- 您現在的位置：買賣IC網 > PDF目錄245685 > W3H128M72ER-667SBM (WHITE ELECTRONIC DESIGNS CORP) 128M X 72 DDR DRAM, 0.5 ns, PBGA255 PDF資料下載
參數資料
| 型號： | W3H128M72ER-667SBM |
| 廠商： | WHITE ELECTRONIC DESIGNS CORP |
| 元件分類： | DRAM |
| 英文描述： | 128M X 72 DDR DRAM, 0.5 ns, PBGA255 |
| 封裝： | 23 X 21 MM, 1.27 MM PITCH, PLASTIC, BGA-255 |
| 文件頁數： | 9/34頁 |
| 文件大?。?/td> | 1028K |
| 代理商： | W3H128M72ER-667SBM |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁當前第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁第30頁第31頁第32頁第33頁第34頁
W3H128M72ER-XNBX
17
White Electronic Designs Corporation (602) 437-1520 www.whiteedc.com
White Electronic Designs
February 2009
Rev. 6
PRELIMINARY
White Electronic Designs Corp. reserves the right to change products or specications without notice.
READ COMMAND
The READ command is used to initiate a burst read access
to an active row. The value on the BA2–BA0 inputs selects
the bank, and the address provided on inputs A0–i (where
i = A9) selects the starting column location. The value on
input A10 determines whether or not auto precharge is
used. If auto precharge is selected, the row being accessed
will be precharged at the end of the READ burst; if auto
precharge is not selected, the row will remain open for
subsequent accesses.
READ OPERATION
READ bursts are initiated with a READ command. The
starting column and bank addresses are provided with the
READ command and auto precharge is either enabled or
disabled for that burst access. If auto precharge is enabled,
the row being accessed is automatically precharged at the
completion of the burst. If auto precharge is disabled, the
row will be left open after the completion of the burst.
During READ bursts, the valid data-out element from the
starting column address will be available READ latency
(RL) clocks later. RL is dened as the sum of AL and CL;
RL = AL + CL. The value for AL and CL are programmable
via the MR and EMR commands, respectively. Each
subsequent data-out element will be valid nominally at
the next positive or negative clock edge (i.e., at the next
crossing of CK and CK#).
DQS/DQS# is driven by the DDR2 SDRAM along with
output data. The initial LOW state on DQS and HIGH state
on DQS# is known as the read preamble (tRPRE). The LOW
state on DQS and HIGH state on DQS# coincident with
the last data-out element is known as the read postamble
(tRPST).
Upon completion of a burst, assuming no other commands
have been initiated, the DQ will go High-Z.
Data from any READ burst may be concatenated with
data from a subsequent READ command to provide a
continuous ow of data. The rst data element from the
new burst follows the last element of a completed burst.
The new READ command should be issued x cycles after
the rst READ command, where x equals BL / 2 cycles.
FIGURE 11 – READ COMMAND
DON’T CARE
CK
CK#
CS#
RAS#
CAS#
WE#
CKE
Col
Bank
ADDRESS
BANK ADDRESS
AUTO PRECHARGE
ENABLE
DISABLE
A10
相關PDF資料 |
PDF描述 |
|---|---|
| W3EG72126S262AJD3SG | 128M X 72 DDR DRAM MODULE, 0.75 ns, DMA184 |
| W3EG72126S265JD3SG | 128M X 72 DDR DRAM MODULE, 0.75 ns, DMA184 |
| W3H128M72E0533SBM | DDR DRAM, PBGA208 |
| W3H128M72E2-533NBC | 128M X 72 DDR DRAM, 0.5 ns, PBGA208 |
| W7NCF01GH10CS6CG | 64M X 16 FLASH 3.3V PROM CARD, 150 ns, UUC |
相關代理商/技術參數 |
參數描述 |
|---|---|
| W3H13C1048AT | 制造商:AVX 制造商全稱:AVX Corporation 功能描述:High Current Feedthry Capacitors |
| W3H13C1048AT1A | 功能描述:饋通電容器 25volt 0.1uF X7R RoHS:否 制造商:Tusonix 電容:8200 pF 容差:- 20 %, + 80 % 電壓額定值: 工作溫度范圍: 溫度系數: 封裝 / 箱體: |
| W3H13C1048AT1F | 功能描述:饋通電容器 25volt 0.1uF X7R RoHS:否 制造商:Tusonix 電容:8200 pF 容差:- 20 %, + 80 % 電壓額定值: 工作溫度范圍: 溫度系數: 封裝 / 箱體: |
| W3H15C1038AT | 制造商:AVX 制造商全稱:AVX Corporation 功能描述:High Current Feedthry Capacitors |
| W3H15C1038AT1A | 功能描述:饋通電容器 50volt .01uF X7R RoHS:否 制造商:Tusonix 電容:8200 pF 容差:- 20 %, + 80 % 電壓額定值: 工作溫度范圍: 溫度系數: 封裝 / 箱體: |
發布緊急采購，3分鐘左右您將得到回復。