- 您現在的位置：買賣IC網 > PDF目錄366550 > AM79C975 (Advanced Micro Devices, Inc.) PCnet⑩-FAST III Single-Chip 10/100 Mbps PCI Ethernet Controller with Integrated PHY PDF資料下載
參數資料
| 型號： | AM79C975 |
| 廠商： | Advanced Micro Devices, Inc. |
| 英文描述： | PCnet⑩-FAST III Single-Chip 10/100 Mbps PCI Ethernet Controller with Integrated PHY |
| 中文描述： | PCnet⑩快速三單芯片10/100 Mbps的PCI以太網控制器集成PHY |
| 文件頁數： | 269/304頁 |
| 文件大小： | 2092K |
| 代理商： | AM79C975 |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁第30頁第31頁第32頁第33頁第34頁第35頁第36頁第37頁第38頁第39頁第40頁第41頁第42頁第43頁第44頁第45頁第46頁第47頁第48頁第49頁第50頁第51頁第52頁第53頁第54頁第55頁第56頁第57頁第58頁第59頁第60頁第61頁第62頁第63頁第64頁第65頁第66頁第67頁第68頁第69頁第70頁第71頁第72頁第73頁第74頁第75頁第76頁第77頁第78頁第79頁第80頁第81頁第82頁第83頁第84頁第85頁第86頁第87頁第88頁第89頁第90頁第91頁第92頁第93頁第94頁第95頁第96頁第97頁第98頁第99頁第100頁第101頁第102頁第103頁第104頁第105頁第106頁第107頁第108頁第109頁第110頁第111頁第112頁第113頁第114頁第115頁第116頁第117頁第118頁第119頁第120頁第121頁第122頁第123頁第124頁第125頁第126頁第127頁第128頁第129頁第130頁第131頁第132頁第133頁第134頁第135頁第136頁第137頁第138頁第139頁第140頁第141頁第142頁第143頁第144頁第145頁第146頁第147頁第148頁第149頁第150頁第151頁第152頁第153頁第154頁第155頁第156頁第157頁第158頁第159頁第160頁第161頁第162頁第163頁第164頁第165頁第166頁第167頁第168頁第169頁第170頁第171頁第172頁第173頁第174頁第175頁第176頁第177頁第178頁第179頁第180頁第181頁第182頁第183頁第184頁第185頁第186頁第187頁第188頁第189頁第190頁第191頁第192頁第193頁第194頁第195頁第196頁第197頁第198頁第199頁第200頁第201頁第202頁第203頁第204頁第205頁第206頁第207頁第208頁第209頁第210頁第211頁第212頁第213頁第214頁第215頁第216頁第217頁第218頁第219頁第220頁第221頁第222頁第223頁第224頁第225頁第226頁第227頁第228頁第229頁第230頁第231頁第232頁第233頁第234頁第235頁第236頁第237頁第238頁第239頁第240頁第241頁第242頁第243頁第244頁第245頁第246頁第247頁第248頁第249頁第250頁第251頁第252頁第253頁第254頁第255頁第256頁第257頁第258頁第259頁第260頁第261頁第262頁第263頁第264頁第265頁第266頁第267頁第268頁當前第269頁第270頁第271頁第272頁第273頁第274頁第275頁第276頁第277頁第278頁第279頁第280頁第281頁第282頁第283頁第284頁第285頁第286頁第287頁第288頁第289頁第290頁第291頁第292頁第293頁第294頁第295頁第296頁第297頁第298頁第299頁第300頁第301頁第302頁第303頁第304頁
Am79C973/Am79C975
269
P R E L I M I N A R Y
MII Receive Interface
The MII receive clock is also generated by the external
PHY and is sent to the Am79C973/Am79C975 control-
ler on the RX_CLK input pin. The clock will be the same
frequency as the TX_CLK but will be out of phase and
can run at 25 MHz or 2.5 MHz, depending on the speed
of the network to which the external PHY is attached.
The RX_CLK is a continuous clock during the reception
of the frame, but can be stopped for up to two RX_CLK
periods at the beginning and the end of frames, so that
the external PHY can sync up to the network data traffic
necessary to recover the receive clock. During this
time, the external PHY may switch to the TX_CLK to
maintain a stable clock on the receive interface. The
Am79C973/Am79C975 controller will handle this situa-
tion with no loss of data. The data is a nibble-wide (4
bits) data path, RXD(3:0), from the external PHY to the
Am79C973/Am79C975 controller and is synchronous
to the rising edge of RX_CLK.
The receive process starts when RX_DV is asserted.
RX_DV will remain asserted until the end of the receive
frame. The Am79C973/Am79C975 controller requires
CRS (Carrier Sense) to toggle in between frames in
order to receive them properly. Errors in the currently
received frame are signaled across the MII by the
RX_ER pin. RX_ER can be used to signal special con-
ditions
out of band
when RX_DV is not asserted. Two
defined out-of-band conditions for this are the
100BASE-TX signaling of
bad
Start of Frame Delimiter
and the 100BASE-T4 indication of illegal code group
before the receiver has
synched
to the incoming data.
