參數資料
型號： ADV7189BKSTZ10F
廠商： Analog Devices, Inc.
英文描述： Multiformat SDTV Video Decoder
中文描述： 標清多格式視頻解碼器
文件頁數： 53/104頁
文件大小： 805K
代理商： ADV7189BKSTZ10F
ADV7189B
Table 65. Data Byte Allocation
Raw Information Bytes
Retrieved from the Video Line
1
4
1
4
0
2
0
2
Rev. B | Page 53 of 104
2×
GDECAD
0
1
0
1
User Data-Words
(Including Padding)
8
4
4
4
Padding Bytes
0
0
0
2
DC[1:0]
10
01
01
01
Gemstar Bit Names
DID. The data identification value is 0x140 (10-bit value).
Care has been taken that in 8-bit systems, the 2 LSBs do
not carry vital information.
EP and !EP. The EP bit is set to ensure even parity on the
data-word D[8:0]. Even parity means there is always an
even number of 1s within the D[8:0] bit arrangement.
This includes the EP bit. !EP describes the logic inverse of
EP and is output on D[9]. The !EP is output to ensure that
the reserved codes of 00 and FF cannot happen.
EF. Even field identifier. EF = 1 indicates that the data was
recovered from a video line on an even field.
2×. This bit indicates whether the data sliced was in
Gemstar 1× or 2× format. A high indicates 2× format.
Line[3:0]. This entry provides a unique code for each of the
possible 16 source lines of video from which Gemstar data
may have been retrieved. See
225H
Table 74 and
226H
Table 75.
DC[1:0]. Data count value. The number of user data-words
in the packet divided by 4. The number of user data-words
(UDW) in any packet must be an integral number of 4.
Padding is required at the end if necessary (requirement
as set in ITU-R BT.1364). See
227H
Table 65.
The 2× bit determines whether the raw information
retrieved from the video line was 2 or 4 bytes. The state
of the GDECAD bit affects whether the bytes are trans-
mitted straight (that is, two bytes transmitted as two bytes)
or whether they are split into nibbles (that is, two bytes
transmitted as four half bytes). Padding bytes are then
added where necessary.
CS[8:2]. The checksum is provided to determine the
integrity of the ancillary data packet. It is calculated by
summing up D[8:2] of DID, SDID, the Data Count byte,
and all UDWs, and ignoring any overflow during the
summation. Since all data bytes that are used to calculate
the checksum have their 2 LSBs set to 0, the CS[1:0] bits
are also always 0.
!CS[8] describes the logic inversion of CS[8]. The value
!CS[8] is included in the checksum entry of the data packet
to ensure that the reserved values of 0x00 and 0xFF do not
occur.
228H
Table 66 to
229H
Table 69 outline the possible data packages.
Gemstar 2× Format, Half-Byte Output
Half-byte output mode is selected by setting CDECAD = 0;
full-byte output mode is selected by setting CDECAD = 1.
See the
230H
GDECAD Gemstar Decode Ancillary Data Format,
Address 0x4C[0] section.
Gemstar 1× Format
Half-byte output mode is selected by setting CDECAD = 0,
full-byte output mode is selected by setting CDECAD = 1.
See the
231H
GDECAD Gemstar Decode Ancillary Data Format,
Address 0x4C[0] section.
相關PDF資料
PDF描述
ADV7189 Multiformat SDTV Video Decoder
ADV7189KST Multiformat SDTV Video Decoder
ADV7195 Multiformat Progressive Scan/HDTV Encoder with Three 11-Bit DACs and 10-Bit Data Input
ADV7195KST Multiformat Progressive Scan/HDTV Encoder with Three 11-Bit DACs and 10-Bit Data Input
ADV7196 Multiformat Progressive Scan/HDTV Encoder with Three 11-Bit DACs, 10-Bit Data Input, and Macrovision
相關代理商/技術參數
參數描述
ADV7189BKSTZ10F2 制造商:AD 制造商全稱:Analog Devices 功能描述:Multiformat SDTV Video Decoder
ADV7189BST 制造商:Analog Devices 功能描述:
ADV7189KST 制造商:Rochester Electronics LLC 功能描述:12BIT NTSC/PAL/SECAMVIDDECOD I.C. - Tape and Reel 制造商:Analog Devices 功能描述:IC VIDEO ENCODER
ADV7189XST 制造商:Analog Devices 功能描述:54MHZ NTSC/PAL ENCODER(DNR+MACROVISON)IC - Bulk
ADV7189XST-X2 制造商:Analog Devices 功能描述:54MHZ NTSC/PAL ENCODER(DNR+MACROVISON)IC - Bulk
發布緊急采購，3分鐘左右您將得到回復。

采購需求

(若只采購一條型號，填寫一行即可)

發布成功！您可以繼續發布采購。也可以進入我的后臺，查看報價

發布成功！您可以繼續發布采購。也可以進入我的后臺，查看報價

*型號 *數量 廠商 批號 封裝
添加更多采購

我的聯系方式

*
*
*