25
faces. In addition, when in the Standby State, the
LCD controller and PWM drive are also disabled.
When operating from an external 13 MHz oscilla-
tor which has become disabled in the Standby State
by using the CLKEN (SYSCON, bit 13) signal
(i.e., with CLKENSL = 0), the oscillator must be
stable within 0.125 sec from the rising edge of the
CLKEN signal.
3.5
There are two clocking modes for the EP7212. Ei-
ther an external clock input can be used or the on-
chip PLL. The clock source is selected by a strap-
ping option on Port E, pin 2 (PE[2]). If PE[2] is
high at the rising edge of nPOR (i.e., upon power-
up), the external clock mode is selected. If PE[2] is
low, then the on-chip PLL mode is selected. After
power-up, PE[2] can be used as a GPIO.
Clocks
The EP7212 device contains several separate sec-
tions of logic, each clocked according to its own
clock frequency requirements. When the EP7212 is
in external clock mode, the actual frequencies at
the peripherals will be different than when in PLL
mode. See each peripheral device section for more
details. The section below describes the clocking
for both the ARM720T and address/data bus.
3.5.1
On-Chip PLL
The ARM720T clock can be programmed to
18.432 MHz, 36.864 MHz, 49.152 MHz, or
73.728 MHz with the PLL running at twice the
highest
possible
CPU
(147.456 MHz). The PLL uses an external
3.6864 MHz crystal. By chip default, the on-chip
PLL is used and configured such that the
ARM720T and address/data buses run at
18.432 MHz.
clock
frequency
When the clock frequency is selected to be
36 MHz, both the ARM720T and the address/data
buses are clocked at 36 MHz. When the clock fre-
quency is selected higher than 36 MHz, only the
ARM720T gets clocked at this higher speed. The
address/data will be fixed at 36 MHz. The clock
frequency used is selected by programming the
CLKCTL[1:0] bits in the SYSCON3 register. The
clock frequency selection does not effect the EPB
(external peripheral bus). Therefore, all the periph-
eral clocks are fixed, regardless of the clock speed
selected for the ARM720T.
NOTE:
After modifying the CLKCTL[1:0] bits, the
next instruction should always be a ‘NOP’.
3.5.1.1
Characteristics of the PLL Interface
When connecting a crystal to the on-chip PLL in-
terface pins (i.e. MOSCIN and MOSCOUT), the
crystal and circuit should conform to the following
requirements:
The 3.6864 MHz frequency should be created
by the crystals fundamental tone (i.e., it should
be a fundamental mode crystal).
A start-up resistor is not necessary, since one is
provided internally.
Start-up loading capacitors may be placed on
each side of the external crystal and ground.
Their value should be in the range of 10 pF.
However, their values should be selected based
upon the crystal specifications. The total sum of
the capacitance of the traces between the
EP7212’s clock pins, the capacitors, and the
crystal leads should be subtracted from the
crystal’s specifications when determining the
values for the loading capacitors.
The crystal should have a maximum 100 ppm
frequency drift over the chip’s operating tem-
perature range.
Alternatively, a digital clock source can be used to
drive the MOSCIN pin of the EP7212. With this
approach, the voltage levels of the clock source
should match that of the V
DD
supply for the
EP7212’s pads (i.e. the supply voltage level used to
drive all of the non-V
DD
core pins on the EP7212).
相關PDF資料
PDF描述
EP7212-CB-A HIGH-PERFORMANCE, LOW-POWER SYSTEM-ON-CHIP WITH LCD CONTROLLER AND DIGITAL AUDIO INTERFACE(DAI)
EP7212-CV-A HIGH-PERFORMANCE, LOW-POWER SYSTEM-ON-CHIP WITH LCD CONTROLLER AND DIGITAL AUDIO INTERFACE(DAI)
EP7309 HIGH PERFORMANCE LOW POWER SYSTEM ON CHIP ENHANCED DIGITAL AUDIO INTERFACE
EP7309-CB-C CONN MODULAR JACK 8-8 R/A UNSHLD
EP7309-CR-C HIGH PERFORMANCE LOW POWER SYSTEM ON CHIP ENHANCED DIGITAL AUDIO INTERFACE
相關代理商/技術參數
參數描述
EP7212-CB-A 制造商:CIRRUS 制造商全稱:Cirrus Logic 功能描述:HIGH-PERFORMANCE, LOW-POWER SYSTEM-ON-CHIP WITH LCD CONTROLLER AND DIGITAL AUDIO INTERFACE(DAI)
EP7212-CV-A 制造商:CIRRUS 制造商全稱:Cirrus Logic 功能描述:HIGH-PERFORMANCE, LOW-POWER SYSTEM-ON-CHIP WITH LCD CONTROLLER AND DIGITAL AUDIO INTERFACE(DAI)
EP7212-CV-D 制造商:Rochester Electronics LLC 功能描述:- Bulk
EP7230 功能描述:電氣外殼配件 E-PANEL FITS 72 X 30 RoHS:否 制造商:Hammond Manufacturing 產品:Rack Accessories 類型: 面板寬度: 面板高度: 外部寬度: 外部高度: 外部深度: 顏色:Black
EP7236 功能描述:電氣外殼配件 E-PANEL FITS 72 X 36 RoHS:否 制造商:Hammond Manufacturing 產品:Rack Accessories 類型: 面板寬度: 面板高度: 外部寬度: 外部高度: 外部深度: 顏色:Black