- 您現在的位置：買賣IC網 > PDF目錄8526 > EL5625ILZ-T13 (Intersil)IC BUFFER 18XGAMMA PROG 38-QFN PDF資料下載
參數資料
| 型號： | EL5625ILZ-T13 |
| 廠商： | Intersil |
| 文件頁數： | 2/12頁 |
| 文件大?。?/td> | 0K |
| 描述： | IC BUFFER 18XGAMMA PROG 38-QFN |
| 標準包裝： | 2,500 |
| 應用： | TFT-LCD 面板：伽瑪緩沖器，VCOM 驅動器 |
| 輸出類型： | 滿擺幅 |
| 電路數： | 18 |
| 電流 - 電源： | 11mA |
| 電流 - 輸出 / 通道： | 130mA |
| 電壓 - 電源，單路/雙路(±)： | 7 V ~ 16 V |
| 安裝類型： | 表面貼裝 |
| 封裝/外殼： | 38-VFQFN 裸露焊盤 |
| 供應商設備封裝： | 38-QFN（5x7）裸露焊盤 |
| 包裝： | 帶卷 (TR) |
10
FN7488.1
February 20, 2008
CHANNEL OUTPUTS
Each of the channel outputs has a rail-to-rail buffer. This
enables all channels to have the capability to drive to within
50mV of the power rails, (see Electrical Characteristics for
details).
When driving large capacitive loads, a series resistor should
be placed in series with the output (Usually between 5
Ω and
50
Ω).
Each of the channels is updated on a continuous cycle, the
time for the new data to appear at a specific output will
depend on the exact timing relationship of the incoming data
to this cycle.
The best-case scenario is when the data has just been
captured and then passed on to the output stage
immediately; this can be as short as 48s. In the worst-case
scenario, this will be 860s for EL5625, when the data has
just missed the cycle at f_OSC = 21kHz.
When a large change in output voltage is required, the
change will occur in 2V steps, thus the requisite number of
timing cycles will be added to the overall update time. This
means that a large change of 16V can take between 6.8ms
and 7.2ms depending on the absolute timing relative to the
update cycle.
Output Stage and the Use of External
Oscillator
Simplified output sample and hold amp stage for one
channel.
The output voltage is generated from the DAC, which is VIN
in the above circuit. The refreshed switches are controlled by
the internal or external oscillator signal. When the OSC clock
signal is low, switches S1 and S2 are closed. The output
VOUT = VIN and at the same time the sample and hold cap
CH is being charged. When the OSC clock signal is high, the
refreshed switches S1 and S2 are opened and the output
voltage is maintained by CH. This refreshed process will
repeat every 18 clock cycles for each channel. The time
takes to update the output depends on the timing at the VIN
and the state of the switches. It can take 1 to 19 clock cycles
to update each output.
For the sample and hold capacitor CH to maintain the
correct output voltage, the driving load shouldn’t be changed
at the rising edge of the OSC signal. Since at the rising edge
of the OSC clock, the refreshed switches are being opened,
if the load changes at that time, it will generate an error
output voltage. For a fixed load condition, the internal
oscillator can be used.
For the transient load condition, the external OSC mode
should be used to avoid the conflict between the rising edge
of the OSC signal and the changing load. So a timing delay
circuit will be needed to delay the OSC signal and avoid the
rising edge of the OSC signal and changing the load at the
same time.
TRANSIENT LOAD RESPONSE
Channel 3 --- sinking and sourcing 5mA current
Channel 2 --- EXT_OSC signal
Channel 1 --- VOUT
Here, the OSC signal is synchronized to the load signal. The
rising edge of the OSC signal is then delayed by some
amount of time and gives enough time for CH to be charged
to a new voltage before the switches are opened.
CHANNEL TO CHANNEL REFRESH
Ch1 --- Output1
Ch3 --- Output2
Ch2 --- EXT_OSC
-
+
VOUT
1.3V
FIGURE 8.
S1
-
+
VIN
S2
-
+
CH
OSC
1.3V
FIGURE 9.
FIGURE 10.
