- 您現在的位置：買賣IC網 > PDF目錄16820 > XR17V358IB-E8-EVB (Exar Corporation)EVAL BOARD FOR XR17V358-E8 PDF資料下載
參數資料
| 型號： | XR17V358IB-E8-EVB |
| 廠商： | Exar Corporation |
| 文件頁數： | 20/68頁 |
| 文件大?。?/td> | 0K |
| 描述： | EVAL BOARD FOR XR17V358-E8 |
| 產品培訓模塊： | PCIe UARTs UART Product Overview |
| 標準包裝： | 1 |
| 主要目的： | 接口，UART |
| 嵌入式： | 否 |
| 已用 IC / 零件： | XR17V358 |
| 已供物品： | 板 |
| 相關產品： | 1016-1294-ND - IC UART PCIE OCTAL 176FPBGA |
| 其它名稱： | 1016-1296 |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁當前第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁第30頁第31頁第32頁第33頁第34頁第35頁第36頁第37頁第38頁第39頁第40頁第41頁第42頁第43頁第44頁第45頁第46頁第47頁第48頁第49頁第50頁第51頁第52頁第53頁第54頁第55頁第56頁第57頁第58頁第59頁第60頁第61頁第62頁第63頁第64頁第65頁第66頁第67頁第68頁
XR17V358
27
REV. 1.0.4
HIGH PERFORMANCE OCTAL PCI EXPRESS UART
1.4.8
Multi-Purpose Inputs and Outputs
The V358 provides 16 multi-purpose inputs/outputs MPIO[15:0] for general use. Each pin can be programmed
to be an input or output function. The input logic state can be set for normal or inverted level, and optionally set
to generate an interrupt. The outputs can be set to be normal HIGH or LOW state, 3-state, or open drain. Their
functions and definitions are programmed through 6 registers: MPIOINT, MPIOLVL, MPIO3T, MPIOINV,
MPIOSEL, and MPIOOD. If all 16 pins are set for inputs, all 16 interrupts would be ORed together. The ORed
interrupt is reported in the channel 0 UART interrupt status, see Interrupt Status Register. The pins may also be
programmed to be outputs and to the 3-state condition for signal sharing. The MPIO[0] pin can be programmed
to show the Timer output. When it is programmed to be the Timer output, all the above 5 registers lose control
over the MPIO[0] pin. For details on Timer output, please see “Section 1.4.2, General Purpose 16-bit Timer/
1.4.9
MPIO REGISTERS
REGB[18](Read/Write
Logic 0 (default) - Global interrupt enable. Interrupts to PCI host are enabled.
Logic 1 - Global interrupt disable. Interrupts to PCI host are disabled.
REGB[19](Read-Only)
Logic 0 - EEPROM load is valid.
Logic 1 - EEPROM load error caused by one of the following conditions: EEPROM not
attached, final bit not found, parity error detected.
REGB[20] (Write-Only)
Control the EECK, clock, output on the EEPROM interface.
REGB[21] (Write-Only)
Control the EECS, chips select, output to the EEPROM device.
REGB[22] (Write-Only)
EEDI data input. Write data to the EEPROM device.
REGB[23] (Read-Only)
EEDO data output. Read data from the EEPROM device.
1.4.7
REGB Register
相關PDF資料 |
PDF描述 |
|---|---|
| EBM24DCSH-S288 | CONN EDGECARD 48POS .156 EXTEND |
| EGM08DRST | CONN EDGECARD 16POS DIP .156 SLD |
| V150B28E150BL | CONVERTER MOD DC/DC 28V 150W |
| HSM06DRYH-S13 | CONN EDGECARD 12POS .156 EXTEND |
| EBM24DCSD-S288 | CONN EDGECARD 48POS .156 EXTEND |
相關代理商/技術參數 |
參數描述 |
|---|---|
| XR1857SN | 制造商:Electro-Term/Hollingsworth 功能描述: |
| XR1858SN | 制造商:Electro-Term/Hollingsworth 功能描述: |
| XR1859SN | 制造商:Electro-Term/Hollingsworth 功能描述: |
| XR1859SNT | 制造商:Hollingsworth 功能描述: |
| XR1880S | 制造商:Electro-Term/Hollingsworth 功能描述: |
發布緊急采購，3分鐘左右您將得到回復。