- 您現在的位置：買賣IC網 > PDF目錄379182 > DS2151Q T1 Single-Chip Transceiver PDF資料下載
參數資料
| 型號： | DS2151Q |
| 英文描述： | T1 Single-Chip Transceiver |
| 中文描述： | T1單芯片收發器 |
| 文件頁數： | 13/51頁 |
| 文件大?。?/td> | 1100K |
| 代理商： | DS2151Q |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁當前第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁第30頁第31頁第32頁第33頁第34頁第35頁第36頁第37頁第38頁第39頁第40頁第41頁第42頁第43頁第44頁第45頁第46頁第47頁第48頁第49頁第50頁第51頁
DS2151Q
13 of 51
(with any BPVs that might have occurred intact) via the TTIP and TRING pins. Data will continue to
pass through the receive side of the DS2151Q as it would normally and the data at the TSER input will be
ignored. Data in this loopback will pass through the jitter attenuator. RLB is used to place the DS2151Q
into “l(fā)ine” loopback which is a requirement of both ANSI T1.403 and AT&T TR62411. Please see the
DS2151Q Block Diagram in Section 1 for more details.
PAYLOAD LOOPBACK
When CCR1.1 is set to a 1, the DS2151Q will be forced into Payload LoopBack (PLB). Normally, this
loopback is only enabled when ESF framing is being performed. In a PLB situation, the DS2151Q will
loop the 192 bits of payload data (with BPVs corrected) from the receive section back to the transmit
section. The FPS framing pattern, CRC6 calculation, and the FDL bits are not looped back, they are
reinserted by the DS2151Q. When PLB is enabled, the following will occur:
1.
Data will be transmitted from the TTIP and TRING pins synchronous with RCLK instead of TCLK.
2.
All of the receive side signals will continue to operate normally.
3.
The TCHCLK and TCHBLK signals are forced low.
4.
Data at the TSER pin is ignored.
5.
The TLCLK signal will become synchronous with RCLK instead of TCLK.
FRAMER LOOPBACK
When CCR1.0 is set to a 1, the DS2151Q will enter a Framer LoopBack (FLB) mode. This loopback is
useful in testing and debugging applications. In FLB, the DS2151Q will loop data from the transmit side
back to the receive side. When FLB is enabled, the following will occur:
1.
Unless the RLB is active, an unframed all 1s code will be transmitted at TTIP and TRING.
2.
Data off the T1 line at RTIP and RRING will be ignored.
3.
The RCLK output will be replaced with the TCLK input.
相關PDF資料 |
PDF描述 |
|---|---|
| DS2151 | T1 Single-Chip Transceiver |
| DS2154L | Enhanced E1 Single Chip Transceiver |
| DS2154LN | Enhanced E1 Single Chip Transceiver |
| DS2154 | WSD 151 SOLDERING STATION 230V UKWSD 151 SOLDERING STATION 230V UK; Frequency, supply max:60Hz; Frequency, supply min:50Hz; Height:101mm; Length:166mm; Power, input:150W; Temperature range:50(degree C) - 550(degree C); Voltage, |
| DS2155 | T1/E1/J1 Single-Chip Transceiver TDM/UTOPIA II Interface |
相關代理商/技術參數 |
參數描述 |
|---|---|
| DS2151Q/T&R | 制造商:Maxim Integrated Products 功能描述:IC TXRX T1 1-CHIP 5V LP 44-PLCC |
| DS2151Q/T&R | 功能描述:IC TXRX T1 1-CHIP 5V LP 44-PLCC RoHS:否 類別:集成電路 (IC) >> 接口 - 電信 系列:- 產品培訓模塊:Lead (SnPb) Finish for COTS 產品變化通告:Product Discontinuation 06/Feb/2012 標準包裝:750 系列:* |
| DS2151QB | 功能描述:網絡控制器與處理器 IC RoHS:否 制造商:Micrel 產品:Controller Area Network (CAN) 收發器數量: 數據速率: 電源電流（最大值）:595 mA 最大工作溫度:+ 85 C 安裝風格:SMD/SMT 封裝 / 箱體:PBGA-400 封裝:Tray |
| DS2151QB/T&R | 制造商:Maxim Integrated Products 功能描述:T1 SINGLE CHIP XCVR REV B T&R - Tape and Reel |
| DS2151QB/T&R+ | 制造商:Maxim Integrated Products 功能描述:FRAMER DS1/E1/ISDN-PRI/T1 5V 44PLCC - Tape and Reel |
發布緊急采購，3分鐘左右您將得到回復。