Philips Semiconductors
Preliminary data
PDI1394P23
2-port/1-port 400 Mbps physical layer interface
2001 Sep 06
33
Table 20. LPS Timing Parameters
PARAMETER
DESCRIPTION
MIN
MAX
UNIT
TLPSL
LPS low time (when pulsed) (see Note 1)
0.09
2.60
S
TLPSH
LPS high time (when pulsed) (see Note 1)
0.021
2.60
S
LPS duty cycle (when pulsed) (see Note 2)
20
55
%
TLPS_RESET
Time for PHY to recognize LPS deasserted and reset the interface
2.60
2.68
S
TLPS_DISABLE
Time for PHY to recognize LPS deasserted and disable the interface
26.03
26.11
S
TRESTORE
Time to permit optional isolation circuits to restore during an interface reset
15
233
S
TCLK_ACTIVATE
Time for SYSCLK to be activated from reassertion of LPS
—
60
nS
NOTES:
1. The specified TLPSL and TLPSH times are worst–case values appropriate for operation with the PDI1394P23. These values are broader than
those specified for the same parameters in the P1394a Supplement (i.e., an implementation of LPS that meets the requirements of P1394a
will operate correctly with the PDI1394P23).
2. A pulsed LPS signal must have a duty cycle (ratio of TLPSH to cycle period) in the specified range to ensure proper operation when using an
isolation barrier on the LPS signal (e.g., as shown in Figure 8)
3. The maximum value for TRESTORE does not apply when the PHY–LLC interface is disabled, in which case an indefinite time may elapse
before LPS is reasserted. Otherwise, in order to reset but not disable the interface it is necessary that the LLC ensure that LPS is
deasserted for less than TLPS_DISABLE.
The LLC requests that the interface be reset by deasserting the LPS
signal and terminating all bus and request activity. When the PHY
observes that LPS has been deasserted for TLPS_RESET, it resets
the interface. When the interface is in the reset state, the PHY sets
its CTL and D outputs in the logic 0 state and ignores any activity on
the LREQ signal. The timing for interface reset is shown in Figure 20
and Figure 21.
TLPS_RESET
TRESTORE
ISO
SYSCLK
CTL0, CTL1
D0 – D7
LREQ
LPS
(low)
(a)
(c)
(d)
(b)
TLPSL
TLPSH
SV01810
Figure 20.
Interface Reset, ISO Low