The Am79C973/Am79C975 controller will not respond
to these conditions. All
out of band
conditions are cur-
rently treated as NULL events. Certain
in band
non-
IEEE 802.3u-compliant flow control sequences may
cause erratic behavior for the Am79C973/Am79C975
controller. Consult the switch/bridge/router/hub manual
to disable the
in-band
flow control sequences if they
are being used.
MII Network Status Interface
The MII also provides signals that are consistent and
necessary for IEEE 802.3 and IEEE 802.3u operation.
These signals are CRS (Carrier Sense) and COL (Col-
lision Sense). Carrier Sense is used to detect non-idle
activity on the network. Collision Sense is used to indi-
cate that simultaneous transmission has occurred in a
half-duplex network.
MII Management Interface
The MII provides a two-wire management interface so
that the Am79C973/Am79C975 controller can control
and receive status from external PHY devices.
The Am79C973/Am79C975 controller can support up
to 31 external PHYs attached to the MII Management
Interface with software support and only one such de-
vice without software support.
The Network Port Manager copies the PHYADD after
the Am79C973/Am79C975 controller reads the EE-
PROM and uses it to communicate with the external
PHY. The PHY address must be programmed into the
EEPROM prior to starting the Am79C973/Am79C975
controller. This is necessary so that the internal man-
agement controller can work autonomously from the
software driver and can always know where to access
the external PHY. The Am79C973/Am79C975 control-
ler is unique by offering direct hardware support of the
external PHY device without software support. The
PHY address of 1Fh is reserved and should not be
used. To access the 31 external PHYs, the software
driver must have knowledge of the external PHY
’
s ad-
dress when multiple PHYs are present before attempt-
ing to address it.
The MII Management Interface uses the MII Control,
Address, and Data registers (BCR32, 33, 34) to control
and communicate to the external PHYs. The
Am79C973/Am79C975 controller generates MII man-
agement frames to the external PHY through the MDIO
pin synchronous to the rising edge of the Management
Data Clock (MDC) based on a combination of writes
and reads to these registers.
MII Management Frames
MII management frames are automatically generated
by the Am79C973/Am79C975 controller and conform
to the MII clause in the IEEE 802.3u standard.
The start of the frame is a preamble of 32 ones and
guarantees that all of the external PHYs are synchro-
nized on the same interface. See Figure C-78. Loss of
synchronization is possible due to the
hot-plugging
ca-
pability of the exposed MII.
The IEEE 802.3 specification allows you to drop the
preamble, if after reading the MII Status Register from
the external PHY you can determine that the external
PHY will support Preamble Suppression (BCR34, bit
6). After having a valid MII Status Register read, the
Am79C973/Am79C975 controller will then drop the
creation of the preamble stream until a reset occurs, re-
ceives a read error, or the external PHY is discon-
nected.
相關PDF資料 |
PDF描述 |
|---|---|
| AM79C973 | PCnet⑩-FAST III Single-Chip 10/100 Mbps PCI Ethernet Controller with Integrated PHY |
| AM79C973KCW | PCnet⑩-FAST III Single-Chip 10/100 Mbps PCI Ethernet Controller with Integrated PHY |
| AM79C975KCW | PCnet⑩-FAST III Single-Chip 10/100 Mbps PCI Ethernet Controller with Integrated PHY |
| AM79C973VCW | PCnet⑩-FAST III Single-Chip 10/100 Mbps PCI Ethernet Controller with Integrated PHY |
| AM79C975VCW | PCnet⑩-FAST III Single-Chip 10/100 Mbps PCI Ethernet Controller with Integrated PHY |
相關代理商/技術參數 |
參數描述 |
|---|---|
| AM79C975BKC\\W | 制造商:Advanced Micro Devices 功能描述: |
| AM79C975BKC\W | 制造商:Advanced Micro Devices 功能描述: |
| AM79C975BKD\\W | 制造商:Advanced Micro Devices 功能描述: |
| AM79C975BKD\W | 制造商:Advanced Micro Devices 功能描述:PCnet-FAST III Single-Chip 10/100 Mbps PCI Ethernet Controller with Integrated PHY 制造商:AMD (Advanced Micro Devices) 功能描述:PCnet-FAST III Single-Chip 10/100 Mbps PCI Ethernet Controller with Integrated PHY |
| AM79C975BKDW | 制造商:Advanced Micro Devices 功能描述:PCnet-FAST III Single-Chip 10/100 Mbps PCI Ethernet Controller with Integrated PHY 制造商:AMD (Advanced Micro Devices) 功能描述:PCnet-FAST III Single-Chip 10/100 Mbps PCI Ethernet Controller with Integrated PHY |
發布緊急采購，3分鐘左右您將得到回復。