VCOM Amplifier
參數資料
型號: EL5625ILZ-T13
廠商: Intersil
文件頁數: 11/12頁
文件大?。?/td> 0K
描述: IC BUFFER 18XGAMMA PROG 38-QFN
標準包裝: 2,500
應用: TFT-LCD 面板:伽瑪緩沖器,VCOM 驅動器
輸出類型: 滿擺幅
電路數: 18
電流 - 電源: 11mA
電流 - 輸出 / 通道: 130mA
電壓 - 電源,單路/雙路(±): 7 V ~ 16 V
安裝類型: 表面貼裝
封裝/外殼: 38-VFQFN 裸露焊盤
供應商設備封裝: 38-QFN(5x7)裸露焊盤
包裝: 帶卷 (TR)
8
FN7488.1
February 20, 2008
Serial Timing Diagram
VCOM Amplifier
The VCOM amplifier is designed to control the voltage on the
back plate of an LCD display. This plate is capacitively
coupled to the pixel drive voltage which alternately cycles
positive and negative at the line rates for the display. Thus
the amplifier must be capable of sourcing and sinking
capacitive pulse of current, which can be quite large (100mA
for typical applications).
Analog Section
TRANSFER FUNCTION
The transfer function is:
where data is the decimal value of the 11-bit data binary
input code.
The output voltages from the EL5625 will be derived from
the reference voltages present at the VREFL and VREFH
pins. The impedance between those two pins is about 32k
Ω.
Care should be taken that the system design holds these two
reference voltages within the limits of the power rails of the
EL5625. GND < VREFH ≤ VS and GND ≤ VREFL ≤ VREFH.
CLOCK OSCILLATOR
The EL5625 requires an internal clock or external clock to
refresh its outputs. The outputs are refreshed at the falling OSC
clock edges. The output refreshed switches open at the rising
edges of the OSC clock. The driving load shouldn’t be changed
at the rising edges of the OSC clock. Otherwise, it will generate
a voltage error at the outputs. This clock may be input or output
via the clock pin labelled EXT_OSC. The internal clock is
provided by an internal oscillator running at approximately
21kHz and can be output to the EXT_OSC pin. In a 2 chip
system, if the driving loads are stable, one chip may be
programmed to use the internal oscillator; then the OSC pin will
output the clock from the internal oscillator. The second chip
may have the OSC pin connected to this clock source.
For transient load application, the external clock mode
should be used to ensure all functions are synchronized
together. The positive edge of the external clock to the OSC
pin should be timed to avoid the transient load effect. The
Application Drawing shows the LCD H rate signal used, here
the positive clock edge is timed to avoid the transient load of
the column driver circuits.
TABLE 2. SERIAL TIMING PARAMETERS
PARAMETER
RECOMMENDED OPERATING RANGE
DESCRIPTION
T
≥200ns
Clock Period
tr/tf
0.05 * T
Clock Rise/Fall Time
tHE
≥10ns
ENA Hold Time
tSE
≥10ns
ENA Setup Time
tHD
≥10ns
Data Hold Time
tSD
≥10ns
Data Setup Time
tW
0.50 * T
Clock Pulse Width
B15
B14
B13
B12-B2
B1
B0
ENA
SCLK
SDI
MSB
LSB
t
tHE
tSE
tSD
tHD
Ttr
tw
tHE
tSE
LOAD MSB FIRST, LSB LAST
tf
V
OUT IDEAL
)
(
V
REFL
=
data
2048
-------------
V
REFH - VREFL
()
×
+
EL5625
相關PDF資料
PDF描述
5-1877847-1 PLUG 7POS 0 DEG BLK/GRN 2.7-3.9
4-1877847-5 PLUG 7POS 0 DEG GRY/YEL 2.7-3.9
ISL59442IBZ-T7 IC AMP MULTIPLEX 1GHZ 14SOIC
3-1877847-9 PLUG 7POS 0 DEG BLK/YEL 2.7-3.9
3-1877847-3 PLUG 7POS 0 DEG GRY/WH 2.7-3.9
相關代理商/技術參數
參數描述
EL5724 制造商:INTERSIL 制造商全稱:Intersil Corporation 功能描述:Integrated Buffers with VCOM
EL5724IRE 功能描述:IC INTEGRATED BUFFER 24-HTSSOP RoHS:否 類別:集成電路 (IC) >> 線性 - 放大器 - 視頻放大器和頻緩沖器 系列:- 標準包裝:1,000 系列:- 應用:驅動器 輸出類型:差分 電路數:3 -3db帶寬:350MHz 轉換速率:1000 V/µs 電流 - 電源:14.5mA 電流 - 輸出 / 通道:60mA 電壓 - 電源,單路/雙路(±):5 V ~ 12 V,±2.5 V ~ 6 V 安裝類型:表面貼裝 封裝/外殼:20-VFQFN 裸露焊盤 供應商設備封裝:20-QFN 裸露焊盤(4x4) 包裝:帶卷 (TR)
EL5724IRE-T13 功能描述:IC BUFFER 8XGAMMA 8.3MA 24HTSSOP RoHS:否 類別:集成電路 (IC) >> 線性 - 放大器 - 視頻放大器和頻緩沖器 系列:- 產品培訓模塊:Lead (SnPb) Finish for COTS Obsolescence Mitigation Program 標準包裝:50 系列:- 應用:TFT-LCD 面板:VCOM 驅動器 輸出類型:滿擺幅 電路數:1 -3db帶寬:35MHz 轉換速率:40 V/µs 電流 - 電源:3.7mA 電流 - 輸出 / 通道:1.3A 電壓 - 電源,單路/雙路(±):9 V ~ 20 V,±4.5 V ~ 10 V 安裝類型:表面貼裝 封裝/外殼:8-TSSOP,8-MSOP(0.118",3.00mm 寬)裸露焊盤 供應商設備封裝:8-uMax-EP 包裝:管件
EL5724IRE-T7 功能描述:IC BUFFER 8XGAMMA 8.3MA 24HTSSOP RoHS:否 類別:集成電路 (IC) >> 線性 - 放大器 - 視頻放大器和頻緩沖器 系列:- 產品培訓模塊:Lead (SnPb) Finish for COTS Obsolescence Mitigation Program 標準包裝:50 系列:- 應用:TFT-LCD 面板:VCOM 驅動器 輸出類型:滿擺幅 電路數:1 -3db帶寬:35MHz 轉換速率:40 V/µs 電流 - 電源:3.7mA 電流 - 輸出 / 通道:1.3A 電壓 - 電源,單路/雙路(±):9 V ~ 20 V,±4.5 V ~ 10 V 安裝類型:表面貼裝 封裝/外殼:8-TSSOP,8-MSOP(0.118",3.00mm 寬)裸露焊盤 供應商設備封裝:8-uMax-EP 包裝:管件
EL5724IREZ 功能描述:運算放大器 - 運放 EL5724IREZ 8 CH GAMM A BUFRS W/VCOM RoHS:否 制造商:STMicroelectronics 通道數量:4 共模抑制比(最小值):63 dB 輸入補償電壓:1 mV 輸入偏流(最大值):10 pA 工作電源電壓:2.7 V to 5.5 V 安裝風格:SMD/SMT 封裝 / 箱體:QFN-16 轉換速度:0.89 V/us 關閉:No 輸出電流:55 mA 最大工作溫度:+ 125 C 封裝:Reel