參數資料
型號: TSS463C
廠商: Atmel Corp.
英文描述: VAN Data Link Controller with Serial Interface
中文描述: 凡數據與串行接口鏈路控制器
文件頁數: 8/59頁
文件大小: 492K
代理商: TSS463C
8
TSS463C
7601B–AUTO–02/06
When the master (CPU) conducts a read, it sends an address byte, a control byte and
dummy characters (’0xFF’for instance) on its MOSI line. In the case of a VAN messages
RAM read (VAN frame received), the first data byte sent back by the TSS463C on its
MISO pin is the
data length
so the master knows how many dummy characters it must
send to read the VAN frame properly. When the TSS463C responds back with data, it
will not take care of the MOSI line.
The master must activate and desactivate SS between each data frame.
Synchronization bytes must be monitored carefully. For instance, if ’0xAA’and ’0x55’are
not monitored correctly, then the previous transmission may be incorrect too.
A control byte containing ’0x00’or ’0xFF’is forbidden except during an ’Initialization
Sequence ’.
Intel SPI Mode
The Intel SPI mode is the second type of interface. As mentioned before, the TSS463C
enters this mode if the Initialization Sequence contains (first two bytes received) ’0xFF,
0xFF’.
This mode is fully compatible to the Intel UART serial interface programmed in mode 0
only. It is the same as Motorola SPI mode (same CPOL and CPHA) but with inverted
communication sense (LSB first and MSB last). The protocol is also the same.
However, from the master point of view (host microcontroller), the hardware is different.
Figure 5 shows how to connect the TSS463C and Intel type microcontroller.
Figure 5.
Typical Application With the 8051 UART in Mode 0
Note:
1. The RESET pin can either be connected to GND through a 1 μF capacitor, or to the
microcontroller RESET pin, or unconnected (inactive with internal pull-up).
INT
IRQ
PORT X.z
SS
PORT X.y
RXD
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
SCLK
MISO
MOSI
RxD0
RxD1
RxD2
TXD
RESET (1)
VDD
GND
CKOUT
XTAL1
XTAL2
TXD
VAN Bus
General I/O
Remaining pins
TEST/VSS
XTAL1
C1
C2
100k
(if needed)
optional
RESET (1)
16
M
T
相關PDF資料
PDF描述
TSS4B02G Single Phase 4.0 Amps. Glass Passivated Super Fast Bridge Rectifiers
TSS4B03G Single Phase 4.0 Amps. Glass Passivated Super Fast Bridge Rectifiers
TSS4B01G Single Phase 4.0 Amps. Glass Passivated Super Fast Bridge Rectifiers
TSS5G45S TOSHIBA SOLID STATE AC RELAY
TSS5J45S TOSHIBA SOLID STATE AC RELAY
相關代理商/技術參數
參數描述
TSS463C-TERA-9 功能描述:網絡控制器與處理器 IC ASICS RoHS:否 制造商:Micrel 產品:Controller Area Network (CAN) 收發器數量: 數據速率: 電源電流(最大值):595 mA 最大工作溫度:+ 85 C 安裝風格:SMD/SMT 封裝 / 箱體:PBGA-400 封裝:Tray
TSS463C-TERZ-9 制造商:Atmel Corporation 功能描述:
TSS463C-TESZ-9 功能描述:網絡控制器與處理器 IC ASICS RoHS:否 制造商:Micrel 產品:Controller Area Network (CAN) 收發器數量: 數據速率: 電源電流(最大值):595 mA 最大工作溫度:+ 85 C 安裝風格:SMD/SMT 封裝 / 箱體:PBGA-400 封裝:Tray
TSS463D 制造商:未知廠家 制造商全稱:未知廠家 功能描述:Industrial Control IC
TSS463R 制造商:未知廠家 制造商全稱:未知廠家 功能描述:Industrial Control IC