- 您現在的位置：買賣IC網 > PDF目錄359302 > TMS320FN (Texas Instruments, Inc.) Adjustable 1.24-16V ±0.5% Tolerance, 0.05-20mA Shunt Regulator; Package: TO-92 (TO-226) 5.33mm Body Height; No of Pins: 3; Container: Tape and Reel; Qty per Container: 2000 PDF資料下載
參數資料
| 型號： | TMS320FN |
| 廠商： | Texas Instruments, Inc. |
| 英文描述： | Adjustable 1.24-16V ±0.5% Tolerance, 0.05-20mA Shunt Regulator; Package: TO-92 (TO-226) 5.33mm Body Height; No of Pins: 3; Container: Tape and Reel; Qty per Container: 2000 |
| 中文描述： | 第二代數字信號處理器 |
| 文件頁數： | 68/123頁 |
| 文件大?。?/td> | 1205K |
| 代理商： | TMS320FN |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁第30頁第31頁第32頁第33頁第34頁第35頁第36頁第37頁第38頁第39頁第40頁第41頁第42頁第43頁第44頁第45頁第46頁第47頁第48頁第49頁第50頁第51頁第52頁第53頁第54頁第55頁第56頁第57頁第58頁第59頁第60頁第61頁第62頁第63頁第64頁第65頁第66頁第67頁當前第68頁第69頁第70頁第71頁第72頁第73頁第74頁第75頁第76頁第77頁第78頁第79頁第80頁第81頁第82頁第83頁第84頁第85頁第86頁第87頁第88頁第89頁第90頁第91頁第92頁第93頁第94頁第95頁第96頁第97頁第98頁第99頁第100頁第101頁第102頁第103頁第104頁第105頁第106頁第107頁第108頁第109頁第110頁第111頁第112頁第113頁第114頁第115頁第116頁第117頁第118頁第119頁第120頁第121頁第122頁第123頁
www.ti.com
4.9
Serial Peripheral Interface (SPI) Modules (SPI-A, SPI-B, SPI-C, SPI-D)
Baud rate =
LSPCLK
4
LSPCLK
(SPIBRR
1)
when SPIBRR = 3 to 127
Baud rate =
when SPIBRR = 0,1, 2
TMS320F2808, TMS320F2806
TMS320F2801, UCD9501
Digital Signal Processors
SPRS230F–OCTOBER 2003–REVISED SEPTEMBER 2005
The 280x devices include the four-pin serial peripheral interface (SPI) module. Up to four SPI modules
(SPI-A, SPI-B, SPI-C, and SPI-D) are available. The SPI is a high-speed, synchronous serial I/O port that
allows a serial bit stream of programmed length (one to sixteen bits) to be shifted into and out of the
device at a programmable bit-transfer rate. Normally, the SPI is used for communications between the
DSP controller and external peripherals or another processor. Typical applications include external I/O or
peripheral expansion through devices such as shift registers, display drivers, and ADCs. Multidevice
communications are supported by the master/slave operation of the SPI.
The SPI module features include:
Four external pins:
–
SPISOMI: SPI slave-output/master-input pin
–
SPISIMO: SPI slave-input/master-output pin
–
SPISTE: SPI slave transmit-enable pin
–
SPICLK: SPI serial-clock pin
NOTE: All four pins can be used as GPIO, if the SPI module is not used.
Two operational modes: master and slave
Baud rate: 125 different programmable rates.
Data word length: one to sixteen data bits
Four clocking schemes (controlled by clock polarity and clock phase bits) include:
–
Falling edge without phase delay: SPICLK active-high. SPI transmits data on the falling edge of the
SPICLK signal and receives data on the rising edge of the SPICLK signal.
–
Falling edge with phase delay: SPICLK active-high. SPI transmits data one half-cycle ahead of the
falling edge of the SPICLK signal and receives data on the falling edge of the SPICLK signal.
–
Rising edge without phase delay: SPICLK inactive-low. SPI transmits data on the rising edge of the
SPICLK signal and receives data on the falling edge of the SPICLK signal.
