- 您現在的位置：買賣IC網 > PDF目錄372453 > TDA7514 (意法半導體) SINGLE-CHIP FM/AM TUNER WITH STEREO DECODER AND AUDIO PROCESSOR PDF資料下載
參數資料
| 型號： | TDA7514 |
| 廠商： | 意法半導體 |
| 英文描述： | SINGLE-CHIP FM/AM TUNER WITH STEREO DECODER AND AUDIO PROCESSOR |
| 中文描述： | 單芯片F(xiàn)M /調幅調諧立體聲解碼器和音頻處理器 |
| 文件頁數： | 66/74頁 |
| 文件大?。?/td> | 604K |
| 代理商： | TDA7514 |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁第30頁第31頁第32頁第33頁第34頁第35頁第36頁第37頁第38頁第39頁第40頁第41頁第42頁第43頁第44頁第45頁第46頁第47頁第48頁第49頁第50頁第51頁第52頁第53頁第54頁第55頁第56頁第57頁第58頁第59頁第60頁第61頁第62頁第63頁第64頁第65頁當前第66頁第67頁第68頁第69頁第70頁第71頁第72頁第73頁第74頁
TDA7514
66/74
5.2.2
An IF noise blanker circuit is present to detect and remove impulse noise especially at weak field strength
levels. The noise spikes are detected at the output of the first mixer and noise cancelling takes place in
the second mixer. The necessary delay in the signal path is provided by the IF1 ceramic filter.
The detection circuit consists of an expressly-built IF1 limiter and Smeter detector (not the same used for
FM Smeter generation), followed by a pulse detector. The sensitivity of the noise blanker is programmable.
The IF NB is desensitized at high field strength (using the filtered Smeter) and the desensitization thresh-
old can be programmed.
IF NOISE BLANKER
5.2.3
After channel selection by means of the IF2 ceramic filter, the AM signal is amplified by a very high gain
(up to 70 dB, programmable) linear amplifier, and demodulated by an integrated quasi-synchronous de-
tector. The phase information for the detector is derived from the IF2 limiter (shared with the FM signal
path) whose input is the IF2 amplifier input pin. The same IF2 limiter is used to generate the AM Smeter
information since it uses a narrow band signal and is not subjected to AGC.
The IF2 amplifier gain is controlled by the AGC2 loop.
The IF2 limiter output is also used to generate the input signal for the AM IF counter.
IF AMPLIFIER AND DETECTOR
5.2.4
The demodulated signal is buffered on the same output pin used for the FM MPX signal and is subjected
to the action of the soft mute circuit as well (programmable threshold/slope). The controlling signal for this
function is the filtered Smeter.
AUDIO OUTPUT
5.2.5
Station detection in AM is done evaluating the field strength and the IF2 signal frequency position.
The field strength detector (sensing the filtered Smeter) has a programmable threshold.
The programmability of the IF counter is the same as for the FM IF counter, albeit with different center
frequency, frequency window and sampling time programming.
The SD information or the single weak field strength information or IF counter result are available at the
SD pin.
The Smeter is available both in analog format (buffered at the SMETER pin) and in a 6 bit digital format
(tuner I
2
C bus read byte).
STATION DETECTION
5.3 TUNING SECTION
5.3.1
One VCO is used for both AM and FM tuning. To implement the world tuning concept (one VCO applica-
tion for all the geographical areas), the VCO runs at approximately 200 MHz. Digital dividers generate the
LO signals suitable for the AM and FM 1st mixers.
The VCO itself is a two-pin base-input collector-output bipolar amplifier.
A first divider by 1, 2 and 3 is present to generate the FM LO frequency and to be fed to the PLL. A second
divider by 4, 6, 8 and 10 is present to generate the AM LO frequency. For FM tuning it is possible to pro-
gram whether the mixer works in high- or in low-side injection mode. A 90a phase shift circuit operated on
the output of the first divider to generate the I and Q portions of the LO for the FM image rejection mixer.
VCO AND DIVIDERS
5.3.2
A 10.25 MHz crystal oscillator is used to generate the reference frequency of the tuning PLL and of the
switched capacitor circuits of the TDA7514. The oscillation frequency can be finely adjusted by program-
ming internal capacitors (5 bit).
XTAL OSCILLATOR
相關PDF資料 |
PDF描述 |
|---|---|
| TDA7528 | AM/FM car radio Front-End receiver for IF sampling tuners |
| TDA7575 | MULTIFUNCTION DUAL BRIDGE POWER AMPLIFIER WITH INTEGRATED DIGITAL DIAGNOSTICS |
| TDA8175 | TV VERTICAL DEFLECTION OUTPUT CIRCUIT |
| TDA8176 | TV VERTICAL DEFLECTION SYSTEM FOR TV AND MONITORS |
| TDA8177F | VERTICAL DEFLECTION BOOSTER |
相關代理商/技術參數 |
參數描述 |
|---|---|
| TDA7515 | 功能描述:音頻 DSP RF Front End RoHS:否 制造商:Texas Instruments 工作電源電壓: 電源電流: 工作溫度范圍: 安裝風格: 封裝 / 箱體: 封裝:Tube |
| TDA7515_06 | 制造商:STMICROELECTRONICS 制造商全稱:STMicroelectronics 功能描述:RF front-end for AM/FM-DSP car radios with IF sampling |
| TDA7515A | 制造商:STMicroelectronics 功能描述:TDA7515A - Trays |
| TDA7515ATR | 制造商:STMicroelectronics 功能描述:TDA7515ATR - Tape and Reel |
| TDA7515TR | 制造商:STMICROELECTRONICS 制造商全稱:STMicroelectronics 功能描述:RF front-end for AM/FM-DSP car radios with IF sampling |
發布緊急采購，3分鐘左右您將得到回復。