參數資料
型號: TSS463A-TERZ
廠商: Atmel Corp.
英文描述: VAN Data Link Controller with Serial Interface
中文描述: 凡數據與串行接口鏈路控制器
文件頁數: 22/60頁
文件大?。?/td> 816K
代理商: TSS463A-TERZ
22
TSS463-AA
4205B–AUTO–12/04
Diagnosis System
The purpose of the diagnosis system is to detect any short or open circuits on either the
DATA or DATA lines and to permit, if it is possible, to carry the communications on the
non-defective line.
The diagnosis system is based on the assumption that three separate line receivers are
connected to the VAN bus see Figure 1:
One of the line receivers is connected in differential mode, sensing both DATA and
DATA signals, and is connected to the RxD0 input.
The other two line receivers are operating in single wire mode and are sensing only
one of the two VAN bus signals:
The line receiver sensing DATA is connected to RxD1
The line receiver sensing DATA is connected to RxD2
The diagnosis system analyzes and compares the data sent over both VAN lines. So,
the diagnosis system executes a digital filtering and transition analyses. In order to per-
form its investigation, three internal signals are generated, RI (
Return to Idle)
, SDC
(
Synchronous Diagnosis Clock)
and TIP (
Transmission In Progress
).
One of four operating modes can be chosen to manage the results of the diagnosis
system.
Diagnosis States
If the diagnosis system finds a failure on any of the VAN bus signals, it changes from
nominal to degraded mode, and connects the line receiver not coupled to the failing sig-
nal to the reception logic.
When the diagnosis system finds that the failing signal is working again, it returns to
nominal mode and re-connects the differential line receiver to the reception logic.
A major error occurs when both the VAN bus signals failed.
Figure 21.
Diagnosis States
Nominal
Degraded
Data
Degraded
Data
Major
Error
- Failure during the frame
- Default of transitions on the valid input between 2 consecutive SDC rising edges.
- Protocol fault
-In specified selection mode, every RI pulse when an EOF is detected or through an active SDC.
-In automatic selection mode and SDC active, no failuresampled by 2 consecutive SDC rising edges.
-General Reset
相關PDF資料
PDF描述
TSS463C VAN Data Link Controller with Serial Interface
TSS4B02G Single Phase 4.0 Amps. Glass Passivated Super Fast Bridge Rectifiers
TSS4B03G Single Phase 4.0 Amps. Glass Passivated Super Fast Bridge Rectifiers
TSS4B01G Single Phase 4.0 Amps. Glass Passivated Super Fast Bridge Rectifiers
TSS5G45S TOSHIBA SOLID STATE AC RELAY
相關代理商/技術參數
參數描述
TSS463B 制造商:ATMEL 制造商全稱:ATMEL Corporation 功能描述:Serial VAN Data Link Controller
TSS463B_03 制造商:ATMEL 制造商全稱:ATMEL Corporation 功能描述:Serial VAN Data Link Controller
TSS463B_04 制造商:ATMEL 制造商全稱:ATMEL Corporation 功能描述:VAN Data Link Controller with Serial Interface
TSS463B-TERA 制造商:Temic 功能描述:LAN Node Controller, 16 Pin, SOP
TSS463B-TERA-9 制造商:ATMEL 制造商全稱:ATMEL Corporation 功能描述:VAN Data Link Controller with Serial Interface