–
Rising edge with phase delay: SPICLK inactive-low. SPI transmits data one half-cycle ahead of the
falling edge of the SPICLK signal and receives data on the rising edge of the SPICLK signal.
Simultaneous receive and transmit operation (transmit function can be disabled in software)
Transmitter and receiver operations are accomplished through either interrupt-driven or polled
algorithms.
Nine SPI module control registers: Located in control register frame beginning at address 7040h.
NOTE
All registers in this module are 16-bit registers that are connected to Peripheral Frame 2.
When a register is accessed, the register data is in the lower byte (7-0), and the upper
byte (15-8) is read as zeros. Writing to the upper byte has no effect.
Enhanced feature:
16-level transmit/receive FIFO
Delayed transmit control
The SPI port operation is configured and controlled by the registers listed in
Table 4-10
.
68
Peripherals
相關PDF資料 |
PDF描述 |
|---|---|
| TMS320FZ | Adjustable 1.24-16V +/-0.5% Tolerance, 0.05-20mA Shunt Regulator, Pb-Free Device; Package: TO-92 (TO-226) 5.33mm Body Height; No of Pins: 3; Container: Tape and Reel; Qty per Container: 2000 |
| TMS320GB | Adjustable 1.24-16V ±0.5% Tolerance, 0.05-20mA Shunt Regulator; Package: TO-92 (TO-226) 5.33mm Body Height; No of Pins: 3; Container: Tape and Reel; Qty per Container: 2000 |
| TMS320LC545B | FIXED-POINT DIGITAL SIGNAL PROCESSORS |
| TMS320LC546B | 1A, 52kHz (250kHz Max) Current Mode PWM Control Circuit with 8.4V UVLO Threshold and 48% Max Duty Cycle; Package: SOIC 14 LEAD; No of Pins: 14; Container: Rail; Qty per Container: 55 |
| TMS320LC54x | 1A, 52kHz (250kHz Max) Current Mode PWM Control Circuit with 16V UVLO Threshold and 96% Max Duty Cycle; Package: SOIC-8 Narrow Body; No of Pins: 8; Container: Rail; Qty per Container: 98 |
相關代理商/技術參數 |
參數描述 |
|---|---|
| TMS320G203PZ | 制造商:n/a 功能描述:320G203 S7G4A |
| TMS320-JTAG | 功能描述:仿真器/模擬器 DSP JTAG FOR PROG & EMULATION RoHS:否 制造商:Blackhawk 產品:System Trace Emulators 工具用于評估:C6000, C5000, C2000, OMAP, DAVINCI, SITARA, TMS470, TMS570, ARM 7/9, ARM Cortex A8/R4/M3 用于:XDS560v2 |
| TMS320-JTAG-USB | 功能描述:JTAG調試器 DSP USB JTAG FOR XDS100 SOFTWARE RoHS:否 制造商:Olimex Ltd. 產品:JTAG In-Circuit Debuggers 工具用于評估:MSP430 Flash MCUs 用于:MSP430 Kick Start, MSPGCC 核心:MSP430 接口類型:JTAG, USB 工作電源電壓:12 V |
| TMS320LBC51PQA57 | 功能描述:數字信號處理器和控制器 - DSP, DSC DSP RoHS:否 制造商:Microchip Technology 核心:dsPIC 數據總線寬度:16 bit 程序存儲器大小:16 KB 數據 RAM 大小:2 KB 最大時鐘頻率:40 MHz 可編程輸入/輸出端數量:35 定時器數量:3 設備每秒兆指令數:50 MIPs 工作電源電壓:3.3 V 最大工作溫度:+ 85 C 封裝 / 箱體:TQFP-44 安裝風格:SMD/SMT |
| TMS320LBC51PZ | 制造商:Rochester Electronics LLC 功能描述:- Bulk 制造商:Texas Instruments 功能描述: |
發布緊急采購，3分鐘左右您將得到回復。