- 您現在的位置：買賣IC網 > PDF目錄295174 > BXM80526B650256 (INTEL CORP) 64-BIT, 650 MHz, MICROPROCESSOR, CPGA495 PDF資料下載
參數資料
| 型號： | BXM80526B650256 |
| 廠商： | INTEL CORP |
| 元件分類： | 微控制器/微處理器 |
| 英文描述： | 64-BIT, 650 MHz, MICROPROCESSOR, CPGA495 |
| 封裝： | MICRO PGA-495 |
| 文件頁數： | 7/84頁 |
| 文件大小： | 450K |
| 代理商： | BXM80526B650256 |
第1頁第2頁第3頁第4頁第5頁第6頁當前第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁第30頁第31頁第32頁第33頁第34頁第35頁第36頁第37頁第38頁第39頁第40頁第41頁第42頁第43頁第44頁第45頁第46頁第47頁第48頁第49頁第50頁第51頁第52頁第53頁第54頁第55頁第56頁第57頁第58頁第59頁第60頁第61頁第62頁第63頁第64頁第65頁第66頁第67頁第68頁第69頁第70頁第71頁第72頁第73頁第74頁第75頁第76頁第77頁第78頁第79頁第80頁第81頁第82頁第83頁第84頁
Mobile Pentium III Processor in BGA2 and Micro-PGA2 Packages Datasheet
Intel Corporation
7
2.2
Power Management
2.2.1
Clock Control Architecture
The mobile Pentium III processor clock control architecture (Figure 3) has been optimized for
leading edge deep green desktop and mobile computer designs. The clock control architecture
consists of seven different clock states: Normal, Stop Grant, Auto Halt, Quick Start, HALT/Grant
Snoop, Sleep, and Deep Sleep states. The Auto Halt state provides a low-power clock state that
can be controlled through the software execution of the HLT instruction. The Quick Start state
provides a very low power and low exit latency clock state that can be used for hardware
controlled “idle” computer states. The Deep Sleep state provides an extremely low-power state
that can be used for “Power-On-Suspend” computer states, which is an alternative to shutting off
the processor’s power. Compared to the Pentium processor exit latency of 1 msec, the exit latency
of the Deep Sleep state has been reduced to 30
sec in the mobile PentiumIII processor. The Stop
Grant and Sleep states shown in Figure 3 are intended for use in “Deep Green” desktop and server
systems — not in mobile systems. Performing state transitions not shown in Figure 3 is neither
recommended nor supported.
The Stop Grant and Quick Start clock states are mutually exclusive, i.e., a strapping option on
signal A15# chooses which state is entered when the STPCLK# signal is asserted. The Quick Start
state is enabled by strapping the A15# signal to ground at Reset; otherwise, asserting the
STPCLK# signal puts the processor into the Stop Grant state. The Stop Grant state has a higher
power level than the Quick Start state and is designed for Symmetric Multi-Processing (SMP)
platforms. The Quick Start state has a much lower power level, but it can only be used in
uniprocessor platforms. Table 3 provides clock state characteristics, which are described in detail
in the following sections.
2.2.2
Normal State
The Normal state of the processor is the normal operating mode where the processor’s core clock
is running and the processor is actively executing instructions.
2.2.3
Auto Halt State
This is a low-power mode entered by the processor through the execution of the HLT instruction.
The power level of this mode is similar to the Stop Grant state. A transition to the Normal state is
made by a halt break event (one of the following signals going active: NMI, INTR, BINIT#,
INIT#, RESET#, FLUSH#, or SMI#).
Asserting the STPCLK# signal while in the Auto Halt state will cause the processor to transition
to the Stop Grant or Quick Start state, where a Stop Grant Acknowledge bus cycle will be issued.
Deasserting STPCLK# will cause the processor to return to the Auto Halt state without issuing a
new Halt bus cycle.
The SMI# interrupt is recognized in the Auto Halt state. The return from the System Management
Interrupt (SMI) handler can be to either the Normal state or the Auto Halt state. See the Intel
Architecture Software Developer’s Manual, Volume III: System Programmer’s Guide for more
information. No Halt bus cycle is issued when returning to the Auto Halt state from the System
Management Mode (SMM).
The FLUSH# signal is serviced in the Auto Halt state. After the on-chip and off-chip caches have
been flushed, the processor will return to the Auto Halt state without issuing a Halt bus cycle.
相關PDF資料 |
PDF描述 |
|---|---|
| BXM80526B450256 | 64-BIT, 450 MHz, MICROPROCESSOR, CPGA495 |
| BXM80526B500256 | 64-BIT, 500 MHz, MICROPROCESSOR, CPGA495 |
| BXM80526B600256 | 64-BIT, 600 MHz, MICROPROCESSOR, CPGA495 |
| BY8400 | Fast high-voltage soft-recovery rectifiers |
| BY8404 | Fast high-voltage soft-recovery rectifiers |
相關代理商/技術參數 |
參數描述 |
|---|---|
| BXM80536NC1400ES L7LS | 制造商:Intel 功能描述:CELERON M,360,1.40GHZ,1M CACHE, 400MHZ FSB,1.26V,UFCPGA - Boxed Product (Development Kits) |
| BXMP1000 | 制造商:SPECTRUM 制造商全稱:Spectrum Microwave, Inc. 功能描述:RF AMPLIFIER |
| BXMP1001 | 制造商:SPECTRUM 制造商全稱:Spectrum Microwave, Inc. 功能描述:RF AMPLIFIER |
| BXMP1002 | 制造商:SPECTRUM 制造商全稱:Spectrum Microwave, Inc. 功能描述:RF AMPLIFIER |
| BXMP1003 | 制造商:SPECTRUM 制造商全稱:Spectrum Microwave, Inc. 功能描述:RF AMPLIFIER |
發布緊急采購，3分鐘左右您將得到回復。