EL5625
相關PDF資料 |
PDF描述 |
|---|---|
| 5-1877847-1 | PLUG 7POS 0 DEG BLK/GRN 2.7-3.9 |
| 4-1877847-5 | PLUG 7POS 0 DEG GRY/YEL 2.7-3.9 |
| ISL59442IBZ-T7 | IC AMP MULTIPLEX 1GHZ 14SOIC |
| 3-1877847-9 | PLUG 7POS 0 DEG BLK/YEL 2.7-3.9 |
| 3-1877847-3 | PLUG 7POS 0 DEG GRY/WH 2.7-3.9 |
相關代理商/技術參數 |
參數描述 |
|---|---|
| EL5724 | 制造商:INTERSIL 制造商全稱:Intersil Corporation 功能描述:Integrated Buffers with VCOM |
| EL5724IRE | 功能描述:IC INTEGRATED BUFFER 24-HTSSOP RoHS:否 類別:集成電路 (IC) >> 線性 - 放大器 - 視頻放大器和頻緩沖器 系列:- 標準包裝:1,000 系列:- 應用:驅動器 輸出類型:差分 電路數:3 -3db帶寬:350MHz 轉換速率:1000 V/µs 電流 - 電源:14.5mA 電流 - 輸出 / 通道:60mA 電壓 - 電源，單路/雙路(±):5 V ~ 12 V，±2.5 V ~ 6 V 安裝類型:表面貼裝 封裝/外殼:20-VFQFN 裸露焊盤 供應商設備封裝:20-QFN 裸露焊盤（4x4） 包裝:帶卷 (TR) |
| EL5724IRE-T13 | 功能描述:IC BUFFER 8XGAMMA 8.3MA 24HTSSOP RoHS:否 類別:集成電路 (IC) >> 線性 - 放大器 - 視頻放大器和頻緩沖器 系列:- 產品培訓模塊:Lead (SnPb) Finish for COTS Obsolescence Mitigation Program 標準包裝:50 系列:- 應用:TFT-LCD 面板：VCOM 驅動器 輸出類型:滿擺幅 電路數:1 -3db帶寬:35MHz 轉換速率:40 V/µs 電流 - 電源:3.7mA 電流 - 輸出 / 通道:1.3A 電壓 - 電源，單路/雙路(±):9 V ~ 20 V，±4.5 V ~ 10 V 安裝類型:表面貼裝 封裝/外殼:8-TSSOP，8-MSOP（0.118"，3.00mm 寬）裸露焊盤 供應商設備封裝:8-uMax-EP 包裝:管件 |
| EL5724IRE-T7 | 功能描述:IC BUFFER 8XGAMMA 8.3MA 24HTSSOP RoHS:否 類別:集成電路 (IC) >> 線性 - 放大器 - 視頻放大器和頻緩沖器 系列:- 產品培訓模塊:Lead (SnPb) Finish for COTS Obsolescence Mitigation Program 標準包裝:50 系列:- 應用:TFT-LCD 面板：VCOM 驅動器 輸出類型:滿擺幅 電路數:1 -3db帶寬:35MHz 轉換速率:40 V/µs 電流 - 電源:3.7mA 電流 - 輸出 / 通道:1.3A 電壓 - 電源，單路/雙路(±):9 V ~ 20 V，±4.5 V ~ 10 V 安裝類型:表面貼裝 封裝/外殼:8-TSSOP，8-MSOP（0.118"，3.00mm 寬）裸露焊盤 供應商設備封裝:8-uMax-EP 包裝:管件 |
| EL5724IREZ | 功能描述:運算放大器 - 運放 EL5724IREZ 8 CH GAMM A BUFRS W/VCOM RoHS:否 制造商:STMicroelectronics 通道數量:4 共模抑制比（最小值）:63 dB 輸入補償電壓:1 mV 輸入偏流（最大值）:10 pA 工作電源電壓:2.7 V to 5.5 V 安裝風格:SMD/SMT 封裝 / 箱體:QFN-16 轉換速度:0.89 V/us 關閉:No 輸出電流:55 mA 最大工作溫度:+ 125 C 封裝:Reel |
發布緊急采購，3分鐘左右您將得到回復。