- 您現在的位置：買賣IC網 > PDF目錄376449 > X96012V14I (INTERSIL CORP) Universal Sensor Conditioner with Dual Look Up Table Memory and DACs PDF資料下載
參數資料
| 型號： | X96012V14I |
| 廠商： | INTERSIL CORP |
| 元件分類： | 模擬信號調理 |
| 英文描述： | Universal Sensor Conditioner with Dual Look Up Table Memory and DACs |
| 中文描述： | SPECIALTY ANALOG CIRCUIT, PDSO14 |
| 封裝： | PLASTIC, MO-153AC, TSSOP-14 |
| 文件頁數： | 24/27頁 |
| 文件大?。?/td> | 383K |
| 代理商： | X96012V14I |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁當前第24頁第25頁第26頁第27頁
24
FN8216.0
March 10, 2005
Page Write Operation
The 2176-bit memory array is physically realized as
one contiguous array, organized as 17 pages of 16
bytes each. A “Page Write” operation can be per-
formed to any of the GPM or LUT pages. In order to
perform a Page Write operation to the memory array,
the Write Enable Latch (WEL) bit in Control register 6
must first be set (See “WEL: Write Enable Latch (Vola-
tile)” on page 14.)
A Page Write operation is initiated in the same manner
as the byte write operation; but instead of terminating
the write cycle after the first data byte is transferred,
the master can transmit up to 16 bytes (See Figure
19). After the receipt of each byte, the X96012
responds with an ACK, and the internal byte address
counter is incremented by one. The page address
remains constant. When the counter reaches the end
of the page, it “rolls over” and goes back to the first
byte of the same page.
For example, if the master writes 12 bytes to a 16-byte
page starting at location 11 (decimal), the first 5 bytes
are written to locations 11 through 15, while the last 7
bytes are written to locations 0 through 6 within that
page. Afterwards, the address counter would point to
location 7. If the master supplies more than 16 bytes of
data, then new data overwrites the previous data, one
byte at a time (See Figure 20).
The master terminates the loading of Data Bytes by
issuing a STOP condition, which initiates the nonvola-
tile write cycle. As with the Byte Write operation, all
inputs are disabled until completion of the internal
write cycle.
A Page Write operation cannot be performed on the
page at locations 80h through 8Fh. Next section
describes the special cases within that page.
A Page Write operation starting with byte address
FFh, accesses the page between locations 100h and
10Fh. The first data byte of such operation is written to
location 100h.
Writing to Control Registers
The byte at location 80h, 85h, and 86h are written
using Byte Write operations. They cannot be written
using a Page Write operation.
Control bytes 1 through 4, at locations 81h through 84h
respectively, are written during a single operation (See
Figure 21). The sequence must be: a START, followed
by a Slave Address byte, with the R/W bit equal to “0”,
followed by 81h as the Address Byte, and then followed
by exactly four Data Bytes, and a STOP condition. The
first data byte is written to location 81h, the second to
82h, the third to 83h, and the last one to 84h.
S
t
a
r
t
S
t
o
p
Slave
Address
Address
Byte
Data
Byte
A
C
K
Signals from
the Master
Signals from
the Slave
A
C
K
1
0
1
0
0
A
C
K
Write
Signal at SDA
Figure 18. Byte Write Sequence
2 < n < 16
Signals from
the Master
Signals from
the Slave
Signal at SDA
S
t
a
r
t
Slave
Address
Address
Byte
A
C
K
A
C
K
1
0
1
0
0
Data Byte (1)
S
t
o
p
A
C
K
A
C
K
Data Byte (n)
Write
Figure 19. Page Write Operation
X96012
相關PDF資料 |
PDF描述 |
|---|---|
| X96012 | Universal Sensor Conditioner with Dual Look-up Table Memory and DACs(通用傳感器調節器，帶雙查找表存儲器及DACs) |
| X98014L128-3.3-Z | 140MHz Triple Video Digitizer with Digital PLL |
| X98014L128-3.3 | 140MHz Triple Video Digitizer with Digital PLL |
| X98014 | 140MHz Triple Video Digitizer with Digital DLL(帶有數字PLL的140MHz三路視頻信號數字轉換器) |
| X98017 | 170MHz Triple Video Digitizer with Digital PLL |
相關代理商/技術參數 |
參數描述 |
|---|---|
| X96012V14IZ | 功能描述:板上安裝溫度傳感器 UNIVERSAL SENSOR CONDITIO W/DL LOOKUP RoHS:否 制造商:Omron Electronics 輸出類型:Digital 配置: 準確性:+/- 1.5 C, +/- 3 C 溫度閾值: 數字輸出 - 總線接口:2-Wire, I2C, SMBus 電源電壓-最大:5.5 V 電源電壓-最小:4.5 V 最大工作溫度:+ 50 C 最小工作溫度:0 C 關閉: 安裝風格: 封裝 / 箱體: 設備功能:Temperature and Humidity Sensor |
| X96012V14IZT1 | 功能描述:板上安裝溫度傳感器 UNIVERSAL SENSOR CONDITIO W/DL LOOKUP RoHS:否 制造商:Omron Electronics 輸出類型:Digital 配置: 準確性:+/- 1.5 C, +/- 3 C 溫度閾值: 數字輸出 - 總線接口:2-Wire, I2C, SMBus 電源電壓-最大:5.5 V 電源電壓-最小:4.5 V 最大工作溫度:+ 50 C 最小工作溫度:0 C 關閉: 安裝風格: 封裝 / 箱體: 設備功能:Temperature and Humidity Sensor |
| X9601XEVAL | 制造商:Intersil Corporation 功能描述:X9601 EVALUATION BOARD - Bulk |
| X9650M | 制造商:EPCOS 制造商全稱:EPCOS 功能描述:Bandpass Filter |
| X-97-488 | 制造商:Brady Corporation 功能描述:Labels External Width:0.9" 制造商:Brady Corporation 功能描述:LABEL IDENTIFICATION 22.86X22.86 BLK/WHT; Background Color:White; Color:Black on White; External Width:0.9"; For Use With:IDXPERT Hand-Held Labeler; Label Material:Polyester; Label Size:22.86 x 22.86mm; Label Type:Identification ;RoHS Compliant: Yes |
發布緊急采購，3分鐘左右您將得到回復。