- 您現在的位置：買賣IC網 > PDF目錄8526 > EL5625ILZ-T13 (Intersil)IC BUFFER 18XGAMMA PROG 38-QFN PDF資料下載
參數資料
| 型號： | EL5625ILZ-T13 |
| 廠商： | Intersil |
| 文件頁數： | 3/12頁 |
| 文件大?。?/td> | 0K |
| 描述： | IC BUFFER 18XGAMMA PROG 38-QFN |
| 標準包裝： | 2,500 |
| 應用： | TFT-LCD 面板：伽瑪緩沖器，VCOM 驅動器 |
| 輸出類型： | 滿擺幅 |
| 電路數： | 18 |
| 電流 - 電源： | 11mA |
| 電流 - 輸出 / 通道： | 130mA |
| 電壓 - 電源，單路/雙路(±)： | 7 V ~ 16 V |
| 安裝類型： | 表面貼裝 |
| 封裝/外殼： | 38-VFQFN 裸露焊盤 |
| 供應商設備封裝： | 38-QFN（5x7）裸露焊盤 |
| 包裝： | 帶卷 (TR) |
11
All Intersil U.S. products are manufactured, assembled and tested utilizing ISO9000 quality systems.
Intersil Corporation’s quality certifications can be viewed at www.intersil.com/design/quality
Intersil products are sold by description only. Intersil Corporation reserves the right to make changes in circuit design, software and/or specifications at any time without
notice. Accordingly, the reader is cautioned to verify that data sheets are current before placing orders. Information furnished by Intersil is believed to be accurate and
reliable. However, no responsibility is assumed by Intersil or its subsidiaries for its use; nor for any infringements of patents or other rights of third parties which may result
from its use. No license is granted by implication or otherwise under any patent or patent rights of Intersil or its subsidiaries.
For information regarding Intersil Corporation and its products, see www.intersil.com
FN7488.1
February 20, 2008
At the falling edge of the OSC, output 1 is being refreshed
and one clock cycle later, output 2 is being refreshed. The
spike you see here is the response of the output amplifier
when the refreshed switches are closed. When driving a big
capacitor load, there will be ringing at the spikes because
the phase margin of the amplifier is decreased.
The speed of the external OSC signal shouldn’t be greater
than 70kHz because for the worst condition, it will take at
least 4s to charge the sample and hold capacitor CH. The
pulse width has to be at least 4s long. From our lab test, the
duty cycle of the OSC signal must be greater than 30%.
POWER DISSIPATION
With the 100mA maximum continues output drive capability
for VCOM channel, it is possible to exceed the 125°C
absolute maximum junction temperature. Therefore, it is
important to calculate the maximum junction temperature for
the application to determine if load conditions need to be
modified for the part to remain in the safe operation.
The maximum power dissipation allowed in a package is
determined according to:
where:
TJMAX = Maximum junction temperature
TAMAX = Maximum ambient temperature
θJA = Thermal resistance of the package
PDMAX = Maximum power dissipation in the package
The maximum power dissipation actually produced by the IC
is the total quiescent supply current times the total power
supply voltage and plus the power in the IC due to the loads.
when sourcing, and:
when sinking.
Where:
i = 18
VS = Supply voltage
IS = Quiescent current
VOUTi = Output voltage of the i channel
ILOADi = Load current of the i channel
By setting the two PDMAX equations equal to each other, we
can solve for the RLOADs to avoid the device overheat. The
package power dissipation curves provide a convenient way
to see if the device will overheat.
THERMAL SHUTDOWN
The EL5625 has an internal thermal shutdown circuitry that
prevents overheating of the part. When the junction
temperature goes up to about 150°C, the part will be
disabled. When the junction temperature drops down to
about 120°C, the part will be enabled. With this feature, any
short circuit at the outputs will enable the thermal shutdown
circuitry to disable the part.
POWER SUPPLY BYPASSING AND PRINTED CIRCUIT
BOARD LAYOUT
Good printed circuit board layout is necessary for optimum
performance. A low impedance and clean analog ground
plane should be used for the EL5625. The traces from the
two ground pins to the ground plane must be very short. The
thermal pad of the EL5625 should be connected to the
analog ground plane. Lead length should be as short as
possible and all power supply pins must be well bypassed. A
0.1F ceramic capacitor must be place very close to the VS,
VREFH, VREFL, and CAP pins. A 4.7F local bypass
tantalum capacitor should be placed to the VS, VREFH, and
VREFL pins.
