- 您現在的位置：買賣IC網 > PDF目錄372453 > TDA7514 (意法半導體) SINGLE-CHIP FM/AM TUNER WITH STEREO DECODER AND AUDIO PROCESSOR PDF資料下載
參數資料
| 型號： | TDA7514 |
| 廠商： | 意法半導體 |
| 英文描述： | SINGLE-CHIP FM/AM TUNER WITH STEREO DECODER AND AUDIO PROCESSOR |
| 中文描述： | 單芯片F(xiàn)M /調幅調諧立體聲解碼器和音頻處理器 |
| 文件頁數： | 67/74頁 |
| 文件大小： | 604K |
| 代理商： | TDA7514 |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁第30頁第31頁第32頁第33頁第34頁第35頁第36頁第37頁第38頁第39頁第40頁第41頁第42頁第43頁第44頁第45頁第46頁第47頁第48頁第49頁第50頁第51頁第52頁第53頁第54頁第55頁第56頁第57頁第58頁第59頁第60頁第61頁第62頁第63頁第64頁第65頁第66頁當前第67頁第68頁第69頁第70頁第71頁第72頁第73頁第74頁
67/74
TDA7514
5.3.3
Tuning is achieved thanks to a high speed PLL for fast RDS operation. The VCO input (after the first di-
vider) is divided through a swallow counter-divider and compared to the divided 10.25 MHz reference fre-
quency (fully programmable divider).
In FM the absence of a locked condition can be detected in order to automatically enable the charge pump
current and loop filter bandwidth to increase in order to speed up the locking process. Automatic switch
back to a lower charge pump current and narrower loop filter bandwidth can also be forced by the lock
detector, thus achieving a slower but less noisy operation of the tuning loop. Both the high and the low
values of the charge pump current are programmable.
Two separate loop filters can be used for optimized AM and FM operation.
PLL
5.3.4
The stereo decoder is crossed by both the AM and the FM signal. The AM signal is only low-pass filtered
and subjected to audio noise blanking if necessary; the FM MPX signal is stereo demodulated, low-pass
filtered and blanked against impulse noise if necessary.
STEREO DECODER SECTION
5.4 FM MODE
5.4.1
The FM stereo decoder input stage provides a high-input impedance buffering. The input impedance is
opened during the RDS AF update phase by software or external pin control (programmable function) in
order not to discharge the coupling capacitor placed between the tuner output and the stereo decoder in-
put, and so speed up the return to normal listening.
The audio noise blanker circuit is fed from the stereo decoder buffer output: when the input impedance is
open during RDS AF update, the noise blanker is still able to work for a short period of time before the
capacitance associated with the buffer input stage is discharged.
During RDS AF update the output of the buffer is muted to avoid letting transient signals leak through the
audio processor section.
An additional input series switch has been added to perform the stereo decoder auto zero function (see
also Audio Processor section). This switch must be opened before selecting the tuner as the audio source
in order to allow the stereo decoder internal filters to discharge before the offset measurement is per-
formed.
The input buffer in FM mode is followed by an 80 kHz low-pass filter to remove high frequency noise.
INPUT STAGE
5.4.2
The buffered MPX signal is fed to a 19 kHz-centered band-pass filter and subsequently to a PLL used to
regenerate the 38 kHz carrier for stereo demodulation.
The PLL compares the pilot tone with the divided output frequency of an internal VCO running at 456 kHz,
locking its operating frequency and phase to that of the pilot tone. The PLL status can be stored during
the RDS AF update phase in order to speed up subsequent returning to normal listening conditions.
Since the VCO tuning range is small, the VCO needs being adjusted to a setting that ensures lock is
achieved when a pilot tone is present. On the current TDA7514 version it is necessary to perform this
alignment during the car-radio test phase, by injecting a 19 kHz tone into the stereo decoder and changing
the VCO programming until a lock condition is reached.
The presence of a stereo signal is detected in this block by measuring the peak value of the pilot tone and
comparing it with a programmable threshold. The resulting information can be read back via I
2
C bus (audio
processor/stereo decoder I
2
C read byte).
PLL
5.4.3
The MPX signal is fed to the stereo demodulator where the L and R outputs are derived. In case of a stereo
transmission in weak field or bad reception conditions (see FM tuner quality section) a gradual transition
STEREO DEMODULATOR AND BLEND
相關PDF資料 |
PDF描述 |
|---|---|
| TDA7528 | AM/FM car radio Front-End receiver for IF sampling tuners |
| TDA7575 | MULTIFUNCTION DUAL BRIDGE POWER AMPLIFIER WITH INTEGRATED DIGITAL DIAGNOSTICS |
| TDA8175 | TV VERTICAL DEFLECTION OUTPUT CIRCUIT |
| TDA8176 | TV VERTICAL DEFLECTION SYSTEM FOR TV AND MONITORS |
| TDA8177F | VERTICAL DEFLECTION BOOSTER |
相關代理商/技術參數 |
參數描述 |
|---|---|
| TDA7515 | 功能描述:音頻 DSP RF Front End RoHS:否 制造商:Texas Instruments 工作電源電壓: 電源電流: 工作溫度范圍: 安裝風格: 封裝 / 箱體: 封裝:Tube |
| TDA7515_06 | 制造商:STMICROELECTRONICS 制造商全稱:STMicroelectronics 功能描述:RF front-end for AM/FM-DSP car radios with IF sampling |
| TDA7515A | 制造商:STMicroelectronics 功能描述:TDA7515A - Trays |
| TDA7515ATR | 制造商:STMicroelectronics 功能描述:TDA7515ATR - Tape and Reel |
| TDA7515TR | 制造商:STMICROELECTRONICS 制造商全稱:STMicroelectronics 功能描述:RF front-end for AM/FM-DSP car radios with IF sampling |
發布緊急采購，3分鐘左右您將得到回復。