P
DMAX
T
JMAX - TAMAX
Θ
JA
---------------------------------------------
=
P
DMAX
V
S
I
S
Σ V
S
(
- V
OUTi )
I
LOADi
×
[]
+
×
=
P
DMAX
V
S
I
S
Σ V
OUTiILOADi
×
()
+
×
=
EL5625
相關PDF資料 |
PDF描述 |
|---|---|
| 5-1877847-1 | PLUG 7POS 0 DEG BLK/GRN 2.7-3.9 |
| 4-1877847-5 | PLUG 7POS 0 DEG GRY/YEL 2.7-3.9 |
| ISL59442IBZ-T7 | IC AMP MULTIPLEX 1GHZ 14SOIC |
| 3-1877847-9 | PLUG 7POS 0 DEG BLK/YEL 2.7-3.9 |
| 3-1877847-3 | PLUG 7POS 0 DEG GRY/WH 2.7-3.9 |
相關代理商/技術參數 |
參數描述 |
|---|---|
| EL5724 | 制造商:INTERSIL 制造商全稱:Intersil Corporation 功能描述:Integrated Buffers with VCOM |
| EL5724IRE | 功能描述:IC INTEGRATED BUFFER 24-HTSSOP RoHS:否 類別:集成電路 (IC) >> 線性 - 放大器 - 視頻放大器和頻緩沖器 系列:- 標準包裝:1,000 系列:- 應用:驅動器 輸出類型:差分 電路數:3 -3db帶寬:350MHz 轉換速率:1000 V/µs 電流 - 電源:14.5mA 電流 - 輸出 / 通道:60mA 電壓 - 電源，單路/雙路(±):5 V ~ 12 V，±2.5 V ~ 6 V 安裝類型:表面貼裝 封裝/外殼:20-VFQFN 裸露焊盤 供應商設備封裝:20-QFN 裸露焊盤（4x4） 包裝:帶卷 (TR) |
| EL5724IRE-T13 | 功能描述:IC BUFFER 8XGAMMA 8.3MA 24HTSSOP RoHS:否 類別:集成電路 (IC) >> 線性 - 放大器 - 視頻放大器和頻緩沖器 系列:- 產品培訓模塊:Lead (SnPb) Finish for COTS Obsolescence Mitigation Program 標準包裝:50 系列:- 應用:TFT-LCD 面板：VCOM 驅動器 輸出類型:滿擺幅 電路數:1 -3db帶寬:35MHz 轉換速率:40 V/µs 電流 - 電源:3.7mA 電流 - 輸出 / 通道:1.3A 電壓 - 電源，單路/雙路(±):9 V ~ 20 V，±4.5 V ~ 10 V 安裝類型:表面貼裝 封裝/外殼:8-TSSOP，8-MSOP（0.118"，3.00mm 寬）裸露焊盤 供應商設備封裝:8-uMax-EP 包裝:管件 |
| EL5724IRE-T7 | 功能描述:IC BUFFER 8XGAMMA 8.3MA 24HTSSOP RoHS:否 類別:集成電路 (IC) >> 線性 - 放大器 - 視頻放大器和頻緩沖器 系列:- 產品培訓模塊:Lead (SnPb) Finish for COTS Obsolescence Mitigation Program 標準包裝:50 系列:- 應用:TFT-LCD 面板：VCOM 驅動器 輸出類型:滿擺幅 電路數:1 -3db帶寬:35MHz 轉換速率:40 V/µs 電流 - 電源:3.7mA 電流 - 輸出 / 通道:1.3A 電壓 - 電源，單路/雙路(±):9 V ~ 20 V，±4.5 V ~ 10 V 安裝類型:表面貼裝 封裝/外殼:8-TSSOP，8-MSOP（0.118"，3.00mm 寬）裸露焊盤 供應商設備封裝:8-uMax-EP 包裝:管件 |
| EL5724IREZ | 功能描述:運算放大器 - 運放 EL5724IREZ 8 CH GAMM A BUFRS W/VCOM RoHS:否 制造商:STMicroelectronics 通道數量:4 共模抑制比（最小值）:63 dB 輸入補償電壓:1 mV 輸入偏流（最大值）:10 pA 工作電源電壓:2.7 V to 5.5 V 安裝風格:SMD/SMT 封裝 / 箱體:QFN-16 轉換速度:0.89 V/us 關閉:No 輸出電流:55 mA 最大工作溫度:+ 125 C 封裝:Reel |
發布緊急采購，3分鐘左右您將得到回復。